Sharp Actius PC-RD20 Manuel utilisateur
1
Supplement for PC-RD20
• Specifications
• Re-installation Instructions
Specifications
Parts Specifications
CPU Intel Desktop Pentium4 Processor 3.06GHz *1, FSB 533MHZ
Primary cache 8KB (data cache) and 12K (micro-op trace cache),
Integrated with CPU
Secondary cache 512KB, Integrated with CPU
ROM Including system BIOS,VGA BIOS, Plug&play compliant BIOS
Main memory DDR SDRAM 512MB, expandable up to 1,024MB
RAM
Video 64MB
Panel Active Matrix (TFT) color LCD 15”(38.1cm)
Video controller NVIDIA® GeForce™4 440 Go
Display
Resolution/color 1024 x 768 dots/16M colors by FRC dithering function
Keyboard IBM compatible keyboard
Pointing device Glide pad (touch-sensitive control pad with 2 buttons )
Hard disk Approx. 60GB (C: Approx. 30GB, D: Approx. 30GB),
IDE interface
Floppy disk 3.5”, 1.44MB/720KB
Writing CD-R:16x (max.), DVD-R: 2x (max.)
Re-
writing
CD-RW:8x (max.) *3
DVD-RAM(4.7/9.4GB): 2x (max.), DVD-RW: 1x
Drive
Optical
*2
Reading CD-RW:12x (max.), CD-R:24x (max.), CD-ROM:24x (max.),
DVD-RAM (4.7/9.4GB):2x (max.), DVD-RAM (2.6/5.2GB):1x,
DVD-RW:4x (max.), DVD-R:4x (max.),
DVD+R: 4x (max.), DVD+RW: 4x (max.),
DVD-ROM (single layer):8x (max.),
DVD-ROM (double layer):6x (max.)
PC card slot Type II ×1 (PC Card Standard compliant) CardBus compliant
SD/SmartMedia combo slot SD/SmartMedia combo slot x 1 (Alternative)
MemoryStick slot Memory Stick slot x 1
CompactFlash slot CompactFlash slot x 1
Audio system Sound speaker, sound system compliant with AC’97 audio
Audio Audio output jack (stereo, S/PDIF compliant), external microphone
jack (monaural)
Video external display connector, S video connector
I/O ports
Others USB port x 4 (USB2.0), IEEE 1394 connector x 1
Modem Data: 56Kbps (receive), 33.6Kbps (send), Fax: 14.4Kbps
LAN 100 BASE-TX/10 BASE-T
Radio technology DSSS (IEEE 802.11b) compliantWireless LAN
Operating channels 11 channels
Operating system*4Microsoft® Windows® XP Home Edition Service Pack 1a
Power AC adapter 100-240V, 50-60 Hz
2
Battery Rechargeable lithium ion battery
Battery life *1*5Approx. 1.0 hours (standard battery pack only)
Battery charging
time
Turned off/hibernation: Approx. 4.0 hours
Turned on: Approx. 8.0 hours
Dimensions
*No protrusion is included.
13.9" wide x 11.7" deep x 1.82" (min.)/ 2.09" (max.) high
(352mm x 296mm x 46mm(min.)/53mm(max.))
Weights About 10.4 lbs (4.7kg)
Temperature 50°F to 95°F (10°C to 35°C)
Operating
environment Humidity 20% to 80% (non-condensation)
*1 While operating on battery power, the CPU performs at approx. 25% of the maximum CPU performance.
In rare cases, the CPU performance may be temporarily reduced to 87.5% of the maximum CPU
performance under AC powered operation.
*2 Supporting the buffer underrun protection technology which prevents the buffer underrun error occurred
when the optical drive writes too fast for the buffer to supply data or if some other application is being
used. (Buffer is the storage place of the data read from the hard drive or another media and supplies the
data to the recording media smoothly.)
*3 8x/10x speed CD-RW writing/re-writing requires High Speed CD-RW media.
*4 This model (PC-RD20) does not support other operating systems than the pre-installed one.
*5 Battery life is based on BAPCo® MobileMark™ 2002. Battery life will vary based on many
factors including screen brightness, applications, features, battery conditioning, power management and
other customer preferences.
- N O T E -
In addition to the components listed in the Setup Guide,
you will find 3 EA games packed in paper sleeves.
- Need for Speed: Hot Pursuit 2 (One CD-ROM)
- James Bond 007: NIGHTFIRE (Two CD-ROM set)
- Tiger Woods PGA TOUR 2003 (Three CD-ROM set)
3
Re-installation Instructions
To recover your hard disk, you will use PowerQuest®EasyRestore™. Before starting re-
installation, read the following End User License Agreement first.
PowerQuest(R) EasyRestore (TM) End User License Agreement
IMPORTANT: Read this before using your copy of PowerQuest software.
This document is a legal agreement between you, the "end user," and PowerQuest Corporation. Use of the
software indicates your acceptance of these terms. As used in this License Agreement, the term "Software"
means the EasyRestore software included on the CD provided with this License Agreement.
1. PROPRIETARY RIGHTS. The Software is a proprietary product of PowerQuest Corporation
("PowerQuest") or its licensors and is protected under U.S. copyright laws and international treaty
provisions. Ownership of the Software and all copies, modifications, and merged portions thereof shall at
all times remain with PowerQuest or its licensors.
2. GRANT OF LICENSE. The Software is being licensed to you, which means you have the right to use the
Software only in accordance with this License Agreement. The Software contains pre-installed software for
disaster recovery purposes. The Software is only authorized for distribution together with a specific
computer. This License authorizes you to use the Software for disaster recovery purposes only, to restore
the hard disk image contained on the CD to the computer with which the CD and Software were originally
shipped.
3. NONPERMITTED USES. Without the express permission of PowerQuest, you may not (a) use, copy,
modify, alter, or transfer, electronically or otherwise, the Software or documentation except as expressly
permitted in this License Agreement, or (b) translate, reverse program, disassemble, decompile, or
otherwise reverse engineer the Software.
4. TECHNICAL SUPPORT. PowerQuest is NOT responsible to provide technical support. Any and all
technical support questions, regarding the Software, should be referred to the place of purchase.
5. U.S. GOVERNMENT RESTRICTED RIGHTS. If you are acquiring the Software on behalf of any unit
or agency of the United States Government, the following provision applies: It is acknowledged that the
Software and the documentation were developed at private expense and that no part is in the public domain
and that the Software and documentation are provided with RESTRICTED RIGHTS. Use, duplication, or
disclosure by the Government is subject to restrictions as set forth in subparagraph (c)(1)(ii) of the Rights in
4
Technical Data and Computer Software clause at DFARS 252.227-7013or subparagraphs (c)(1) and (2) of
the Commercial Computer Software-Restricted Rights at 48 CFR 52.227-19, as applicable.
Contractor/manufacturer is PowerQuest Corporation/P.O. Box 1911/Orem, UT 84059.
6. NO WARRANTY. The Software is being provided to you AS IS. PowerQuest does not warrant the
Software to end users. If the Software fails to perform substantially in accordance with the documentation
provided to your hardware supplier, PowerQuest will repair or replace the copy of the Software provided to
your hardware supplier and will authorize your hardware supplier to provide such repaired or replaced
Software to you without charge.
7. LIMITATION OF LIABILITY. NEITHER POWERQUEST NOR ITS SUPPLIERS SHALL IN ANY
EVENT BE LIABLE FOR ANY DAMAGES WHATSOEVER ARISING OUT OF OR RELATED TO
THE USE OF OR INABILITY TO USE THE SOFTWARE, INCLUDING BUT NOT LIMITED TO
DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, AND
DAMAGES FOR LOSS OF BUSINESS PROFITS, BUSINESS INTERRUPTION, LOSS OF BUSINESS
INFORMATION, OR OTHER PECUNIARY LOSS, EVEN IF POWERQUEST CORPORATION HAS
BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES, WHETHER SUCH LIABILITY IS
BASED ON CONTRACT, TORT, WARRANTY, OR ANY OTHER LEGAL OR EQUITABLE
GROUNDS. BECAUSE SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF
LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, THE ABOVE LIMITATION
MAY NOT APPLY TO YOU.
8. NO WAIVER. Any failure by either party to this agreement to enforce a specific part of the agreement in
a specific situation is not a waiver of rights under the agreement. The party may still enforce the rest of the
agreement in that situation and may still enforce some or all of the agreement in other situations.
9. This License Agreement constitutes the entire agreement between you and PowerQuest pertaining to its
subject matter. This License Agreement is governed by the laws of the State of Utah. Any litigation arising
from this license will be pursued only in the state or federal courts located in the State of Utah.
Copyright 1994-2003, PowerQuest Corporation. All rights reserved. U.S. Patents 5,675,769; 5,706,472; and
5,930,831; other patents pending in the U.S.A. and elsewhere. PowerQuest is a registered trademark and
EasyRestore is a trademark of PowerQuest Corporation.
5
Preparation for Re-installation
You can format the hard disk and re-install the preinstalled software with the provided
recovery CD-ROMs, and set the status of your computer to the same configuration as
shipped from the factory. The following items are necessary for re-installation:
• Product Recovery CD-ROMs
• Supplement for PC-RD20 (this booklet)
• Operation Manual
• It will take about 20 minutes to complete the re-installation.
• Use the Product Recovery CD-ROMs only for your computer.
• The Product Recovery CD-ROMs are not for sale. Keep them in a
secure place.
• Unless otherwise specified, the instructions in this booklet assume
that you are installing Windows XP into the C:\WINDOWS directory.
Backing up the data
Before formatting the hard disk, you should back up your data. For details on how to
back up your data, see the Windows Online Help.
Selecting the way to recover your system
Your computer has two drives (C: and D:) in its hard disk when it was shipped from
the factory. You can select the way to recover your system.
• Recovers C: drive only. (Recommended)
This process will format C: drive only and recover C: drive to the same status as
shipped from the factory. Nothing will be done to D: drive. The volume of the
drives will not be changed and current ones will be kept.
• Recovers both C: and D: drive.
This process will format both C: and D: drives, and contents of the hard disk are
restored to its original state in C: drive. The volume of the drives will be back to
the same as shipped from the factory.
• Formats hard disk and creates new partition.
This process will format the whole hard disk drive and creates a new partition. You
can select the volume of C: and D: drives. The contents of the hard disk are
restored to its original state in C: drive.
6
Formatting the drives and re-installing Windows XP
1. Make sure the computer is turned off.
2. If any peripheral devices are connected to your computer, disconnect them.
3. Connect the AC adapter; then, turn on the computer.
Be sure to connect the AC adapter. If the battery power becomes
significantly low, the installation process will be canceled.
4. When the message <F2> to enter System Configuration Utility appears, press
F2. The Setup Utility will open.
5. Insert the Product Recovery CD-ROM disk 1 into the optical drive.
6. In the Exit menu, select Load Setup Defaults; then, press Enter twice.
7. In the Exit menu, confirm Exit Saving Changes is highlighted and press Enter
twice. The system will restart.
Although the pointer may be shown on the screen, never touch the
keyboard or the glide pad during recovery except when the message
prompts you to. If you touch them, the re-installation will be canceled.
8. Read the message on the screen, and select the way to recover your system;
then, press Enter.If you select Formats hard disk and creates new partition, go
to the next step. Otherwise, go to Step 10.
9. Select the volume of C: drive and press Enter.
10. Read the message and select Continue; then, press Enter.
11. If you see the message asking you to replace the CD-ROM, remove the Product
Recovery CD-ROM disk 1 and insert the Product Recovery CD-ROM disk 2;
then, click OK.
12. If you see the message asking you to replace the CD-ROM, remove the Product
Recovery CD-ROM disk 2 and insert the Product Recovery CD-ROM disk 3;
then, click OK.
13. When the re-installation process is completed, the system will restart
automatically.
14. Set up Windows XP by following the instructions on the screen. When you
finish the setup, the recovery is completed. Make sure to set date and time and
remove the CD-ROM disk 3.
561867453001
Autres manuels pour Actius PC-RD20
1
Table des matières
Autres manuels Sharp Ordinateur portable
Sharp
Sharp Actius PC-UM32W Manuel utilisateur
Sharp
Sharp Actius PC-MC22 Manuel utilisateur
Sharp
Sharp Actius PC-UM20 Manuel utilisateur
Sharp
Sharp PC-A500 Manuel utilisateur
Sharp
Sharp MV12W - Actius - PIII-M 1 GHz Manuel utilisateur
Sharp
Sharp PC-AL27 - Actius AL27 - Mobile Athlon 64 1.6... Manuel utilisateur
Sharp
Sharp Actius PC-MC24 Manuel utilisateur
Sharp
Sharp Actius PC-UM30W Manuel utilisateur
Sharp
Sharp PC-W100T Manuel utilisateur
Sharp
Sharp PC-AR50 Manuel utilisateur
Sharp
Sharp PC-AX Series Manuel utilisateur
Sharp
Sharp Actius PC-UM20 Manuel utilisateur
Sharp
Sharp Actius PC-TN10W Manuel utilisateur
Sharp
Sharp Actius PC-UM20 Manuel utilisateur
Sharp
Sharp Actius PC-MV10 Manuel utilisateur
Sharp
Sharp Actius PC-MC22 Manuel utilisateur
Sharp
Sharp Actius PC-TN10W Manuel utilisateur
Sharp
Sharp PC-9300 Manuel utilisateur
Sharp
Sharp PC-MV10 Series Manuel utilisateur
Sharp
Sharp AV18P - Actius - Athlon XP-M Manuel utilisateur
