TM
Silent
Alert
TM
Silent
Alert
OFF
A
B
5
4
3
2
1
Event Keys
Belt clip
Configuration keys
Charging Socket
OFF
A
B
5
4
3
2
1
1.
Move the ON/OFF switch
to the on position (to the
right, away from off).
The pager will illuminate
each key then vibrate.
The pager is now ready
to use.
2. Install the alarm clock or trickle charger
(Part no's. CH3A-2205-IN ,
TR3A-2206-EU), insert the Pager into the
charging slot and charge for 24 hours.
The battery key on the Pager will light
green briefly upon docking confirming the
Pager is docked correctly.
If a pillow pad is fitted it will vibrate 3
times when the Pager is docked.
3. Install the Silent Alert
monitor units according
to their instructions.
4. To re-set the Pager and stop
the vibration, press and hold
the key that is lit.
Each signal will automatically
cancel after 20-40 seconds.
Smoke & CO signals will run
for 15 minutes to comply with
British standards
Silent Alert
TM
Fire Safe
Compatible
Silent
AlertTM
5. The battery key will flash
green every 45 seconds to
indicate the Pager is
switched on.
The Pager must be recharged each night
and if not in use for more than 24 hours
should be switched off.
6.
If the Pager becomes flat it
will vibrate and the battery
key will light up.
The battery key will flash
orange until the Pager
is recharged.
If the low battery sequence
alternates with another event
key, that monitor has a
low battery.
Silent Alert
TM
Fire Safe
Compatible
Silent
AlertTM
7.
We recommend a full 24 hour charge before using our equipment.
In an emergency a few hours charge may be sufficient for short time use but this is not advised.
Silent Alert
TM
Fire Safe
Compatible
Silent
AlertTM
WARNING! Your device and its accessories are not toys. They may contain small parts. Keep them out of the reach of small children.
Silent Alert
TM
Fire Safe
Compatible
Silent
AlertTM
12:14
SNZ
PM
Z Z
