Silverline SCV 1160-50 RF HERMOD Manuel utilisateur
Assembly instructions
SCV 1160-50 RF HERMOD
SCV 1160-50 HV HERMOD
SCV 1160-70 RF HERMOD
SCV 1160-70 HV HERMOD
Read this manual carefully before installation / commissioning
1, en_US
MANUFACTURER
Merzifon OSB AMASYA, Silverline
IMPORT
Jilmas Group Nordic ApS Eli Christensens Vej 90, 7430 Ikast Denmark
Telephone: +45 70104014
Fax: +45 70131389
Internet: www.silverline.dk
24.07.20202
Table of contents
1 Product overview................................................................ 4
2 Technical drawing............................................................... 5
3 WARNINGS AND SAFETY PRECAUTIONS....................... 7
4 DANGER TO LIFE & RISK OF POISONING....................... 9
5 CLEANING AND MAINTENANCE..................................... 11
6 The content of the package............................................. 13
7 Assembly / Installation of the product............................ 14
7.1 Height (recommended)............................................... 14
8 Installation of hood........................................................... 15
8.1 Connection of central ventilation................................. 15
9 Klemens Bağlantısı........................................................... 16
10 Adjustment of air flow...................................................... 17
11 How to operate the product............................................. 23
12 Hints................................................................................... 26
13 Replacement of GU10 light source................................. 27
14 Service, fault symptoms and solutions.......................... 28
14.1 Technical table.......................................................... 29
Table of contents
24.07.2020 3
1 Product overview
1- Control Panel
2- Filter
3- Mounting plate
4- Lighting
1
2
3
4
Fig. 1
Product overview
24.07.20204
2 Technical drawing
500
500
81
121
460
114
100
Fig. 2
Technical drawing
24.07.2020 5
500
700
81
121
660
114
100
Fig. 3
Technical drawing
24.07.20206
3 WARNINGS AND SAFETY PRECAUTIONS
nThis product may only be used by children and persons without
physical, sensory or mental deficiencies or no experience and
knowledge when supervised or instructed in safe use. The
product is intended for household use.
nThe voltage of the product is 220-240 Volts ~ 50 Hz.
nThe hood is mounted with a cable with a ground wire. This
cable must be connected to a grounded electrical outlet.
nAll electrical connections must be made by an electrician.
nUnauthorized installation may result in poor performance,
product damage or accidents. The product cable must not be
pinched or broken during installation. Do not run down near the
stove. This may cause melting and fire.
nDo not connect the product until installation is complete.
nMake sure that the socket is easily accessible, in order to dis-
connect the product, in case of an emergency.
nDo not touch the product's light bulbs if they have been on for a
long time. The light bulbs can get very hot.
nCooker hoods are designed for use in the home for conven-
tional cooking. If the hood is used for other purposes, the right
of complaint may lapse.
nFollow rules and laws issued by authorities on exhaust air
emissions.
nFood that can be ignited (open flame) during cooking must not
be prepared under this product. Start the product after placing
pans, pots, etc. on the stove. Otherwise, high heat may cause
deformation of certain parts of the product.
nTurn off the hobs before removing the cookware from there.
nDo not leave hot oil on the stove. Pans with hot oil can ignite
spontaneously and catch fire. Oil can ignite during frying, etc.
Be careful with curtains, rugs and the like. Be sure to clean and
replace filters on time. Filters that are not cleaned or replaced
in time pose a fire hazard due to accumulated grease in them.
nUse only the oral metal grease filters in the hood.
nDo not operate the product without a grease filter. Do not
remove filters while the product is in use. In case of fire; dis-
connect the hood and the cooker. (Disconnect the product or
turn off the main power switch). The product may pose a fire
hazard if it is not cleaned regularly.
nDisconnect the unit before maintenance work. (Disconnect the
product or turn off the main power switch). Under pressure in
the room, while hoods and equipment operating on sources
other than electricity used simultaneously, must not exceed 4
Pa (4 x 10 bar).
nIf there are units used with fuel or gas, such as heating prod-
ucts in the area where the product is used, the flue from these
units must be completely insulated or the unit must be airtight.
nChildren must not play with the product.
nUse "MAX 13 A" fuse for the product for your safety.
nKeep packaging materials away from children as they may be
dangerous to them.
nAll materials used for packaging the product are suitable for
recycling.
WARNINGS AND SAFETY PRECAU-
TIONS
WARNINGS AND SAFETY PRECAUTIONS
24.07.2020 7
nFollow the instructions on the product box during transport.
nHold the handles on the side of the box to carry the product.
If you need to transport the item again:
nKeep the original box. Carry and ship the product in the original
box and condition. If the supply cable is damaged, it must be
replaced by the manufacturer or its service department or other
personnel with equivalent qualifications to avoid dangerous sit-
uations. In the event of a fire, disconnect the cooker hood and
stove and cover the flames. Never use water for extinguishing.
nAvailable parts may be hot when the cooker is switched on.
nMake sure that the cooker hood has the correct height above
the hob, read the recommended height in the manual. Ask if
necessary. fire authority in your municipality about local laws
and regulations for this
nThe hood's exhaust must not be connected to exhaust ducts
that include other smoke products.
nCare must be taken when using the cooker hood at the same
time with units that use air and fuel (eg heating products, water
heaters operating on gas, diesel, coal or wood). This is
because it can reduce combustion as the hood emits air from
the room.
nThe room must have adequate ventilation when the stove,
cooker hood and units operating on gas and other fuels are
used at the same time Different materials require different rawl
plugs and screws. Use rawl plugs and screws that fit the mate-
rial the hood is to be mounted in.
WARNINGS AND SAFETY PRECAUTIONS
24.07.20208
4 DANGER TO LIFE & RISK OF POISONING
DANGER!
Risk of poisoning due to combustion gases. Unless
adequate air supply is ensured, the unit must not
be used at the same time as appliances that emit
toxic gases, such as stoves, burners, water
heaters, etc., that operate on circulating air gas,
fuel, wood, or coal.
Air circulation devices (eg stoves, burners, water heaters operating
on gas, oil, wood or coal) take the combustion air and send the
exhaust gases through a chimney or similar. A cooker hood with a
strong effect will risk being able to reverse this air flow and thus
draw the exhaust gases through the home and out through the
cooker hood's exhaust duct. This poses a risk of poisoning to per-
sons staying near this airflow (Fig. 4).
Therefore, adequate intake of fresh air should always be ensured.
DANGER!
Fire Hazard!
If the device is not cleaned in accordance with the
cleaning instructions, it may cause a fire as grease
may accumulate in the hood which may be flam-
mable.
DANGER!
Risk of electric shock!
Due to damaged connection cable. Avoid breaking
or pressing the connecting cable during installa-
tion.
DANGER!
Risk of injury!
– There is a risk of damage during installation
due to sharp edges. For safety reasons, use
work gloves when fitting the hood.
– All screws and bolts must be fitted as
described in the operating instructions, as oth-
erwise there may be a risk that the hood is not
fastened sufficiently and thus may fall down.
Fig. 4: Risk of poisoning
Fig. 5: Proper ventilation
DANGER TO LIFE & RISK OF POISONING
24.07.2020 9
DANGER!
Risk of burns & danger of electric shock!
– Wait until the unit has cooled down before
cleaning or maintenance. Disconnect the fuse
or disconnect the device from the mains.
– There is a risk of damage due to seepage of
moisture into electronic parts. Never clean the
control panel with a damp cloth but with a
damp cloth.
– Surface may be damaged due to improper
cleaning. Clean stainless steel surfaces only in
the direction of brushing. Do not use stainless
steel cleaners for the control panel.
– Surface can be damaged by sharp or scrub-
bing cleaners. Never use sharp or scrubbing
cleaners.
Disconnect the fuse or disconnect the device from the wall socket
in the event of a fault or damage to the product. Repairs should
always be performed by an authorized or approved specialist.
In the event of a fault or damage to the device, dis-
connect the fuse or disconnect the device from the
wall outlet and call for authorized service.
If the supply cable is damaged, it must be replaced
by the manufacturer or its service department or
other personnel with equivalent qualifications to
avoid dangerous situations.
When light bulbs in the unit are damaged, remove
the fuse or disconnect the unit from the mains. To
avoid overloading the other bulbs, replace the
defective one immediately (wait until the bulb has
cooled down).
CAUTION!
When the product is used over stoves, accessible
parts may become hot.
DANGER!
Exhaust fumes from the hood must never be con-
nected to the chimney from the stove or other
exhaust ducts used to expel potentially toxic or hot
gases / gases.
DANGER TO LIFE & RISK OF POISONING
24.07.202010
Ce manuel convient aux modèles suivants
3
Autres manuels Silverline Contrôleurs
