SONIQ QMS100 Manuel utilisateur

2221

12345678910 11 12 13 14 15

16 17 18 19 20

1. POWER/AL.RESET button

2. SLEEP button

3. DISP button

4. VOLUME JOG CONTROL/EQ

SET button

5. PLAY/BAND button ( )

6. STOP/MONO button ( )

7. LCD display

8. SNOOZE/BACKLIGHT button

9. FUNCTION button

10. BACKWARD/SCAN DN button ( )

11. FORWARD/SCAN UP button ( )

12. TUNING JOG CONTROL/REPEAT

/PROGRAM/RANDOM button

13. TRANSFER button

14. Al1 ON/OFF button

15. Al2 ON/OFF button

16. Speaker

17. LINE IN

18. SD/MMC CARD input

19. USB input

20. EARPHONE JACK

21. FM ANTENNA

22. BATTERY DOOR

23. POWER CORD

DANGEROUS VOLTAGE

Conductor dangerous voltage, that may be of sufficient magnitude

to constitute a risk of electric shock to persons is present within this

product's enclosure.

ATTENTION

The owner's manual contains important operating and maintenance

instructions, for you safety, it is necessary to refer to the manual.

WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE

THIS APPLIANCE TO DRIPPING OR SPLASHING.

Note: This unit will become warm used for a long period of time.

This is normal and does not indicate a problem with the unit.

This player includes micro-processors which may malfunction

as a result of external electrical interference or noise. If the

player is not working properly, disconnect the power source and

them reconnect it.

This safety and operating instruction should be retained for future

reference.

Avoid installing the unit in locations described below:

- Places exposed to direct sunlight or close to heat radiating

Appliances such as electric heaters.

On top of other stereo equipment that radiate too much heat.

- Places blocking ventilation or dusty places.

- Places subject to constant vibration.

Humid or moist places.

Make sure not to obstruct the ventilation openings.

Operate turning controls and switches as instructed in the manual.

Before turning on the power for the first time, make sure the

batteries is properly installed.

For safety reasons, do not remove any covers or attempt to gain access

to the inside of the product. Refer any servicing to qualified personnel.

Do not attempt to remove any screws, or open the casing of the unit;

there are no user serviceable parts inside, refer all servicing to qualified

service personnel.

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE

COVER(OR BACK),NO USER SERVICEABLE PARTS INSIDE,

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

Important Notes

1 :indicates whenRANDOM is selectedin USBor SD/MMCmode

2 :indicates when selectRandom in SD/MMCmode if USBand SD/MMC

devices areboth inserted

3 :indicates when playbackUSB

4 :indicates when playbackSD/MMC

5 :indicates whenthe timeis PM(12hour mode)

6 :show clock: hourdigit

7 :show clock: minutedigit

8 :indicates radiomemory/ programmode

9 :indicates USBor SD/MMCprogram mode

10 :indicates radiomemory/ programmode

11: indicateswhen sleepfunction isselected

12 :indicates whenalarm2 isset toradio mode

13 :illuminates whenalarm2 isset toUSB mode

14 :illuminates whenalarm2 ison

15 :illuminates whenalarm2 isset toweekend mode

16 :illuminates whenalarm2 isset toSD/MMC mode

17 :illuminates whenalarm2 isset tobuzzer mode

18 :illuminates whenalarm2 ison

19 :indicates whenalarm2 timeis PM(12 hourmode)

20 :indicates FMstereo mode(station isreceived instereo)

21 :indicates FMmono mode

22 :indicates whenselect repeatall in USB orSD/MMC mode

23 :indicates whenselect repeata albumin USBor SD/MMCmode

24 :indicates whenselect repeatone inUSB orSD/MMC mode

25 :indicates whenplayback MP3format song

26 :indicates whenplayback WMAformat song

27 :indicates whenalarm1 timeis PM(12 hourmode)

28 :illuminates whenalarm1 ison

29 : indicateswhen playback SD/MMC

30 :illuminates whenalarm1 isset tobuzzer mode

31 :illuminates whenalarm1 isset toSD/MMC mode

32 :illuminates whenalarm1 ison

33 :illuminates whenalarm1 isset toUSB mode

34 :indicates whenalarm1 isset toradio mode

35 :illuminates whenalarm1 isset toweekend onmode

POWER CORD CONNECTION

Before using, connect the AC Power plug to the AC socket, then turn

on the power switch of the unit.

OPERATING THE UNIT

When you plug the unit into the AC socket firstly, the unit will be in

standby mode, the LCD will show the time and day. In standby mode

press snooze/backlight key to turn the backlight on/off.

12345678910 11 12 13

22 21

MP3/WMA music file playback

- Press the [FUNC] key to select USB or SD/MMC mode. USB or

SD/MMC icon will be indicated individually.

- Press key to start music playback after read out the TOC. The

LCD will show the file format (Mp3 or WMA), album number, track

and playing time. Press the key again to pause playback and

the track will flash unti release pause function.

- Press key to stop music playback and the LCD will show total

album and tracks.

- Press key to up skip track select, press and hold the key to fast

forward search.

- Press key to down skip track select, press and hold the key to fast

backward search.

- Roll [Tuning bar/Program button] to select desired track.

- Press [Tuning bar/Repeat button] to select following

play mode during playback: (LCD will show in sequence as below)

Repeat 1 Repeat Album Repeat All Random

Remarks: In SD/MMC mode, the mix Random (USB+SD/MMC) will

be occurred if both device are inserted and the LCD will show (USB+

SD/MMC) icon.

- In stop mode, press [Tuning bar/Program button] to enter Program

mode (up to 32 tracks can be programmed),

press & or roll the [Tuning bar/Program button] to select track

and press the bar to confirm. When Program is complete,

press for program play.

- Remarks: Mix Programming can be selected if SD/MMC and USB

devices are both inserted. User can press [Func] key to select either USB

or SD/MMC mode during programming.

Music file transfer between SD/MMC and USB device

- Copy the current track

Press [TRANSFER] key while the track is played, and LCD will indicate as

the following sequence:

Copy completeCurrent Track

Track

X X X Start Copy

Alb

X X Confirm OK Table of Content

X X X

Track X X

Alb

When the unit have no power but the back up battery(AA X 2), the

system will keep running but LCD show nothing. You can press the

POWER button to switch the unit ON and OFF. Pull the AC plug out

of the AC socket if you want to switch off the unit completely.

12 58

Sun.

- In SD/MMC or USB mode, press [ ] key to achieve file transferTRANSFER

1st Program Track copy complete1st Program Track

Track

X X X 1st Program Track start Copy

Alb

X X

Next Program Track Confirm OK1st Program Track

X X X X X

Track Alb

1st Program Track Confirm OK

Next Program Track copy complete

Next Program Track start Copy

Flat Classic Rock Pop Jazz X-Bass

Radio Functions:

- Press [FUNC] key to select radio mode and the LCD will display the

band & frequency.

- Press key to select AM or FM.

- Press and hold key to have upward auto tuning.

- Press and hold key to have downward auto tuning.

- Roll [

- Press

Press & key to select desired

station. Press [ ] to confirm and exit program mode

- Press & to recall the preset station (Total preset station,

FM/20 and AM/10)

- Press key to switch to mono mode when the stereo reception

is not stable

Tuning bar/Program button] to select desired station.

[Tuning bar/Program button] to enter program mode.

Tuning bar/Program button

- When the targetdevice is full,the copy functionwill stop automaticallyand

the LCD will display device full .

- Press the key again, the weekend icon flash press key to

disable weekend sleeper function, press key to enable

weekend sleeper function.If weekend is enabled, the icon will be

indicated and the alarm will turn off during weekend automatically

( SAT and SUN ).

- When the radio icon flash, Press & key to select wake up

mode. For example : radio buzzer USB or SD/MMC.

- When radio is selected , the icon will be indicated . And the first station

that played is the station you last listened to. The volume level defaults

to level (20) when the alarm sound.

- When buzzer is selected, the icon will be indicated. The BB sound

can be heard when the alarm sound.The BB sound can not

controlled by volume controls.

- When USB or SD/MMC is selected, the icon will be indicated, the

location of day will appear 3 digit for track selection (maximum

599 tracks), press & key to select desired track .The

selected track will be playback and the volume defaults to level (20)

when the alarm sound.

(Note:1: When the selected track is out of USB/SD then it will playback

from the first track.

2: When you forget to insert the USB or SD/MMC, the USB or

SD/MMC wake up mode will change to Buzzer mode

automatically when the alarm arrives

3: When the unit is working, the USB or SD/MMC wake up mode

will change to Buzzer mode automatically when the alarm

time arrive.

- When alarm1 hour digit flash press & key for alarm1 hour

adjustment

- Press the key again, the minute digit flash, press & key for

alarm1 minute adjustment.

to change the day.

- Press [ ] again to complete clock and day

setting and it will exit to standby mode.

In standby mode, you are able to set the alarm too.

- Press and hold AL1 ON/OFF key to enter alarm1 setting mode

Tuning bar/Program button

- Copy all files of a device

Press [TRANSFER] key in stop mode, and LCD will indicate as the following

sequence:

Track

Table of Content

X X X Alb

X X

X X X

Table of Content

Track X X

Alb

1st Track start Copy 1st Track copy complete 1st Track Confirm OK Next Track start Copy

Next Track copy completeNext Track Confirm OK

Whole device copy complete

- Copy the track programmed

Press [TRANSFER] key in program play mode, and LCD will indicate as the

following sequence:

Clock and Alarm Functions :

Clock and Day setting :

- In standby mode, you are able to set the clock.

- Press the [ ] to enter clock setting mode

- When hour digit flash, press & key for hour adjustment

- Press the [ ] and minute digit flash, press

& key for minute adjustment.

- Press [ ] and day digit flash, press & key

Tuning bar/Program button

AUX Function :

Press [FUNC] key repeatedly to select AUX mode, LCD will show :AUX

ON, sound will come out if external audio device is plugged into the unit.

Volume and Equalizer Control

- Roll the [Volume bar/EQ set button] up and down to achieve higher or

lower volume level and the LCD will display the current volume level,

When the level decrease to 0, the LCD will show : VOL MIN. If the level

increase to 40 , the LCD will show : VOL MAX.

- Press the [Volume bar/EQ set button] repeatedly to select 6 preset EQ,

the LCD display EQs in sequence as below

Alarm2 settings arethe same asAlarm1, butthe

Sleep Function

During radio, USB,SD/MMC, Auxmode, press sleepkey to enable

sleep timer andthe LCD willshow the icon,Press and holdthe key

to select sleeptimer:

90 80 70 ......10 9 8......1

Setting check :

During radio, USB,SD/MMC, Auxmode, press [DISP]key repeatedly to

check the clock/day, AL1/AL2time , sleeptimer settings.

sound is different fromAlarm1 in orderto recognise them.

SPECIFICATIONS:

Unit Power Source: AC 240V ~ 50Hz

Receiving Bands: AM/FM

Radio Frequency Range: AM 522 ~ 1629Khz

FM 87.5 ~ 108 Mhz

Output Power: 1.5W (RMS) x 2

Dimensions: 260x150x98mm (WxHxD)

Alarm Enable and Disable

- Press the Al1 key to enable (with alarm icon is shown)

- Press the Al1 key to disable (without alarm icon is shown)

- When alarm is arrived:

(i) Press [SNOOZE] key to stop alarm temporarily, alarm will

turn on 9 minutes later.

(ii) Press [AL.Reset or FUNC] key to turn off the alarm.

Remarks :

If [SNOOZE] key or [AL.Reset or FUNC] key is not pressed,

the unit will turn off automatically after 60 minutes.

Ce manuel convient aux modèles suivants

Manuels Lecteur multimédia populaires d'autres marques

Visual Land

Visual Land Impulse Manuel utilisateur

limHD

limHD 200i Manuel utilisateur

Transcend

Transcend DMP10 Manuel utilisateur

Philips

Philips GoGear Muse SA2MUS08 Manuel utilisateur

Fantec

Fantec MM-HDRL Manuel utilisateur

Dune HD

Dune HD Duo 4K Manuel utilisateur

IAdea

IAdea HMP-505S Manuel utilisateur

Camos

Camos MMS-1000 Manuel utilisateur

Energy

Energy 75 Series Manuel utilisateur

Z3 Technology

Z3 Technology DME-03 Manuel utilisateur

Sony

Sony SVR-2000 Guide de l'utilisateur

Meicheng

Meicheng HD-1080K12 Manuel utilisateur

DENAFRIPS

DENAFRIPS ARCE Manuel utilisateur

Topaz

Topaz CMS Media Player Instructions d'utilisation

InFocus

InFocus LightCast Manuel utilisateur

IconBiT

IconBiT XDS1003D Manuel utilisateur

Quanmax

Quanmax QDSP-2090 Series Manuel utilisateur

Samsung

Samsung MP-80S Manuel utilisateur