Sigma Spectrum Manuel utilisateur

Only Trained Healthcare Professionals are

Authorized to use the Sigma Spectrum Pump

sigma spectrum

Quick Reference Guide

Starting a New Infusion

Press POWER ON KEY wait for power-up to complete.

1.Gravity prime the IV, removing all air from Y sites

and backcheck valve. Position and close the roller

clamp on the IV set comfortably below the pump.

2.Insert the slide clamp into the keyhole on top of the

pump at .

3.Push down on the slide clamp until the door opens.

4.Load the tubing into the tubing guides as illustrated.

Starting at the top with the slide clamp at

proceeding in order through guides &

ensuring the fluid flow is directed from the IV

container to the patient.

5.Close the door by pressing with both thumbs at top

and bottom of door over latches.

6.The IV set is properly loaded when the screen

displays three green bars and check marks as

illustrated in Fig. 1, on page 2.

Set Loading

2 3 4

OFF

14 MFGID

sigma, LLC

711 Park Avenue

Medina, NY 14103

[email protected]

www.sigmapumps.com

Troubleshooting/Operating Tips

Soft keys

ŸAlarms - Follow all prompts on screen to clear alarms. Silence will be the

right soft key. Press SILENCE soft key or any key to silence the alarm for 2

minutes.

ŸStart with a fresh section of tubing loaded in the pump, make sure there is

enough tubing for patient movement.

ŸCorrect loading is confirmed by drops falling in drip chamber after pressing

RUN. Confirm flow from IV container, to drip chamber, to patient.

ŸAlways press OK to confirm entries and changes.

ŸKeep the power cord plugged in whenever the pump is not in use.

ŸOptions – Allows operator adjustment of alarm and display settings.

ŸTitrate – Press the TITRATE soft key to change the flow rate and VTBI

(volume to be infused) without stopping the pump.

ŸReview – Displays infusion information.

ŸReview/Program – Return to primary setup screen.

ŸHold – Infusion is in stand-by (No alarm ) until any key is pressed.

P/N 95520-605 REV A

From IV

Container

From IV

Container

To PatientTo Patient

Call 1-800-356-3454

24-7 Technical Support

Call 1-800-356-3454

24-7 Technical Support

7.To open the slide clamp, hold the tubing

down at the keyhole while pulling the slide

clamp up and out as in Fig. 2. Open the

roller clamp and confirm no flow.

When the pump is turned on and programmed

infusion data exists in memory, a screen

displays asking the operator if the intended

use for the pump is for a New Patient.

ŸAnswering YES to this prompt clears the

existing infusion data.

ŸAnswering NO retains the data and allows

the operator to resume the infusion.

Using the soft arrow keys, scroll to the desired

care area and press OK.

1.Type the drug’s first two letters (similar to

phone texting). A list of all matching drugs

will automatically be shown.

2.Using the soft arrow keys, scroll to the

desired drug and press OK.

IMPORTANT: If a drug is not available in the

Master Drug Library, follow your facility’s

procedure to request a drug library update.

New Patient Prompt

Select Your Care Area

Select a Drug

For drugs NOT in drug library

Basic Infusions

(Set Loading Continued) (Basic Infusion Continued)

1.Select the Care Area.

2.Enter “B” “A” and scroll to the BASIC selection.

3.Using the soft arrow keys select Primary or Secondary Bag and

press OK.

4.Select a dose mode and press OK (default is mL/hr).

5.Type in the required values, press OK after each entry.

6.Press RUN/STOP to start the infusion.

7. Check flow to confirm clamps are open, no tubing kinks and drops

are falling.

1.Program a Primary Infusion.

2.Lower the Primary Bag at least 20” below the Secondary Bag.

3.Stop the pump if running, press REVIEW/PROGRAM soft key.

4.Press PROGRAM SECONDARY soft key.

5.Type the drug’s first two letters.

6.Press OK to select/confirm secondary bag.

7.Follow all setup steps.

8.Press RUN/STOP to begin Secondary infusion.

9.Check flow for drops falling in the secondary not the primary drip

chamber and press YES/NO soft key to confirm.

1.Close the roller clamp on the set below the pump

2.To unload set, insert the slide clamp in keyhole at to open the

door and clamp the tubing.

3.Remove the tubing by pulling out from the bottom towards the top.

Secondary Infusions

Set Unloading

LOAD SET

Figure 1

Figure 2

Autres manuels Sigma Équipement de laboratoire

Sigma

Sigma 1-14K Manuel utilisateur

Sigma

Sigma Sigma 3-16KL Manuel utilisateur

Sigma

Sigma 2-16P Manuel utilisateur

Sigma

Sigma 3-18KS Manuel utilisateur

Sigma

Sigma 1-15PK Manuel utilisateur

Sigma

Sigma 1-14 Manuel utilisateur

Sigma

Sigma 2-7 Manuel utilisateur

Sigma

Sigma 4-16KS Manuel utilisateur

Sigma

Sigma 8KS Manuel utilisateur

Sigma

Sigma 2-16KHL Manuel utilisateur

Sigma

Sigma 3-16P Manuel utilisateur

Sigma

Sigma 1-14K Manuel utilisateur

Sigma

Sigma 2-7 Manuel utilisateur

Sigma

Sigma 8K Manuel utilisateur

Sigma

Sigma 2-16PK Manuel utilisateur

Sigma

Sigma 10164 Manuel utilisateur

Sigma

Sigma 3-30K Manuel utilisateur

Sigma

Sigma 4-5KL Manuel utilisateur

Sigma

Sigma SPRIZZA SPZ 40 Fiche technique

Sigma

Sigma 4-5L Manuel utilisateur

Sigma

Sigma 6-16KHS Manuel utilisateur

Sigma

Sigma 6-16KS Manuel utilisateur

Sigma

Sigma 8KBS Manuel utilisateur

Sigma

Sigma 3-16L Manuel utilisateur

Manuels Équipement de laboratoire populaires d'autres marques

Qiagen

Qiagen DML 3000 Manuel utilisateur

Queensgate

Queensgate NANOSCAN OP400 Manuel de programmation

Conviron

Conviron GEN1000-GE Manuel utilisateur

Parr Instrument

Parr Instrument 4560 Mode d’emploi

IKA

IKA IC control Manuel utilisateur

Integra

Integra DOSE IT Manuel utilisateur

Agilent Technologies

Agilent Technologies 5800 ICP-OES Manuel utilisateur

Endress+Hauser

Endress+Hauser Cleanfit CPA875 Manuel utilisateur

NI PXI-5422 Manuel

Collomix

Collomix Aqix Manuel utilisateur

SPEX SamplePrep

SPEX SamplePrep 6875 Freezer/Mill Series Manuel utilisateur

Ocean Insight

Ocean Insight FLAME-NIR+ Manuel utilisateur

Parker

Parker ALIGN-MG-NA Manuel utilisateur

BD 644787 Manuel utilisateur

DENTAURUM

DENTAURUM Compact Megaplus Manuel utilisateur

Biuged Laboratory Instruments

Biuged Laboratory Instruments BGD 626 Manuel utilisateur

VWR

VWR SAS Super IAQ Manuel utilisateur

illumina

illumina MiSeqDx Manuel utilisateur

Sigma spectrum Manuel utilisateur

Manuels Équipement de laboratoire populaires d'autres marques