Snom C520 WiMi Manuel utilisateur
C520
SIP Conference
Quick Installa on Guide
0
1
6
MNO
9
WXYZ
3
DEF
#
5
JKL
8
TUV
2
ABC
4
GHI
7
PQRS
a » A
2
Quick Installation Guide
C520
SIP Conference
Table of Contents
Copyright, Trademarks, Legal
Disclaimers 3
Parts checklist 4
Status Indicators Overview 5
Status indicators on the base unit ������ 5
Status indicators on the wireless
microphones��������������������������������������� 6
Connect the base unit 7
Install the wireless microphone
battery 9
Register the wireless microphones
10
Deregister the wireless
microphones 11
Register a cordless headset 12
Deregister a cordless headset 13
Register a wireless speakerphone 14
Manually register the C52-SP to the
C520������������������������������������������������� 14
Deregister a wireless speakerphone
15
Technical Specications 16
California Energy Commission
(CEC) battery charging testing
instructions 17
Important Battery Information 18
Charging and Discharging, Storage � 18
Disposal of the device and batteries 19
Cleaning ������������������������������������������� 19
Important safety instructions 19
Battery ���������������������������������������������� 21
Precautions for users of implanted
cardiac pacemakers ������������������������� 21
About wireless mics�������������������������� 21
For C-UL compliance only 22
Mesures de sécurité importantes 22
Compliance 26
FCC part 15�������������������������������������� 26
Industry Canada ������������������������������� 27
3
Copyright, Trademarks, Legal Disclaimers
Copyright © 2022 Snom Technology GmbH� All Rights Reserved�
Snom, the names of Snom products, and Snom logos are trademarks owned by
Snom Technology GmbH�
All product specications are subject to change without notication. Snom
Technology GmbH� reserves the right to revise and change this document at any
time,
without being obliged to announce such revisions or changes beforehand or after
the fact�
Although due care has been taken in the compilation and presentation of the
information in this document, the data upon which it is based may have changed
in the meantime� Snom therefore disclaims all warranties and liability for the
accurateness, completeness, and currentness of the information published,
except in the case of intention or gross negligence on the part of Snom or
where liability arises due to binding legal provisions�
Important Information
Please read the instructions on safety and disposal and on how to set up and
use the device before using it and also give them to other users to read or inform
those users of their contents� Save this manual and do not give the device to
third parties without it�
4
Parts checklist
Your product package contains the following items� Save your sales receipt and
original packaging in the event warranty service is necessary�
0
1
6
MNO
9WXYZ
3
DEF
#
5
JKL
8TUV
2
ABC
4
GHI
7PQRS
a » A
Conference Phone
Wireless
Mic x2
Wireless Mic
battery x2
Wireless Mic
battery door x2
Quick
Installaon
Guide
C520
Power
Adapter
AC Power Cord
DC Power Cable
(with yellow plugs)
Ethernet Cable
2
1
5
Status Indicators Overview
Status indicators on the base unit
0
1
6
MNO
9
WXYZ
3DEF
#
5
JKL
8
TUV
2
ABC
4
GHI
7
PQRS
a » A
23
1
LED ①
Power Up • Green for about two seconds�
On a call • Steady Green during a call�
• Flashes Green slowly when a call is on hold�
• Steady Red when a call is muted�
Incoming Call • Flashes Green quickly when there is an incoming call�
LED ②()and LED ③()
Bluetooth device connected • Steady
Incoming call on Bluetooth device • Flashing
Held call on Bluetooth device • Slow ashing
Base unit is in discoverable mode • Flashing alternately /
6
Status indicators on the wireless microphones
On the cradle • Steady Orange when charging in the cradle except during
registration
• Flashes Red and Green alternately when the non-
registered wireless microphone is charging on the cradle�
O the cradle • Steady Green during a call
• Steady Red when the system is muted during a call�
• O when the wireless microphone is in idle mode or
without a battery�
• Flashes Orange when the wireless microphone’s battery
is low�
• Flashes Green when there is an incoming call�
• Flashes Red slowly when the wireless microphone is:
• out of range; or
• not registered; or
• o cradle during paging (with a paging tone).
During
registration
• Flashes Red and Green alternately�
7
Connect the base unit
The C520 can be powered by AC power or Power over Ethernet (PoE—Class 0).
To power the base unit with PoE:
1� Plug one end of the Ethernet cable into the Ethernet port on the bottom of the
unit�
2� Plug the other end of the cable into your network router or switch�
When the base unit is powered up, the status indicators turn green for about
two seconds�
NOTE: You can connect the C520 to both PoE and AC power� Ensure that
you connect the cables in the order described in “To power the C520
using AC power:” on page 8� Once connected, the unit will use
PoE� If PoE fails, the unit will use AC power as a backup�
8
To power the C520 using AC power:
1� Plug one end of the DC power cable into the power jack of the base unit, and
plug the other end into the C520 jack of the power adapter. Route the cord
through the slots�
2� Plug one end of the Ethernet cable into the LAN jack of the power adapter,
and plug the other end into a network switch or router�
3� Plug the small end of the AC power cord into the power jack of the adapter,
and plug the large end into a wall outlet not controlled by a switch�
NOTE:
• Use only the power adapter provided with the product� To order a
replacement power adapter, visit our website at www.snomamericas.com�
• The supplied power adapter is designed for use with only the C520 SIP
Conference Phone� It is not designed to power other network devices� Do not
connect the supplied power adapter to any other network devices through the
supplied DC power cable or any other Cat5e ethernet cable�
• The C520 SIP Conference Phone requires a network connection to an IP
PBX to operate� This quick installation guide assumes that your network
infrastructure is established and that your IP PBX phone service has been
ordered and congured for your location.
• The AC power cord is intended for a vertical or oor mount position. The
prongs are not designed to hold the plug in place if it is plugged into a ceiling
or cabinet outlet�
9
Install the wireless microphone battery
• Risk of explosion! Batteries should not be exposed to
excessive heat such as bright sunlight or re.
• Use only the supplied battery�
1� Plug the battery connector securely into the socket inside the battery
compartment. Insert the battery (with the label THIS SIDE UP facing up) into
the battery compartment�
2� Slide the battery door until it clicks into place�
3� Place the wireless mics into the charging cradles until they are ush.
NOTE: Charge the battery for 8 hours before use� The status indicator on
the wireless microphone turns orange when charging, and turns o when the
wireless microphone is fully charged�
3
AC power cord
12
LAN
VCS752
Wall outlet
Network switch
or router
DC power cable
(with yellow plugs) Ethernet cable
Slots
To Adapter
Adapter
Network switch
or router
Ethernet cable
Slots
Battery X2
10
Register the wireless microphones
Your wireless microphones are preregistered� You can register up to two wireless
microphones to the base unit�
Before you register any new wireless microphones, you must rst deregister the
wireless microphones from the base unit�
During registration, incoming calls will not have any audio after being answered�
Audio connection will resume when registration is complete�
To register the wireless microphones:
1� Press �
2� On the Main Menu, press qto select 3. User Settings, and then press �
3� On the User Settings menu, press qto select 4. Wireless microphone, and
then press �
4� On the Wireless Microphone menu, with 1. Register selected, press
The screen displays “Registering���”
• If registration is successful, the screen displays “Registration
succeeded.” The base unit plays a conrmation tone. The registered
microphone LED stops ashing red and green.
• If registration fails, the screen displays “Registration failed�” Remove the
unregistered microphone from the charging cradle and put it back in�
Repeat step 4 to try the registration process again�
5� To register the second wireless microphone, repeat step 4�
NOTE: All wireless microphones should always be kept on the charging cradles
during the registration process� Any wireless microphone that was deregistered,
but not put into the charging cradle will remain deregistered after the above
operations�
Status indicators on the wireless microphones ash red and green alternately
during registration�
To cancel registration, press �
Autres manuels pour C520 WiMi
3
Table des matières
Autres manuels Snom Système de conférence
Manuels Système de conférence populaires d'autres marques
Kramer
Kramer VIA GO Manuel utilisateur
AVT
AVT MAGIC AC1 Go Manuel utilisateur
ProSoft Technology
ProSoft Technology AN-X4-AB-DHRIO Manuel utilisateur
Sony
Sony PCS-I150 Manuel utilisateur
Middle Atlantic Products
Middle Atlantic Products VTC Series Manuel utilisateur
Prentke Romich Company
Prentke Romich Company Vanguard Plus Mode d’emploi
