1. Carefully open the AccuForce main box.
2. Remove the component boxes
3. Carefully open the component boxes.
4. Verify that no shipping damage has occurred. Contact SimXperience immediately if you observe
shipping damage! Shipping damage claims must be made within 48 hours of receipt.
5. Locate the main enclosure base
IMPORTANT SAFETY WARNINGS
WARNING: The AccuForce wheel is NOT a toy and can produce similar steering forces to that of a real
race car. Race car steering forces are significantly greater than those of a typical passenger car. Use
extreme caution, accidental death or dismemberment is possible while using this simulation device.
WARNING: The motor will calibrate when all cables have been connected. Do NOT connect all cables
until the AccuForce Base Unit is securely mounted
WARNING: Expect unexpected movements of the wheel at any time! Due to the nature of force
feedback and game provided telemetry, SimXperience is often times responding to instructions
provided by 3rd parties and cannot guarantee the accuracy or safety of these instructions.
Mounting & Controller Placement
1. IMPORTANT - Place the controller box within 6ft of where your wheel will be mounted and as
far away from the PC and other electrical wiring / cabling as possible.
2. Securely mount the wheel to your simulator using the M6 screws included in the bottom of the
AccuForce Pro Base Unit
WARNING: Ensure that your mounting can withstand up to 16Nm of rotational force.
Connecting Steering Wheel Assembly to The Base Unit
1. Locate the AccuForce Steering Wheel / Button Box Assembly
2. Connect the steering wheel / button box assembly to the AccuForce base unit via the standard
race car quick release system. Rotate the steering wheel until the quick release halves align and
lock into place.
3. Ensure a secure connection of the quick release before proceeding.
Connecting Wheel Base Unit To Controller
4. Locate the cable exiting the back of the AccuForce enclosure.
5. Route this cable as far away from other cables as possible.
6. Avoid routing this cable near devices that may cause electromagnetic interference.
7. Connect the two plugs on this cable to the controller box, connecting the smaller plug first.
8. Ensure that the plugs are firmly connected and that the clasp locks on the larger plug.
Connecting Controller To PC
1. Locate the included USB cables.
2. Connect two USB cables between the controller box and the PC.
