Siemens E10 Manuel de l'opérateur
Information and Communication
Communication Devices
E10 / S6 Power GSM /S8 GSM
Level .5
Repair Documentation
V 1.2
V1.2 Page 1 of 22 ICP CD ST
D. Schnoor
06/98
Information and Communication
Communication Devices
Table of Contents:
1INTRODUCTION................................................................................................................................................. 2
2VCXO
................................................................................................................................................................................... 3
3FUSE 1A
................................................................................................................................................................................... 8
4FUSE 0.25 A
................................................................................................................................................................................. 12
5MOLEX CONNECTOR
................................................................................................................................................................................. 16
6RINGER
................................................................................................................................................................................. 20
1Introduction
V1.2 Page of 22 ICP CD ST
D. Schnoor
06/98
Information and Communication
Communication Devices
This manual is inten e to help you carry out repairs on level 2.5, meaning limite
component repairs. Failure highlights are ocumente an shoul be repaire in the local
workshops.
The E10 an the S6 Power GSM are both han sets for GSM-900. Internally they are almost
i entical but the form factors of the boar s are ifferent.
Note: In some countries the S6 Power GSM is calle S6 Classic!
It must be note that all repairs have to be carrie out in an environment set up accor ing to
the ESD (Electrostatic Discharge Sensitive Devices) regulations efine in international
stan ar s.
If you have any questions regar ing the repair proce ures or spare parts o not hesitate to
contact our technical support team in Kamp-Lintfort, Germany:
Tel.: +49 2842 95 4666
Fax: +49 2842 95 4302
VCXO
.1Affected Units
.1.1Type: E10 / S6 Power GSM
V1.2 Page 3 of 22 ICP CD ST
D. Schnoor
06/98
Information and Communication
Communication Devices
.1. Affected IMEIs / Date Codes: All / All
.1.3Affected SW-Versions: All
.1.4Fault Code for LSO reporting: 3VCX
. Fault Description
. .1Fault Symptoms for customers:
Network Search
Han set not logging into network
. . Fault Symptom on GSM-Tester:
Frequency error in synchronize mo e >90 Hz
No location up ate possible
The VCXO (Voltage Controlle Crystal Oscillator) is responsible for generating the
13 MHz reference frequency of the han set.
If it is efective, the han set cannot synchronize to the base station anymore.
.3Priority:
........ Man atory
........ Repair
........ Optional
........ Not Yet Define
.4Repair Documentation
.4.1Description of procedure:
.4.1.1Diagnosis
Check the output frequency of the VCXO using the level-2 testing
program for E10 / S6 Power GSM.
Switch off the „CMD in Use“ option in the S611.INI file an restart
V1.2 Page 4 of 22 ICP CD ST
D. Schnoor
06/98
Information and Communication
Communication Devices
the program. Start the test, when the program says „Check power an
phase of external antenna with your GSM-Tester“, switch the CMD to
„LOCAL“ mo e an enter the „MODULE TEST“.
On the CMD isplay you can see the frequency error of the han set.
(Make sure that the CMD is on channel 124, power level 5!)
If the frequency error is higher than 2kHz, the VCXO has to be
replace .
.4.1. Repair by component change
Use hot air blower to remove efective VCXO.
Avoi excessive heat!
Watch surroun ing components!
Resol er new VCXO afterwar s.
.4.1.3Repair by SW-Booting
Not possible!
.4.1.4Test
Retest han set after repair as escribe above.
The frequency error must now be < 2kHz.
.4. List of needed material
.4. .1Components
VCXO
Part-Number: L36145-G300-Y19
.4. . Jigs and Tools
Hot Air Blower
V1.2 Page 5 of 22 ICP CD ST
D. Schnoor
06/98
Information and Communication
Communication Devices
Sol ering Iron
.4. .3Special Tools
None
.4. .4Working materials
Desol er Wick / Brai
Sol er
V1.2 Page 6 of 22 ICP CD ST
D. Schnoor
06/98
Information and Communication
Communication Devices
.4.3Drawings
V1.2 Page 7 of 22 ICP CD ST
D. Schnoor
06/98
Figure 1: E10 / S6 Power GSM Board VCXO Side
Information and Communication
Communication Devices
3Fuse 1A
3.1Affected Units
3.1.1Type: E10 / S6 Power GSM
3.1. Affected IMEIs / Date Codes: All / All
3.1.3Affected SW-Versions: All
3.1.4Fault Code for LSO reporting: 3FU1
3. Fault Description
3. .1Fault Symptoms for customers:
Battery charging not possible
V1.2 Page 8 of 22 ICP CD ST
D. Schnoor
06/98
Figure : VCXO (Z601) Placement (Top View)
Information and Communication
Communication Devices
3. . Fault Symptom on GSM-Tester:
This fault cannot be etecte with a GSM-Tester
3.3Priority:
........ Man atory
........ Repair
........ Optional
........ Not Yet Define
3.4Repair Documentation
3.4.1Description of procedure:
3.4.1.1Diagnosis
Check the status of the fuse by measuring its resistance with
a multimeter. The fuse is efective if the resistance higher than 10
ohms.
3.4.1. Repair by component change
Use sol ering iron to remove efective fuse.
Avoi excessive heat!
Watch surroun ing components!
Resol er new fuse afterwar s.
3.4.1.3Repair by SW-Booting
Not possible!
V1.2 Page 9 of 22 ICP CD ST
D. Schnoor
06/98
Information and Communication
Communication Devices
3.4.1.4Test
Retest han set after repair as escribe above.
The resistance must now be close to zero.
3.4. List of needed material
3.4. .1Components
Fuse
Part-Number: L36145-A820-Y7
3.4. . Jigs and Tools
Sol ering Iron
3.4. .3Special Tools
Multimeter
3.4. .4Working materials
Desol er Wick / Brai
Sol er
V1.2 Page 10 of 22 ICP CD ST
D. Schnoor
06/98
Ce manuel convient aux modèles suivants
2
Table des matières
Autres manuels Siemens Téléphone portable
Siemens
Siemens S25 Manuel utilisateur
Siemens
Siemens Gigaset S2 HiPath 4000 Manuel utilisateur
Siemens
Siemens SL10 Manuel utilisateur
Siemens
Siemens A51 Manuel utilisateur
Siemens
Siemens SX66 Manuel utilisateur
Siemens
Siemens S40 Manuel utilisateur
Siemens
Siemens HiPath 3000 V3.0 or later Gigaset M1... Manuel utilisateur
Siemens
Siemens MDACT Manuel utilisateur
Siemens
Siemens SFG75 Manuel utilisateur
Siemens
Siemens C66 Manuel utilisateur
Siemens
Siemens S46 Manuel utilisateur
Siemens
Siemens M30 Manuel utilisateur
Siemens
Siemens S6 GSM Manuel utilisateur
Siemens
Siemens M65 Manuel utilisateur
Siemens
Siemens CX75 Manuel utilisateur
Siemens
Siemens MC60 Manuel utilisateur
Siemens
Siemens SL45 Manuel utilisateur
Siemens
Siemens Gigaset SL75 WLAN Manuel utilisateur
Siemens
Siemens CX70 Manuel utilisateur
Siemens
Siemens S75 Manuel utilisateur
