Sharp ES-HK800G Manuel utilisateur

ES-HK800G

Operation Manual

WASHING MACHINE

If the appliance is sold or transferred to another owner or if you moved house and leaving the

appliance, always ensure the manual is supplied with the appliance in order for the new owner

can get to know its functions and its relevant warnings. These warnings have been provided for

your safety. You MUST read them carefully before installing or using the appliance.

Before using

Parts name........................................

Cautions........................................... 2

Installation and adjustment.................

How to usedrainpipe.......................... 5

Water

inlet

installation........................ 6

Operation

Preparation before operation..............7

Load

laundries..............................

Use

of detergent................................ 9

Control panel instructions..................

Operation steps................................ 12

Maintenance.....................................

Common non-fault phenomenon.........

Specification.....................................

Contents

Additionalfunctions.......................... 15

Others

Pay attention to the warning symbols.There may be serious risks on personal

safety or may damage the washing machine if not followed.

The contents of this symbol are prohibited.It may damage the appliance and

can lead to injury.

Prohibited symbol

Warning symbols

Drainpipe

The end connect to

the appliance

Bottom cover

(1pc) Water inlet hose (1pc) Outfall stopper

(1pcs)

The end connect to

water inlet hose connector

220V.

This appliance is not intended for use by persons(including

children) with reduced physical, sensory or mental capabilities,

or lack of experience and knowledge, unless they have been

given supervision or instruction concerning use of the

appliance by a person responsible for their safety.Children

should be supervised to ensure that they do not play with the

appliance.

Notice

Please install and adjust the machine according tothe requirements of the manual.

Correct operation is very important for your safety.

Unpacking

Unpack the carton and take out the bottom cover.

Open the top lid of washing machine and take out all of the accessories.

Remove all wrappers, including the polystyrene base.

You are advised to keep all the packaging for reuse in case the machine is to be

transported again.

Positioning

Make it horizontal.

Use a tied thread with plumb to check

if it is horizontal.

Adjust the adjustable foot

and twist the adjustable foot.

2) Fasten the nut after adjustment.

Installing the bottom cover

1°

Adjustable nut

Adjustable

foot

1) Lift up the adjustable foot gently, loose the adjustable nut

Fixing clamp

Scissors

Bottom cover

The base

The distance between the washing machine and the wall should be more than 50mm,

and the maximum allowable angle of the shank base of the machine is 1°.

The slanting or rough ground maycause operating stopped or unstable, please adjust it

with the following methods:

Let the back of washing machine incline forward,

make the side of the bottom cover with sticker

description facing outside. Insert it to the bottom

of washing machine along the direction of the

arrow.

Remove two fixing clamp by scissors, insert it on

on the cover's aloted holes as shown on the figure

(gently pull fixing clamp and it should not be pulled

out). Make the bottom cover fixed on the base.

1.The drainpipe must be hanged during use, the height is not more than 1.2m to

avoid leakage or stop, if drain a long time, the machine will stop running.

2.You can adjust the situation of the elbow bend pipe to change the height of the

drainpipe.

3.Do not extrude the drainpipe to ensue drain smoothly.

Drainpipe

Elbow

Less than 1.2m

Cautions:When install the washing machine, please use the new hose assy along with

the washing machine, old hose assy can not reuse.

Tap selection

Check the connection between inlet

hose connector and the tap

Connect the inlet hose with the washing machine

1. Swing the inlet hose gently to confirm if it is

fastened.

2. After installation,open the tap and check if

it leaks.

3. Do not bend the inlet hose with overstrain.

4. Before each usage,check the connection

between inlet hose connector and the tap.

Make sure they are firmly fitted to prevent

dropping from improper installation position.

1. Do not take off the water absorption cushion. Please

check if the cushion is dropped or damaged before

each usage. If it is, contact the seller immediately.

2. Put the inlet hose nut on the inlet valve connector.

3. Fasten the inlet hose nut and swing it gently to make

sure if it is suitable.

Inlet valve connector

Inlet hose nut

Water absorption cushion

Suitable tap

The front end should be longer than 10mm. The tap exit end

face should be flat and smooth, if not file it to avoid leakage.

Not suitable tap

Table des matières

Autres manuels Sharp Rondelle

Sharp

Sharp ES-G1752C4 Manuel utilisateur

Sharp

Sharp ES-FW105SG Manuel utilisateur

Sharp

Sharp ES-NFB814AWC-FR Manuel utilisateur

Sharp

Sharp ES-NFA6102WD-UA Manuel utilisateur

Sharp

Sharp ES-NFA6102WD-EE Manuel utilisateur

Sharp

Sharp ES-NFA8121WD-PL Manuel utilisateur

Sharp

Sharp ES-NFB814CWDA-CB Manuel utilisateur

Sharp

Sharp ES-NFA7121WD-FR Manuel utilisateur

Sharp

Sharp ES-HFH814AWC-CZ Manuel utilisateur

Sharp

Sharp ES-NFA9121WD-ES Manuel utilisateur

Sharp

Sharp ES-HK700G Manuel utilisateur

Sharp

Sharp ES-HFA5101WD-EE Manuel utilisateur

Sharp

Sharp ES-NFA014DWB-DE Manuel utilisateur

Sharp

Sharp ES-HFH814AWC-EE Manuel utilisateur

Sharp

Sharp ES-NB914W-BE Manuel utilisateur

Sharp

Sharp ES-GFB7145WD-DE Manuel utilisateur

Sharp

Sharp ES-HFB0143WD-EN Manuel utilisateur

Sharp

Sharp ES-NFH014CWC-PL Manuel utilisateur

Sharp

Sharp ES-HFH6127WD-PL Manuel utilisateur

Sharp

Sharp ES-GFB7143WD-EE Manuel utilisateur

Sharp

Sharp ES-NFB7141WD-EE Manuel utilisateur

Sharp

Sharp ES-HFH014ESC-FR Manuel utilisateur

Sharp

Sharp ES-NFB612CWB-CZ Manuel utilisateur

Sharp

Sharp ES-HFB8143WD-EE Manuel utilisateur

Manuels Rondelle populaires d'autres marques

Tricity Bendix

Tricity Bendix AW 1000 W Guide produit

Panasonic

Panasonic NA-F60L5WRB Manuel utilisateur

GE WSLP1500 Manuel

Electrolux

Electrolux EWF1284EDW Manuel utilisateur

Bosch

Bosch WAN2829BSN Manuel utilisateur

LG TV2516DV3B Manuel utilisateur

LG TH2517DSAV Manuel utilisateur

VESTEL

VESTEL CMH-XL 7510 TE Manuel utilisateur

AEG

AEG 74335 Manuel d'utilisation

Johnson

Johnson JWF721A Manuel utilisateur

Beko

Beko WTE7604XLW0 Manuel utilisateur

Danby

Danby DTT100A1WDB Instructions de montage

Amica

Amica WA 14 Ex Manuel utilisateur

Daewoo

Daewoo DWD-F1222 Manuel utilisateur

Bosch

Bosch WAS28461AU Manuel utilisateur

Miele

Miele PW 6080 Vario Manuel utilisateur

Finlux

Finlux FLX108CF220 Manuel utilisateur

Whirlpool

Whirlpool 3LBR5132AN0 Manuel utilisateur