Sony CCMA-2DAR Mode d’emploi

4 5

1 2

2Operating Procedure

Microscope Connection Guide for the CCMA-2DAR Adapter

and the MCC-1000MD

Connecting to the Carl Zeiss Meditec LUMERA-700

Connection

Connect the controller by pushing

it in until it clicks; it is not

necessary to turn it.

Connect the camera cable to the camera head. *Align the cable slot with the top

of the camera head, and turn the cable ring to secure it.

Attach the camera head while

turning it.

Remove the head cap.Remove the side body adapter cap

while turning it.

Turn the black dial on the

microscope to tighten it.

Insert the adapter into the

microscope (gently with both

hands).

Remove the front lens adapter cap.Pull off the microscope cap.

Preparation

Insert two AA batteries into the

controller.

Print the chart for adjusting the

viewing angle position onto

A4-size paper. You will find the

chart attached to this guide.

Operating Procedure

MK20363V1OHB19MAY

123

For the controller cable, slide the joint and pull it

directly out to remove it.

For the camera cable, pull it out while turning the

ring of the joint.

For the camera head, turn the main unit to

remove/attach it (make sure to disconnect the

camera cable).

Advice on Cable Disconnection

Adjusting

the Viewing Angle Position

Connection setup is complete

(finished state).

If iris adjustment is required, turn

the dial to adjust the focus (F2.8 is

OK by default).

TIPS

If the remote control does not operate

because the battery has run out, you

can use the adapter’s FOCUS dial to

adjust the focus (For emergency

purposes only; be careful not to touch

the clean field.)

While viewing the chart displayed on the monitor,

adjust the focus by pushing (and holding) the

NEAR and FAR buttons on the controller.

Use the hexagonal wrench to adjust the up, down, left, and right positions so

that your chart appears in the center of the monitor.

While viewing the monitor, adjust

the rotation by using a hexagonal

wrench to loosen the screw

securing the camera adapter and

camera head, and then tighten the

screw with the hexagonal wrench

to secure them again.

While looking through the

microscope’s ocular lens, centrally

place your printout of the chart for

adjusting the viewing angle

position. The recommended

working distance is around 30 cm.

Focus wrong

Focus correct

Turn on the camera power and

display the chart on the monitor.

Microscope Connection Guide for the CCMA-2DAR Adapter

and the MCC-1000MD

Connecting to the Carl Zeiss Meditec LUMERA-700

Support call:

Email:

Autres manuels pour CCMA-2DAR

Ce manuel convient aux modèles suivants

Autres manuels Sony Adaptateur

Sony

Sony PCGA-BA1/A Feuille d'instructions

Sony

Sony BKM-FW50 Manuel utilisateur

Sony

Sony CMT-MX500I Manuel utilisateur

Sony

Sony PCWA-C800S Read This First Manuel utilisateur

Sony

Sony PEGA SA500 Manuel utilisateur

Sony

Sony AC-V615 Manuel utilisateur

Sony

Sony HWSBTA2W - Bluetooth Wireless Audio... Manuel utilisateur

Sony

Sony ADP-MAC Manuel utilisateur

Sony

Sony XA-120IP Manuel utilisateur

Sony

Sony AC-PW10AM Manuel utilisateur

Sony

Sony UNA-EN1 Manuel utilisateur

Sony

Sony AC V16 Manuel utilisateur

Sony

Sony MSAC-FD1B Manuel utilisateur

Sony

Sony SGPAC10V1 Manuel utilisateur

Sony

Sony NPA-D100K Manuel utilisateur

Sony

Sony ACV-Q800 Manuel utilisateur

Sony

Sony CCMA-2DAR Mode d’emploi

Sony

Sony BKM-301HD Manuel utilisateur

Sony

Sony AC-U501AD Manuel utilisateur

Sony

Sony AC-VF10 Manuel utilisateur

Sony

Sony IM750 Manuel utilisateur

Sony

Sony XA-120IP Manuel utilisateur

Sony

Sony CMA-D5 Manuel utilisateur

Sony

Sony BKM-FW11 Manuel utilisateur

Manuels Adaptateur populaires d'autres marques

PCB Piezotronics

PCB Piezotronics 090B274 Manuel utilisateur

Auvidea

Auvidea J20 Manuel du produit

Gossen MetraWatt

Gossen MetraWatt AT3-III E Manuel utilisateur

Akribis

Akribis ITF-21-BISS-MIT Manuel utilisateur

Tenda

Tenda W54U Manuel utilisateur

ROHO

ROHO AGILITY Manuel utilisateur

PROLiNK

PROLiNK WN2001 Manuel utilisateur

Hawking

Hawking HUF2 Manuel utilisateur

Airlink101

Airlink101 AWLC4030 Manuel utilisateur

NETGEAR

NETGEAR XAV101v1 - Powerline AV Ethernet Adapter Manuel utilisateur

Philips

Philips SWA4554S/10 Manuel utilisateur

JVC

JVC TS-C9D2B Manuel d'instructions

NETGEAR

NETGEAR A6100 Manuel utilisateur

D-Link

D-Link DWA-121 Manuel utilisateur

Philips

Philips SWA2037 Manuel utilisateur

Basalte

Basalte 0610-20 Manuel utilisateur

Yealink

Yealink EHS40 Manuel utilisateur

Balluff

Balluff BIC 1B0-IT1A7-Q40KFU-SM4A4A Manuel utilisateur