Sielox AC-1500 Series Manuel utilisateur

Sielox AC-1500 Controllers Series

Installation Manual

Released July 2007.

Published by:

Sielox, LLC. 170 East Ninth Avenue

Runnemede, NJ 08078

Rev.: DRAFT

AC-1500 Installation Manual

Introduction ............................................................................................3

Certifications ...........................................................................................3

FCC - Federal Communications Commission Notice..................................................... 3

UL 294 ........................................................................................................................ 3

Technical Support & RMA’s ......................................................................3

Controller Features..................................................................................4

Installing Sielox Enclosures.....................................................................5

Installing Tamper Switch............................................................................................ 6

Mounting Plate (P/N 7372565)................................................................................... 7

Retrofit Plate Kit (P/N 7202975)................................................................................ 8

Installation of AC-1500L Backplanes BP4, BP5 or BP7.............................9

Connectors and Fuses Assignment............................................................................ 10

AC-1500 Controller Modules ..................................................................12

Installing Cables into the Sielox Enclosure ............................................13

Signal Cables .........................................................................................13

Communications ....................................................................................15

Main Controller ......................................................................................................... 15

LANLink™.................................................................................................................. 16

X-LAN ....................................................................................................................... 17

Installing LAN Module............................................................................................... 18

Connecting the Ethernet Cable.................................................................................. 19

Installing RS-485 Module.......................................................................................... 20

Connecting the RS-485 Cables .................................................................................. 21

Installing the Reader Module (AC-1500-REK)........................................22

Transient Suppressor (Door Locks and Outputs) ...................................................... 24

Supervised Inputs..................................................................................................... 24

REK Connectors ........................................................................................................ 26

Setting the Terminal Controller Address ................................................................... 27

Status LED CPU Board (Bottom board of the REK) .................................................... 27

Status LED Reader Board (Top board of REK) ........................................................... 28

Jumpers CPU Board (Top board of REK).................................................................... 28

Jumpers Reader Board (Bottom board of REK) ......................................................... 28

RAM and Real Time Clock Backup Battery................................................................. 29

Power Cables .........................................................................................30

AC Power Surge Suppressor...................................................................................... 30

Installing the Power Regulator Module AC-1500-PRDual.......................31

Connecting the 12 Volts Battery ............................................................................... 32

Monitoring AC Fail..................................................................................................... 33

Page 2 of 33

AC-1500 Installation Manual

Introduction

The AC-1500 Series are Sielox access control and event management controllers. They can

be used in a variety of applications such as access control, parking lot, elevator control,

time and attendance and others. They are modular and scalable allowing from 2 doors to 8

doors on the same backplane and from 4 to 244 I/O using the I/O backplanes or Reader

I/O backplane that combines 2 readers and 32 I/O.

Certifications

FCC - Federal Communications Commission Notice

This equipment complies with Part 15 of the FCC rules; operation is subject to the following two

conditions:

This device may not cause harmful interference, and

This device must accept any interference received, including interference that may cause

undesired operation.

Operation of this equipment in a residential area may cause unacceptable interference to radio

and TV reception requiring the operator to take whatever steps are necessary to correct the

interference.

WARNING: Changes or modifications to Sielox’s EAC equipment not expressly approved by the

party responsible for assuring compliance could void the user’s authority to operate the

equipment in a safe or otherwise regulatory compliant manner. If equipment is not installed and

used in accordance with the instructions in the User Manual, it may cause interference; in which

case, the user at their own expense must take whatever measures are required to correct

interference.

“This Class A digital apparatus complies with Canadian ICES-003.”

«Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.»

UL 294

This controller does not have this approval yet.

Technical Support & RMA’s

Phone: 800-424-2126, prompt 8

FAX: 856-939-9306

8:30 am – 7:30 pm Eastern time, Monday - Friday

E-Mail:[email protected]

Page 3 of 33

AC-1500 Installation Manual

Controller Features

The Sielox AC-1500 Controller Series is an access control and event management controller, It is

(PR-DUAL) that keeps the unit running in the event of a power failure.

Each controller has the following features:

•2 doors, 2 Request to Exit, 2 Door Contacts and Door Locks.

•50.000 Card holder database

•10.000 Off-line events

•4 General purpose Inputs (Supervised or Unsupervised)

•4 General purpose Outputs

•Real Time Clock (RTC)

•Lithium Battery Backup keeps the card holder database, off-line events and RTC running in

case of power loss.

•Status Lights (Lithium Battery, Communications and power)

The AC-1500 comes in two sizes AC-1500L or AC-1500S.

The AC-1500L has 3 backplanes configurations:

•AC-1500-BP4L a 2-8 door configuration with expansion to up 4 BP7 I/O Backplanes.

•AC-1500-BP5 RIO a 2 door and I/O.

•AC-1500-BP7 I/O backplane.

Page 4 of 33

AC-1500 Installation Manual

Installing Sielox Enclosures

Sielox provides 2 types of enclosures:

•Large Enclosure p/n 7969269 for large backplanes

•Small Enclosure p/n 7106307 for small backplanes

To install the Sielox enclosures, perform the following procedure:

1. Position the enclosure or template at the desired installation location and mark the four

keyhole slot locations for mounting.

2. Install the applicable mounting fasteners such as wood screws, moly bolts, or masonry

fasteners, but do not tighten them completely.

3. Position the enclosure on the four fasteners and tighten them completely.

4. Install the conduit, if not already completed.

5. Install a grounding lug to the Enclosure; ensure that the lug is terminated to an earth

ground.

6. Clean any debris from the enclosure.

Large Enclosure p/n 7969269

Small Enclosure p/n 7106307

Page 5 of 33

AC-1500 Installation Manual

Installing Tamper Switch

There is a Tamper Switch mounting channel available in the upper right hand corner of the

large enclosure p/n 7969269 or in the lower right hand corner of the small enclosure p/n

7106307. The switch provided by Sielox will be installed in this mounting channel.

The Tamper Switch must be connected to an Input of an installed controller. This input

shall be configured as normally closed with supervision. Two supervisory resistors

(5.1KOhm) shall be inserted in the wiring from the switch to the terminal controller, one

across the contact of the switch, the other in the Signal data line to the controller. When

configured and connected in this way, the controller will properly report an Input Active

event when the enclosure door is open and Input Secure when the door is closed.

An Input Cut or Input Shorted status will be reported if the switch or supervision resistors

are not properly assembled and connected.

Please refer to the following drawing for wiring of the Tamper Switch:

Input

Return

5k Ohm EOL Resistor

Tam

er Switch

The AC-1500 Series has large and small backplanes and they are:

Large Backplanes

AC-1500-BP4L 8 readers

AC-1500-BP5 RIO 2 readers and 4 I/O Modules (32 I/O)

AC-1500-BP7 I/O 7 I/O modules (56 I/O)

Small Backplanes

AC-1500-BP2 4 readers

AC-1500-BP4S 2 readers and 4 I/O Modules (32 I/O)

Page 6 of 33

AC-1500 Installation Manual

Mounting Plate (P/N 7372565)

The AC-1200-MAP mounting plate can be used where an AC-1500 is not being installed in

the AC-1200-ENC-32 Enclosure.

Not evaluated by UL (The AC-1200-MAP has not been evaluated by UL and is not UL294

compliant. Use the AC-1200-ENCL for UL294 compliance.)

Page 7 of 33

AC-1500 Installation Manual

Page 8 of 33

Retrofit Plate Kit (P/N 7202975)

AC-1200-RFK (Retrofit Plate Kit).

Not evaluated by UL (The AC-1200-RFK has not been evaluated by UL and is not UL294

compliant. Use the AC-1200-ENCS for UL294 compliance.)

AC-1500 Installation Manual

Installation of AC-1500L Backplanes BP4, BP5 or BP7

In order to mount the AC-1500 series of backplanes into the enclosure or mounting plate,

12 SEMS screws #6-32 x 5/16 must be used. The enclosure and the mounting plate have

threaded studs for the utilization of these screws. The AC-1500 series backplanes have

circular cutouts that allow these screws to be utilized, thereby securing the printed circuit

board into the enclosure.

The AC-1500 series of backplanes, when purchased, are shipped with all hardware

necessary for mounting the backplane to the enclosure.

Mountin

Holes

Mountin

Holes

AC-1500L BP4 Mounting Holes

Page 9 of 33

AC-1500 Installation Manual

Connectors and Fuses Assignment

Connectors Description

J200/J201 AC-1500-CPU (CPU 1 slot)

J300/J301 AC-1500-CPU (CPU 2 slot)

J302/J303 AC-1500-CPU (CPU 3 slot)

J304/J305 AC-1500-CPU (CPU 4 slot)

J204/J203 AC-1200-PR5 (Used with AC-1200 only) 1

J205/J206 AC-LAN-COMM or AC-1500-RS485 Primary

J209/J210 AC-LAN-COMM or AC-1500-RS485 Secondary (Reserved)

J102/J101/J3 AC-1500-PRDUAL or AC-1200-PR12 (Used with AC-1200 only) 2

J100 DC-IN +11.5 to +25 VDC with AC-1500-PRDUAL

J700 Connection to I/O Backplane 1

J306 Connection to I/O Backplane 2

J307 Connection to I/O Backplane 3

J308 Connection to I/O Backplane 4

J216 Battery connection for CPU memory retention AC-1200 Only 3

J211 RS485 Connection Primary Channel

J213 RS485 Connection Secondary Channel (Reserved) 4

J1 External 5.8-6.0 VDC Input

J2 External 12 VDC Input

J215 Loop connection for controller supervision

J214 MODEM Connection

Notes:

Some connectors were left on this backplane for backward compatibility with the AC-1200 Series.

The PRDUAL is a 6 Volts, 12 Volts and battery charger it replaces both PR5 and PR12.

1. AC-1200-PR5 is not used with AC-1500.

2. AC-1200-PR12 is not used with AC-1500.

3. This External 6 Volt battery is not use with AC-1500 Reader Modules (REK).

4. The Secondary channel is reserved for communication between the AC-1500 Main

Controller and Pinnacle hardware server.

Fuses Description

F1 DC-IN Fuse 5 Amp / 125 Volts

F2 5.8V Direct Fuse 5 Amp / 125 Volts

F3 12V Direct Fuse 5 Amp / 125 Volts

Page 10 of 33

Ce manuel convient aux modèles suivants

Table des matières

Manuels Contrôleurs populaires d'autres marques

Digiplex

Digiplex DGP-848 Mode d'emploi

YASKAWA

YASKAWA SGM series Manuel utilisateur

Sinope

Sinope Calypso RM3500ZB Manuel utilisateur

Isimet

Isimet DLA Series Style 2 Manuel d'installation

LSIS

LSIS sv-ip5a Manuel utilisateur

Rockwell Automation

Rockwell Automation 1769-L31 Manuel utilisateur

Airflow

Airflow Uno hab Manuel utilisateur

ABB

ABB ACS580-01 drives Manuel utilisateur

Panasonic

Panasonic GM1 Series Manuel utilisateur

Emerson

Emerson SW93 Manuel utilisateur

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manuel utilisateur

Panasonic

Panasonic FP? Positioning Unit RTEX Manuel utilisateur

Samson

Samson Type 5824 Manuel de service

Alpha IP

Alpha IP MIOB 21001 Manuel utilisateur

Siemens

Siemens OpenAir GMA 1 Series Manuel utilisateur

Surecom

Surecom SR-629 Manuel utilisateur

Fishman

Fishman TriplePlay Manuel utilisateur

Regulus

Regulus SRS1 T Manuel utilisateur