SIIG NN-E38012-S2 Manuel utilisateur

Introducing the FireWire 800 3-port PCIe

The FireWire 800 3-port PCIe is designed to add FireWire

800(1394b)and1394a(6-pin)interfacestoyourcomputer.

Features and Benefits

• Provides 2 FireWire 800 (1394b) ports and 1 1394a

(6-pin) port for multiple 1394b/1394a device

connections

• Supports data transfer rates of 100, 200, 400 and

800Mbps

• Built-in4-pinpowerconnectorprovidesextrapower

when connected to the system's power supply

(Recommended)

• Supportshot-swappingand Plug-n-Play connection

of peripheral devices

• Works with various types of FireWire 800 (1394b)

and 1394a devices including portable hard disk, DV

camcorder, digital camera, CD-RW/DVD-ROM

drive and other audio/video devices

FireWire 800 3-port PCIe

Quick Installation Guide

04-0400A

System Requirements

• PCI Express-enabled system with an available PCI

Express slot

• Windows 2000/XP/Server 2003

PackageContents

•FireWire 800 3-port PCIe board

• "Y" split power cable

• Driver CD

• This quick installation guide

Board Layout

FireWire Port

(1394a)

FireWire 800

Ports

4 Pin Power

Connector

Figure 1: Board Layout

Hardware Installation

General instructions for installing the card are provided

below. Since the design of computer cases and

motherboards vary, refer to your computer’s reference

manual for further information, if needed.

Static Electricity Discharge may permanently damage

your system. Discharge any static electricity build up in

your body by touching your computer’s case for a few

seconds. Avoid any contact with internal parts and

handle cards only by their external edges.

1. Turn OFF the power to your computer and any

other connected peripheral devices. Unplug the

computer's power cord.

2. Remove your computer’s cover and install the card

in an available PCIe slot.

3. Push the board down firmly, but gently, until it is

well seated.

4. Connect an available 4-pin power connector from

the system power supply to the 4-pin power

connector on the FireWire 800 3-port PCIe board (See

Figure 1 onpage2). Thisconnectionis recommended

for reliable power output. The included "Y" power

cable can be used to give you additional 4-pin

power connectors.

5. Secure the card and replace the cover.

Driver Installation

This section provides information on how to install the

FireWire 800 3-port PCIe drivers. Please follow the

directions below for your operating system.

Important: If your system doesn't boot to Windows

properly with our card installed, check with your

system'smanufacturer forthelatestsystemfirmware

update. Our board comes with a PCI Express

bridge chip, which may not be understood by your

system. At the time this manual was written, many

system and motherboard vendors already have had

this fix posted on their respective web sites.

Windows 2000

Windows 2000 automatically installs it's built-in 1394a

driver for the FireWire 800 3-port PCIe. To get the full

speed out of this controller, install the Firewire 800 driver

using the directions below.

1. Right click My Computer, click Manage, then click

Device Manager.

2. Double click IEEE 1394 Bus host controller, then

double click Texas Instruments OHCI Compliant

IEEE 1394 Host Controller.

3. Click the Driver tab, then Update driver button.

4. At the Upgrade Device Driver Wizard, click Next.

5. Select Search for a suitable driver for my device,

then click Next.

6. Insert the driver CD, check CD-ROM drives, then

click Next.

7. Click Next, then click Finish.

8. Restart Windows to complete the installation.

Windows XP/Server 2003

Windows XP and Server 2003 automatically installs it's

built-in 1394a driver for the FireWire 800 3-port PCIe . To

get the full speed out of this controller,install the Firewire

800 driver using the directions on the next page.

1. Right click My Computer, click Manage, then click

Device Manager.

2. Double click IEEE 1394 Bus host controller, the

double click Texas Instruments OHCI Compliant

IEEE 1394 Host Controller.

3. Click the Driver tab, then Update Driver button.

4. Select Install from a list or specific location, then

click Next.

5. Select Don't search. I will choose the driver to

install, then click Next.

6. Insert the driver CD, click Have disk.

7. Type in D:, then click OK. (Change D: to match your

CD-ROM drive letter)

8. Select OHCI IEEE 1394b Host Controller, then click

Next.

9. Click Continue Anyway. Our driver has been

thoroughly tested in Windows for stability.

10. Click Finish. Restart Windows to complete the

installation.

Verify Proper Installation in Windows

1. Check Device Manager to verify successful

installation.

Windows 2000/XP/Server 2003: Right click My

Computer, then click Manage. Click Device

Manager.

2. Double click 1394 Bus Controller or IEEE 1394 Bus

host controllers.

- An OHCI IEEE 1394b Host Controller should be

displayed.

Technical Support and Warranty

QUESTIONS? SIIG’s Online Support has answers!

Simply visit our website at www.siig.com and click on Support.

Our online support database is updated daily with new drivers

and solutions. Answers to your questions could be just a few clicks

away. You can also submit questions online and one of our technical

support analysts will promptly respond.

A lifetime manufacturer warranty supplied with this product is

offered by SIIG, Inc. Please see SIIG website for more warranty

details. If you should happen to encounter any problems with this

product, please follow the procedures below.

If it is within the store's return policy period, please return the

product to the store where you purchased from.

If your purchase has passed the store's return policy period, please

follow these steps to have the product repaired or replaced.

Step 1: Submit your RMA request.

Go to www.siig.com, click Support, then RMA to submit a

request to SIIG RMA. If the product is determined to be

defective, an RMA number will be issued. SIIG RMA department

can also be reached at (510)413-5333.

Step 2: After obtaining an RMA number, ship the product.

•Properly pack the product for shipping. All software, cable(s)

and any other accessories that came with the original package

must be included.

•Clearly write your RMA number on the top of the returned

package. SIIG will refuse to accept any shipping package, and

will not be responsible for a product returned without an

RMA number posted on the outside of the shipping carton.

•You are responsible for the cost of shipping the product to SIIG

at the following address:

SIIG, Inc.

6078 Stewart Avenue

Fremont, CA 94538

RMA #:

•SIIG will ship the repaired or replaced product via Ground

in the U.S and International Economy outside of the U.S at

no cost to the customer.

About SIIG, Inc.

Foundedin1985,SIIG,Inc.isaleadingcomputerupgrademanufacturer

of I/O connectivity products, including PCI & ISA serial and parallel

ports, USB, Serial ATA & UltraATA controllers, FireWire (1394a/b),

Networking,SoundCards, and other accessories. SIIG is the premier

one-stop source of upgrades.

SIIGproducts offercomprehensiveuser manuals,manyuser-friendly

features, and are backed by an extensive manufacturer warranty.

High-quality control standards are evident by the overall ease of

installation and compatibility of our products, as well as one of the

lowest defective return rates in the industry. SIIG products can be

foundincomputer retail stores, mail order catalogs, and e-commerce

sitesintheAmericas andthe UK,as wellas throughmajor distributors,

system integrators, and VARs.

PRODUCT NAME

FireWire 800 3-port PCIe

FCC RULES: TESTED TO COMPLY WITH FCC PART 15, CLASS

B OPERATING ENVIRONMENT: FOR HOME OR OFFICE USE

FCC COMPLIANCE STATEMENT:

This device complies with part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not cause

harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

THE PARTY RESPONSIBLE FOR PRODUCT COMPLIANCE

SIIG, Inc.

6078 Stewart Ave.

Fremont, CA 94538-3152

FireWire 800 3-port PCIe is a trademark of SIIG, Inc.

SIIG and SIIG logo are registered trademarks of SIIG, Inc. Microsoft and Windows are

registeredtrademarksofMicrosoftCorporation. PentiumisaregisteredtrademarkofIntelCorporation.

Other names used in publication are for identification only and may be trademarks

oftheirrespective companies.

Table des matières

Autres manuels SIIG Carte PCI

SIIG

SIIG CyberPro 1S1P Manuel utilisateur

SIIG

SIIG SC-SA1012-S1 Manuel utilisateur

SIIG

SIIG LB-US0314-S1 Manuel utilisateur

SIIG

SIIG LB-US0614-S1 Manuel utilisateur

SIIG

SIIG NN2630 Manuel utilisateur

SIIG

SIIG SoundWave 128 PCI Manuel utilisateur

SIIG

SIIG SIIG 2S1P Combo-Value Manuel utilisateur

SIIG

SIIG SC-SAEE22-S1 Manuel utilisateur

SIIG

SIIG Hi-Speed USB 5-Port PCI Manuel utilisateur

SIIG

SIIG SC-SA2012-S1 Manuel utilisateur

SIIG

SIIG JU-EC2012-S1 Manuel utilisateur

SIIG

SIIG JU-P40112-S1 Manuel utilisateur

SIIG

SIIG CyberPro PCI 1S Manuel utilisateur

SIIG

SIIG 1394 PCI Adapter Manuel utilisateur

SIIG

SIIG JJ-P00112-S6 Manuel utilisateur

SIIG

SIIG SoundWave 7.1 PCI Manuel utilisateur

SIIG

SIIG Universal PCI Serial Cards Manuel utilisateur

SIIG

SIIG DP 4-Port USB 3.0 PCIe i/e Manuel utilisateur

SIIG

SIIG SC-SA4M12 Manuel utilisateur

SIIG

SIIG NN-E20112-S2 Manuel utilisateur

SIIG

SIIG 1394 PCI Adapter Manuel utilisateur

SIIG

SIIG CyberPro PCI 4S Manuel utilisateur

SIIG

SIIG Cyber 1S1P PCI Manuel utilisateur

SIIG

SIIG DP SuperSpeed USB 3.0 2-Port PCIe i/e Manuel utilisateur

Manuels Carte PCI populaires d'autres marques

ERMA

ERMA SSI 1417 Manuel utilisateur

Moxa Technologies

Moxa Technologies CP-102E Manuel utilisateur

I-Bus

I-Bus IBC2602 Manuel utilisateur

Exsys

Exsys EX-60102 Manuel utilisateur

Chelsio Communications

Chelsio Communications T5 Series Manuel utilisateur

Conrad Electronic

Conrad Electronic 97 46 71 Manuel utilisateur

Micro Innovations

Micro Innovations USB650A Manuel utilisateur

KTI Networks

KTI Networks KF-310 Manuel utilisateur

Asus

Asus SpaceLink WL230 Manuel utilisateur

TRENDnet

TRENDnet TEW-703PI Manuel utilisateur

Belkin

Belkin F5D7000F Manuel utilisateur

Pericom

Pericom PI7C7100 Manuel utilisateur

ADLINK Technology

ADLINK Technology cPCI-3548 Manuel utilisateur

Digium

Digium TE200 Series Manuel utilisateur

Allo.com

Allo.com 2nd Gen E1/T1/J1 Manuel utilisateur

Western Digital

Western Digital FireWire PCI Adapter Manuel utilisateur

Pyle

Pyle Gamelink PLINK1 Manuel utilisateur

Alpha Networks

Alpha Networks WMP-A13V Manuel utilisateur