SolarEdge 330kW Manuel utilisateur

Version 1.0, December 2023

SolarEdge 330kW inverter internal fan for short bracket replacement - Support kit manual

1

SolarEdge 330kW inverter internal fan for short

bracket replacement – Support kit manual

This manual describes the procedure for replacing the SolarEdge 330kW Inverter Internal Fan

for Short Bracket.

Revision history

Version 1.0, December 2023 – Initial release

Kit contents

SolarEdge 330kW Inverter Internal Fan for Short Bracket PN FLD-3PH-OR-IN-01.

Required tools

Torque screwdriver

5mm hex bit

Flat screwdriver

Voltmeter

Before you begin

1. Set the P/1/0 switch to “0” (OFF).

2. Turn the DC ON/OFF Switch to the OFF position.

3. To lock the DC Switch, pull the white tab out away from the blue handle and insert a

padlock through one of the holes.

4. Lock the padlock.

Version 1.0, December 2023

SolarEdge 330kW inverter internal fan for short bracket replacement - Support kit manual

2

DC ON/OFF switch safety padlock

5. Disconnect AC power to the inverter by turning OFF the circuit breaker in the power

distribution panel.

6. Wait at least five minutes for the DC Voltage inside the inverter to drop to a safe level.

7. As an additional safety precaution, lock the power distribution panel.

Remove the cover

NOTE

The inverter cover assembly is too big for one person to handle safely. SolarEdge recommends that

two people remove and handle the cover assembly.

To remove the inverter cover, use a screwdriver with a 5mm hex bit to release the screws

holding the cover in place.

Inverter Cover Assembly

WARNING!

Before doing any maintenance work on the inverter, test for safe AC and DC voltages.

Version 1.0, December 2023

SolarEdge 330kW inverter internal fan for short bracket replacement - Support kit manual

3

Remove the damaged fan

1. Using a flat screwdriver, loosen the two screws holding the fan.

2. Pull the fan and bracket out of the inverter.

Remove the fan and bracket

3. Disconnect the fan’s power cable.

Install the replacement fan

1. Reconnect the fan’s power cable. Pull gently on the connector to make sure it is properly

connected.

2. Insert the fan into position.

Insert the fan

3. Ensure that the holes at the bottom of the bracket engage with the two guide pins.

NOTE

When installing the fan and bracket, the bracket must not touch the bus bar.

4. Using a flat screwdriver, tighten the fan assembly clamping screws to a torque of 2.4N·m

(21.2lbf·in).

Version 1.0, December 2023

SolarEdge 330kW inverter internal fan for short bracket replacement - Support kit manual

4

5. Place the cover assembly in position and, using a torque wrench with a 5mm hex bit,

tighten the screws to a torque of 3.9N·m (34.5lbf·in).

6. Tighten the screws in the following sequence:

Screw tightening sequence

Turn on the power

1. Unlock the power distribution panel and turn ON the AC circuit breaker/s.

1. Remove the padlock and turn the DC Switch ON.

2. Set the P/1/0 switch to “1” (ON).

Table des matières

Autres manuels SolarEdge Onduleur

SolarEdge

SolarEdge storedge Manuel utilisateur

SolarEdge

SolarEdge T568B Manuel utilisateur

SolarEdge

SolarEdge Inline Energy Meter Manuel utilisateur

SolarEdge

SolarEdge SE K Series Manuel utilisateur

SolarEdge

SolarEdge SE2500H Manuel utilisateur

SolarEdge

SolarEdge StorEdge SE5000-xxS0 series Manuel utilisateur

SolarEdge

SolarEdge SE5000H-US Manuel utilisateur

SolarEdge

SolarEdge StorEdge Interface SESTI-S4 Manuel utilisateur

SolarEdge

SolarEdge SE K-AU I Series Manuel utilisateur

SolarEdge

SolarEdge SE7600A-US Manuel utilisateur

SolarEdge

SolarEdge SE8000H-AU Manuel utilisateur

SolarEdge

SolarEdge SE3000H-US Manuel utilisateur

SolarEdge

SolarEdge SE K Series Manuel utilisateur

SolarEdge

SolarEdge SE3680H Manuel utilisateur

SolarEdge

SolarEdge Home Hub Inverter Three Phase Manuel utilisateur

SolarEdge

SolarEdge storedge Manuel utilisateur

SolarEdge

SolarEdge SE K Series Manuel utilisateur

SolarEdge

SolarEdge StorEdge Solution with Backup Manuel utilisateur

SolarEdge

SolarEdge SE K Series Manuel utilisateur

SolarEdge

SolarEdge SE3500 Manuel utilisateur

SolarEdge

SolarEdge SE3680H Manuel utilisateur

SolarEdge

SolarEdge storedge Manuel utilisateur

SolarEdge

SolarEdge BI-EU1P Manuel utilisateur

SolarEdge

SolarEdge storedge Manuel utilisateur

Manuels Onduleur populaires d'autres marques

Fourgroup

Fourgroup Easy Manuel utilisateur

Velleman

Velleman PI300M Manuel utilisateur

Sungrow

Sungrow SG350HX-US Manuel utilisateur

WilTec

WilTec 61897 Manuel utilisateur

SMA

SMA SUNNY BOY STORAGE 2.5 Manuel utilisateur

Simplicity

Simplicity LANDLORD 316 Manuel utilisateur

Santak

Santak SMAX 3000 Manuel utilisateur

ATON

ATON RA.Store-3 Manuel utilisateur

ZIEHL-ABEGG

ZIEHL-ABEGG FXET4AMQ Manuel utilisateur

Tektronix

Tektronix CFG250 Manuel utilisateur

Champion

Champion 200989 Manuel utilisateur

Vanner

Vanner 20-500 Series Manuel utilisateur

GE

GE GEP Manuel utilisateur

Astrel Group

Astrel Group Power Reducer Guide rapide

MULTIQUIP

MULTIQUIP GDP-5H Mode d’emploi

GoWISE

GoWISE PS1007 Manuel utilisateur

Promate

Promate PM13500D ES Manuel utilisateur

Mastervolt

Mastervolt WHISPER 3.5M3000 RPM Manuel utilisateur