(1) see Supplementary user manuals for remote control (EB) and
SNM/EB-2 programming guide
Table 8. Technical specifications of the MC 11 AC EB-2
10. EU Declaration of Conformity
The EU Declaration of Conformity for this product is
available at www.siqura.com/support-files.
Accessories:
MC 11 EB-2 AC: - power cord
- mounting kit
- 4-pin Combicon connector
11. Safety and EMC information
The equipment described in this manual has been designed and
tested according to the IEC 60950-1 safety requirements. It is an
IEC safety class 1 product; the ground wire in the line cord must
be connected when operating.
The equipment has been tested and found to meet the EG-
regulations relating to EMC, and complies with the limits for a
Class B device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against interference
to radio communications in any installation. The equipment does
use radio frequencyenergy; improper useor special circumstances
may cause interference to other equipment or a performance
decrease due to interference radiated by other equipment. In such
a case, the user will have to take appropriate measures to reduce
such interactions between this and other equipment.
The equipment described in this manual is designed for use by
properly trained personnel. This means that adjustment,
maintenance and repair of the equipment should only be carried
out by qualified personnel aware of the hazards involved. For
correct and safe use of the equipment and in order to keep the
equipment in a safe condition, it is essential that both operating
and servicing personnel follow standard safety procedures in
addition to the safety precautions and warnings specified in this
manual.
If there is any doubt regarding the safety of the equipment, do
not put it into operation.
This might be the case when the equipment shows physical
damage or is stressed beyond its tolerable limits (e.g. during
storage and transportation).
Before opening the equipment, disconnect it from all power
sources. After disconnection from its power sources, the
capacitors in the equipment may remain charged for some
(typically 2-3) minutes.
When removing covers or other parts of the equipment, live parts
or terminals may be exposed. If the opened, live equipment needs
calibration, maintenance or repair, only trained personnel, who
are aware of the risks, may perform this.
Any interruption of the ground wire inside or outside the
equipment, or disconnection of the protective earth terminal,
couldmake the equipment dangerous.
Before any connections are made, the equipment must be
connected to safety ground.
Electrostatic discharge (ESD) can damage or destroy electronic
components. Proper precautions should be taken against ESD
when opening the equipment.
Figure 5. Power loading of the power supply cabinet
11 slots loaded with 9W modules: Max. ambient 65°C
11 slots loaded with 6W modules: Max. ambient 74°C
12. Product disposal
Recycling
This product contains valuable materials which
qualify for recycling. In the interest of protecting
the natural environment, properly recycling the
product at the end of its service life is imperative.
