WELCOME TO USE THE SMOKE MACHINE
Products Description:
UniFog DMXis a well-designed smoke machine which user angle control of the smoke output.
With on Board DMX 512 and wired or wireless control options supplied with the machine provides flexibility for
permanent or mobile use.
This machine will operate on Jem Fog or ShowPro Fog fluids.
NOTES:
-The maintenance cycle for the machine is 1-2 months. Method: 20% white vinegarplus 80% distilled water, and then
work 3-5 times after heating!
-Only use Jem Pro-Fog fluid in this machine (JEMJCE051)
It is HIGHLY recommended that this smoke machine is not hung above or near areas
that may have people below it. There is a significant risk of hot liquid or vapor falling
and potentially harming any individuals below. We understand the need for a hanging
bracket and the applications and should only be hung by experienced personal to
ensure that risk is well managed. Please adhere to your local safety guidelines when
hanging this unit.
NOTES BEFORE USE:
1 Place the smoke machine horizontally and check for any damage or leaks. If damaged, please contact your
supplier at once. Loosen the lid of the fluid tank to pour in the high-quality smoke fluid, and then fasten the lid.
2 Before power on, please verify that the supply voltage is in conformity with the rated voltage of the smoke
machine. When the power is on, the indicator light will turn on, and the smoke machine will begin to operate
once heat up procedure is complete.
3 At first, it is normal if the smoke machine creates just a little smoke please be patient the machine will need to be
fully primed to output to its full capacity.
4 Please ensure the smoke machine is in a well-ventilated area. Don’t place the machine in a small non-vented
location as the over temperature protection will disable the machine from heating.
5 Never hang the smoke machine in areas where people could be under the machine this will avoid any risk
of injury.
6 Please ensure the fluid bottle is always to capacity this will avoid the pump failure due to low fluid.
7 Never operate the smoke machine on low fluid. If you need to prime the machine, please only use short burst until machine is
fully primed holding the machine at full with no fluid will cause pump failure
8 Never leave the smoke machine powered and unattended always keep clear of children as the output nozzle is of high temp.
9 Due to condensation, vapor or moisture might gather around the nozzleof machine. There might be some
surplus smoke ejected from any smoke machine during operation or after shutdown.
10 Please make sure there is no liquid and metals inside machine before turning on the power Each time.
Do not modify or repair the machine by yourself. If there is any problem, please contact the supplier.
