Do not use the detector with the cover open; always unplug the
detector from the main power source before opening the cover.
If the detector is used in a manner not specified by this operation
manual, the protection provided by the detector may be impaired.
When using flammable organic solvent as mobile phase, be sure
to make necessary arrangement to prevent accidental ignition
(fire) by static electricity.
If the fuse blows after being replaced, power off the detector
immediately and disconnect the power cord. Please consult
our local representative in your area or SHOKO SCIENTIFIC.
As this detector is readily affected by the ambient temperature, use
it in places where there is little wind or change in the ambient
temperature. Do not use the detector near any source of vibration,
electrical noise, or in places where corrosive gas and a lot of dust
are present.
External input/output terminals are for contact closure.
Never apply voltage to them.
Do not connect any tube other than the provided "OUT tube"
to the eluent outlet joint of the detector. Put the exit end of
the "OUT tube" in the waste liquid bottle and do not apply back
pressure.
When connecting this detector to other detectors in series, put
it at the end.
Make sure that no back pressure is applied to the outlet of the
detector. Connect the tip of the Teflon tube on the cell outlet of the
detector to a receptacle for waste liquid.
If eluent freezes inside the detector, the flow line might break,
damaging the detector. If there is any chance of eluent freezing
during stoppage or storage of the detector, withdraw the eluent
completely from the flow line of the detector.
When using any eluent containing a salt at high concentration, make
sure that the flow line is washed with water thoroughly after use
.
Failure to do so may result in plugging of the line, causing the
detector to cease operation.
If the detector is not to be used for more than one week, prior
to storage, wash the flow line with pure water or acetone, and dry
the line by allowing nitrogen gas to flow through it.
Do not use any eluent which might corrode the material, such as
stainless steel, that it comes into contact with. Use of such eluent
might cause a base line drift and damage the detector.
Caution
Caution
Caution
Caution
Caution
Caution
Caution
Caution
！
Warning
！
Warning
！
Warning
！
Warning
Caution
