Sharp PN-TPC1W Manuel utilisateur

PN-TPC1W

Users Guide©

Version – 1

Getting Started

Introduction to PN-TPC1W

The PN-TPC1W is a full-featured High Definition PC based upon

NVIDIA®ION™ architecture. Targeted for Commercial applications

such as interactive digital white boards, the PN-TPC1W has been

optimized for reliable operation with the Sharp® PN-L601B touch

screen display. The PN-TPC1W includes the Sharp Pen Software™

application pre-installed on the hard disk. It also has the flexibility to

run most third party software and custom applications. The PN-

TPC1W supports true 1080P video with hardware assisted support for

formats such as MPEG2, H.264, and WM9. The PN-TPC1W was

designed with display integration in mind and features a full

complement of video outputs including HDMI®

, DVI, and VGA. The

unit also includes an RS232 port for display control and a custom

mounting bracket specially designed to attach behind a Sharp PN-

L601B touch screen display.The PN-TPC1W’s all metal chassis and

small form factor make it ideal for commercial applications requiring

a powerful yet compact PC.

Package Contents

The packing box should contain the following

items:

Technovare™ PN-TPC1W

AC Power Adapter

Mounting Kit

HDMI®

Connection Diagram

Cable

This Users Guide

Getting Started

Federal Communications Commission (FCC)

Statement

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with instructions contained in

this manual, may cause harmful interference to radio and television

communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following

measures:

- REORIENT OR RELOCATE THE RECEIVING ANTENNA

- INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND THE RECEIVER

- CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM

THAT OF THE RECEIVER

- CONSULT THE DEALER OR AN EXPERIENCED AUDIO/TELEVISION

TECHNICIAN

NOTES:

Connecting this device to peripheral devices that do not comply with Class B

requirements, or using an unshielded peripheral data cable, could also result in

harmful interference to radio or television reception.

The user is cautioned that any changes or modifications not expressly approved by

the party responsible for compliance could void the user’s authority to operate this

equipment. To ensure that the use of this product does not contribute to

interference, it is necessary to use shielded I/O cables.

Getting Started

Specifications

Chipset

oNVIDIA®MCP7A-ION™ Series

Size

oMini-ITX form factor

oCase: 7.5” x 7.4” x 1.75”

Microprocessor support

oIntel®ATOM™ N330 1.6 GHz CPU (onboard)

oSupport for 533 MT/s (533MHz FSB)

Operating systems:

oSupports Windows®XP®32bit/64bit and Windows Vista®

32bit/64bit

oSupports Linux®

oWindows XP Pro SP3 installed

Software Installed:

oSharp®Pen Software™ Application

oMicrosoft®Internet Explorer®

oMicrosoft PowerPoint®Viewer

oWindows Media®Player

oQuickTime®Player

oAdobe®Flash® Player Plug-in

System Memory support

oSupports DDRII667/800.

oSupports up to 4GBs (2GB installed – both slots occupied

and need to remove the current memory modules to

upgrade.)

USB 2.0 Ports

oSupports hot plug and play

oSix USB 2.0 ports (rear panel ports)

oFour from onboard USB headers

oSupports USB 2.0 protocol up to 480 Mbps transmission

rate

Hard Disk Drive

o2.5” 160GB

Onboard Serial ATA II

oIndependent DMA operation on four ports

oOnboard SATA header

oRear panel e-SATA

oData transfer rates of 3Gb/s.

On board RTL8211 CL Gigabit LAN

oSupports 10/100/1000M bps operation

Specifications

Specifications (con’t)

Onboard Audio

oAzalia™ High-Definition audio

oSupports 6-channel

oSupports Jack-Sensing function (under Windows)

Green Function

oSupports ACPI (Advanced Configuration and Power

Interface)

oRTC timer to power-on the system

oAC power failure recovery

Onboard Graphics support

oIntegrated 300MHz DAC for analog displays with

resolutions up to 1920x1440 at 75Hz.

oIntegrated GeForce®9400m GPU, Supports DX10

oVGA / DVI / HDMI®output support (Dual Header capable)

Integrated HDMI®Interface with HDCP

oSupports DVI or HDMI 1.3 interfaces

oSecure digital audio merged from integrated HDA codec

with no external audio signals required

oSupport for HDCP 1.3 using soft or hard HDCP keys

oHDCP encryption support when configured as DVI or HDMI

link without the need for external HDCP key crypto ROM

Dual Head Display Controller

oFull NVIDIA nView™ multi-display technology capability

with independent display controllers

oEach controller can drive same or different display

contents to different resolutions and refresh rates

Expansion Slots

oOne Mini PCI Express slot. (Optional WiFi module must

occupy this slot if ordered)

Environmental

oOperating Temperature: 0° to 40° C

oOperating Humidity: 80% maximum relative humidity,

non-condensing

Power

oInput Voltage: 19V 4.7A

oPower Dissipation: 30 Watts

Installation

Mounting PN-TPC1W on Sharp PN-L601B

Displays

1. Before beginning

Make sure to turn off the monitor and remove the AC power.

2. Items needed

•Sharp PN-L601B

Touchscreen Display

•PN-TPC1W

•Mounting Plate

•AC Power Adapter

•4 x M4 (0.7x10mm) screws

•2 x M3 (0.5x5 mm)

•Phillips®Screw Driver

3. Attach the mounting plate

There are 8 holes on the

mounting plate, but only use 4

holes to match the monitor’s

mounting holes depending on the

monitor model.

The mounting plate is attached to

a similar Sharp “PN” series

display as an example in Figure

Secure the mounting plate to the

monitor with four included M4

screws.

Figure 1

Installation

4. Set the AC power adapter in

place

Place the AC power adapter into

the holder on top of the

mounting plate as in Figure 3.

AC power cord faces inside and

the DC power cord to the PN-

TPC1W faces outside.

5. Install the PN-TPC1W

If you look at the top side of the

PN-TPC1W before sliding it into

the mounting plate as in Figure

4, there are two small slits near

the edges on the PN-TPC1W and

two small fingers on either side

of AC power adapter holder on

the mounting plate.

As you slide the PN-TPC1W into

the mounting plate, insert the

two fingers into these slits as in

Figure 5.

There are two fingers on the

bottom of the mounting plate to

catch the PN-TPC1W in place as

shown in Figure 6, and they need

Figure 2

Figure 3

Figure 4

Installation

to be tightened with two include

M3 screws.

6. Finish

Plug in the DC power cord into

the PN-TPC1W’s power connector

as in Figure 7.

Figure 7

Figure 5

Figure 6

Installation

Rear Connector Layout

1. PS/2 keyboard connector

2. USB Connectors

3. HDMI®Port

4. S/PDIF Out (Coaxial / Optical)

5. DVI Connector

6. eSATA Connector

7. Audio Port 2-Channel 4-Channel 6-Channel

Blue Line-In Rear Speaker Out Rear Speaker Out

Green Line-Out Front Speaker Out Front Speaker Out

Pink Mic In Mic In Center/Subwoofer

8. LAN Connector (with LED status indicator)

Yellow/Light Up/Blink = 10 Mbps/Link/Activity

Yellow and Orange/Light Up/Blink = 100 Mbps/link/Activity

Yellow and Orange/Light Up/Blink = 1000 Mbps/link/Activity

9. VGA Port

Installation

Rear Connector Layout (con’t)

10. Power Connection (refer to the figure in the previous page)

Use only the AC power adapter supplied with the system.

Input: 100~240V AC 1.5A

Output: 19V DC 4.74A

Plug the 19V AC/DC adapter (as in the figure 1 above) to the PN-

TPC1W’s power input jack (as in the figure 2).

11. Power Button

This button will stay lit if the PN-TPC1W is powered on. If the

PN-TPC1W doesn’t power up after the AC is connected, then

press this button to power up. If normal Windows shutdown is

not shutting down the PN-TPC1W, then press this button for

more than 4 seconds will turn off the PN-TPC1W. In this case,

run Disk Cleanup in the Windows next time the PN-TPC1W is

powered up.

12. WiFi antenna connector (optional; refer to the figure in the

previous page)

Install the enclosed antenna to the WiFi connector and turn

clockwise.

Orient the antenna mast to achieve optimum reception and

tighten the antenna base to the WiFi Connector.

Table des matières

Autres manuels Sharp Ordinateur de bureau

Sharp

Sharp ZQ-3000 Manuel utilisateur

Sharp

Sharp Shuttle PN-SPCi5W7 Manuel utilisateur

Sharp

Sharp YO-270 Manuel utilisateur

Sharp

Sharp PC-1500A Manuel utilisateur

Sharp

Sharp Mobilon HC-4000 Manuel utilisateur

Sharp

Sharp PN-L602B Manuel utilisateur

Sharp

Sharp MZ-80B Guide d'installation

Sharp

Sharp MZ-700 Series Manuel utilisateur

Sharp

Sharp YO-250M Manuel utilisateur

Sharp

Sharp MZ-700 Series Manuel utilisateur

Sharp

Sharp MZ-80B Manuel utilisateur

Sharp

Sharp MZ-800 Manuel utilisateur

Sharp

Sharp PN-TPCi7W7 Manuel utilisateur

Sharp

Sharp PC-7200 Manuel utilisateur

Sharp

Sharp MZ-800 Manuel d'utilisation et d'entretien

Sharp

Sharp MZ-80B Manuel utilisateur

Sharp

Sharp ZQ-4400 Manuel utilisateur

Sharp

Sharp MZ-80A Manuel utilisateur

Sharp

Sharp MZ-800 Manuel utilisateur

Sharp

Sharp SCR3042FB Manuel utilisateur

Sharp

Sharp CE-159 Manuel utilisateur

Sharp

Sharp PC-4741 Manuel utilisateur

Sharp

Sharp PC-AX40 Manuel utilisateur

Sharp

Sharp PC-4741 Manuel utilisateur

Manuels Ordinateur de bureau populaires d'autres marques

HP m9060n - Pavilion - Elite Fiche technique

Asus

Asus E210 Series Manuel utilisateur

Dell

Dell Inspiron 600m Manuel utilisateur

Dell

Dell Inspiron 3662 Manuel utilisateur

TotalFlow

TotalFlow uFLO Manuel utilisateur

HP Presario SV7000 - Desktop PC Manuel utilisateur

HP ProDesk 400 G5 Manuel

Logitech

Logitech MK320 Manuel utilisateur

Dell

Dell XPS 730 H2C Manuel utilisateur

Sony

Sony Vaio Series Manuel utilisateur

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Manuel utilisateur

Alto

Alto MD 250 Manuel utilisateur

Lenovo

Lenovo ThinkCentre Edge 72 Manuel

Lenovo

Lenovo ThinkStation D20 Manuel

Arbor Technology

Arbor Technology FPC-7800 Series Manuel utilisateur

Sony

Sony VAIO VGX-TP1 Series Manuel utilisateur

Asus

Asus Eee Box B204 Manuel utilisateur

Dell

Dell Optiplex 9010 All In One Manuel utilisateur