9. Locate the 5 Bolts in the header hardware bag, 5 small
washers, and 5 larger washers, or the hardware used to
mount the hard top.
10.Stack the washers as shown.
11. Using a 7/16” wrench, mount the center bracket on the
header bar to the center hole on the top center of the
vehicle cab into the hole that the hard top was bolted
to. Center the bolts in the slots for now and fasten
securely.
12.Bend the header bar downward to bolt in the
remaining brackets ensuring that the radius of the bend
places the header bar in the center of the weather
stripping on the vehicle.
13.Each end of the header bar will
eventually bolt to the bedrails, so
let the ends hang loosely or out of
shape until bedrails are installed.
The two remaining screws, nuts,
and washers will be used for this.
14. Locate the 110” strip of bulb
seal. Peel off the red paper as you
stick the bulb seal to the upper rear
portion of the header bar as shown
on page 6.!
