7
Parallel Speaker Jacks – mono input jacks to plug the speaker(s) into. PLEASE NOTE: The jacks are in parallel,
so if you plug two equal impedance speaker loads into them, you must set the impedance switch to half their
impedance. For example, with two 16 ohm speaker loads plugged in, the impedance switch should be set to 8
ohms.
Impedance Selector Switch – switch to select the correct impedance of the speaker load hooked up to the amp.
Bias Probes – test jacks to check the bias values of the power tubes.*
Full/Half Power Switch – switch to change the power setting between half and full power. This feature changes
the operation of the power tubes between pentode (full) and triode (half.) The amount of power reduction in
wattage is approximate.**
Fuse Holders – receptacles for the amp’s fuses.
AC Jack – jack to plug the provided AC cord into.
9.
10.
11.
12.
13.
14.
9 11
12
10 1413
The bias pot is located on the top of the amp chassis
near the power tubes. Please only have the bias
adjusted by a qualified technician.
Please note, the power reduction in wattage does not
equate to a 50% reduction in overall loudness (dB.)
*
**
Rear Panel (continued)
2-Year Limited Warranty
This amplifier is protected with a limited, 2-year warranty for any and all defective issues with the build
workmanship and parts, excluding tubes, transformers and speakers. The warranty does not cover general wear
and tear, neglect, misuse or abuse, damage from liquids (water, alcohol, etc.), disasters, acts of God or unauthorized
modifications. Any modifications made to the amp by the owner or a technician will void the warranty. The owner
is responsible for all warranty shipping costs. Once the warranty work is completed, the customer will be notified
and sent a final shipping invoice. The owner then is required to pay the shipping invoice to have the repaired amp
shipped back to them. Returned warranty shipping will be insured and will require a signature.
