2
THE DALI-RD20-M MUST BE INSTALLED BY A LICENSED ELECTRICIAN
IMPORTANT INFORMATION
ELECTRICIANS MUST READ PRIOR TO INSTALLATION
•This product must only be installed by persons who are appropriately licensed by the applicable State
regulatory body.
•This product must be connected to circuits that incorporate 10 A rated circuit breaker protection.
•Hazardous voltage exists at the terminals of this product. Ensure the circuit is isolated before removing
this product from the wall or electrical enclosure.
•Damage caused by incorrect installation, force-majeure, electrical surges, lightning, power grid
fluctuations, water or by connection to alternative power supply sources (such as solar inverters, etc.) is
not eligible for warranty repair.
Device Overview
The DALI P20 is a DALI broadcast controller for control of up to 20 DALI fittings. Its integral DALI power supply
means no other hardware is required for this controller to operate.
With an input for a movement detector and programmable options for Turn on Level, Sensor mode, Run on Timer
and Minimum Level the DALI P20 is not only simple to install and use but also extremely flexible in its
functionality.
Installation Instructions
Before installing this product read all instructions carefully and please keep this installation manual for future
reference.
WARNING: To prevent electric shock, please ensure that power is isolated before installation.
This product is designed for indoor use only.
The DALI-RD20-M is designed to be mounted in the ceiling (typically near the first fitting) with the supplied cable
run down to the switch plate mounted rotary encoder. Suitable switch plate is provided by the installer.
Installation must be carried out by a qualified electrician in accordance with National Wiring Regulations and
other applicable regulations. Compliance to Low Voltage Directives may be invalidated if not used or installed
according to the published specification.
The DALI-RD20-M contains no user serviceable parts and should be returned to the manufacturer for repair.
Rotary Encoder
The encoder is an ELV device and connected with an ELV cable. The installer must adhere to Australian electrical
standards when installing this device near LV cables and devices.
