Using IRxxx :
ÜConnect Work lead to working table or job. Keep welding holder away from work
connections.
ÜSwitch on mains from socket and from backside MCB.
ÜSelect and clamp desired welding electrode in holder and set welding current according
to rod size as mentioned on it’s cartoon.
ÜMake a trial weld, then modify current setting if needed.
ÜMachine is ready for production work.
Using IRTxxx :
ÜFor arc welding, move toggle switch towards MMA on front panel of machine and do
the same procedure as written above for IRxxx.
Ü
For Tig Welding do following steps.
ÜConnect Work lead from +ve terminal to working table or job.
ÜConnect Tig torch at -ve terminal and connect gas pipe at gas nipple and connect torch
plug.
ÜPlace a sharp grinded tungsten electrode in torch head and tight 2-4 mm outside of
ceramic nozzle.
ÜConnect shielding gas(argon) at gas inlet nipple, backside of machine.
ÜSwitch on mains from socket and from backside MCB.
ÜPush Gas Check Button from front panel and adjust the gas flow from gas regulator
and flow-meter according to working conditions. Preferably between 2 to 6 liter per
minute
ÜProgram Gas Pre-flow time:
1. Set TIG/MMA switch back to MMA.
2. Rotate post-flow knob in MMA position. Screen show Pre-flow sec., Set the
desired value, if not sure set it to minimum (0.1 sec.). After a second screen
shows pre flow saving. when saving message changed to Welding Current. Set
TIG/MMA seitch to TIG mode.
3. Every time when Pre-flow will done. Don’t forget to set Post Flow Time.
ÜSet Post-Flow time between 2 to 5 sec. If want to use machine at full current set it to 5
second.
ÜSet welding current according to job.
ÜMake a trial weld, then modify current setting if needed.
ÜMachine is ready for production work.
6
