
Clean any contaminates from
the installation surface with the
alcohol wipe.
5
Fully dry the installation surface
with paper towels.
6
Remove the lining from both of
the adhesive pads.
7
Ensure the base of the GMC5 is
clean using the alcohol wipe and
then dry.
21
Remove any accumulation of ice
from the mounting surface
GMC5T
Sollatek (UK) Ltd. Sollatek House, Waterside Drive, Langley, Slough, SL3 6EZ, UK
MOUNTING THE GMC5
This instructions contains important safety instructions. Before using this product please read all instructions carefully.
Remove the retaining screws from the base of the GMC5
and remove the end cap.
1
2Disconnect the battery pack connector and remove the old
battery.
Battery Replacement
Note: the GMC5 needs to be removed (unstuck from the panel/ unclipped
from the mount) before battery replacement
Note: illustrations are for guide only of mounting orientation and placement but depends on available space within the freezer. For further details on GMC5 place-
ment, please refer to GMC5 Freezer Compatibilty Document
Batteries must be replaced with batteries of the same type.
The device cannot be disposed of as municipal waste therefore
such waste should be collected and disposed of separately in
accordance to EU directive 202/96/EC.
For best signal, avoid mounting the GMC5(T) near/behind metal surfaces and mount with the square end pointing towards/close to the
outside of the cabinet.
Isolate power if installing the GMC5 in areas where live electrical equipment are housed.
Avoid hot/moving parts when positioning.
3Insert and connect the new battery pack, replace the end
cap and secure in place with the retaining screw.
GMC5 PLACEMENT GMC5T PLACEMENT
Horizonal Freezers
Mount within the compressor
compartment as close to the grill
as possible
Vertical Freezers
Mount in either the top hat or
compressor compartment as close
to the grill / edge
Horizonal Freezers
Mount on the oor or on the
compressor step along any wall
depending on basket positioning.
Vertical Freezers
Mount along the side walls on
either the bottom or to of the
cabinet.
IMPORTANT: When choosing a mounting location, check the surface atness rst using the GMC5. If the surface has an extreme
curvature where the entire GMC5 base can not stick to the surface, consider an alternative surface.
Note: While preparing the surfaces, ensure the adhesive pad is kept at ambient temperature, hot or cold temperatures could
result in the adhesive losing adhesion.
Immediately press and hold the
GMC5 for 10 seconds to secure
it to the surface.
10
SEC
Peel off the liner on one side,
then stick them to the base at
either end.
4
Remove the back lining from the
adhesive pad and stick 2 pads
together (x2).
3
8
MBA 25/08/2022
GMC5(T) Installation Manual v6
A/I: 10910717