Sharp EL-2607PC Manuel utilisateur
EL-2607PC
ELECTRONIC PRINTING CALCULATOR
DRUCKENDER TISCHRECHNER
CALCULATRICE IMPRIMANTE ÉLECTRONIQUE
CALCULADORA IMPRESORA ELECTRÓNICA
CALCOLATRICE ELETTRONICA STAMPANTE
ELEKTRONISK SKRIVANDE OCH VISANDE RÄKNARE
ELEKTRONISCHE REKENMACHINE MET AFDRUK
CALCULADORA ELETRÔNICA COM IMPRESSORA
NAUHALASKIN
SZALAGOS ASZTALI KALKULÁTOR
OPERATION MANUAL
BEDIENUNGSANLEITUNG
MODE D’EMPLOI
MANUAL DE MANEJO
MANUALE DI ISTRUZIONI
BRUKSANVISNING
GEBRUIKSAANWIJZING
MANUAL DE INSTRUÇÕES
KÄYTTÖOHJE
HASZNÁLATI ÚTMUTATÓ
ENGLISH ............................................................... Page 2
CALCULATION EXAMPLES ................................. Page 92
DEUTSCH .............................................................. Seite 11
RECHNUNGSBEISPIELE ..................................... Seite 92
FRANÇAIS ............................................................. Page 20
EXEMPLES DE CALCULS .................................... Page 93
ESPAÑOL .............................................................. Página 29
EJEMPLOS DE CÁLCULOS ................................. Página 93
ITALIANO .............................................................. Pagina 38
ESEMPI DI CALCOLO ........................................... Pagina 94
SVENSKA .............................................................. Sida 47
RÄKNEEXEMPEL .................................................. Sida 94
NEDERLANDS ...................................................... Pagina 56
REKENVOORBEELDEN ....................................... Pagina 95
PORTUGUÊS ........................................................ Página 65
EXEMPLOS DE CÁLCULOS ................................. Página 95
SUOMI ................................................................... Sivu 74
LASKENTAESIMERKKEJÄ ................................... Sivu 96
MAGYAR ............................................................... Oldal 83
SZÁMÍTÁSI PÉLDÁK ............................................. Oldal 96
EL-2607PC(AGO)-Cover-1 03.11.25, 0:26 PM1
EL-2607PC(AGO)-Cover-2 03.11.13, 0:22 PM2
1
Caution!
The socket outlet shall be installed near the equipment and shall be easily accessible.
Vorsicht!
Die Netzsteckdose muß in der Nähe des Gerätes angebracht und leicht zugänglich sein.
Attention!
La prise de courant murale doit être installée à proximité de l’appareil et doit être
facilement accessible.
Aviso!
El tomacorriente debe estar instalado cerca del equipo y debe quedar bien accesible.
Attenzione!
La presa della corrente deve essere installata in prossimità dell’apparecchio ed essere
facilmente accessibile.
Observera!
Anslut till ett vägguttag som återfinns nära enheten och är lätt åtkomligt.
Let op!
Het stopcontact moet in de buurt van het apparaat zijn en ook gemakkelijk toegankelijk
zijn.
Atenção!
A tomada elétrica deve estar perto do equipamento e ser de fácil acesso.
Huomautus!
Pistorasia tulee asentaa laitteen lähelle paikkaan, jossa sen käyttöä on helppoa.
Figyelem!
A kalkulátort úgy érdemes elhelyezni, hogy a hálózati csatlakozó aljzatot könnyen el lehessen
érni.
EL-2607PC(AGO)-IEC950 03.11.6, 7:50 AM1
2
CONTENTS
OPERATIONAL NOTES
ENGLISH
Page
• OPERATING CONTROLS ................................ 3
• INK RIBBON REPLACEMENT ......................... 6
• PAPER ROLL REPLACEMENT ........................ 7
• ERRORS ........................................................... 8
• SPECIFICATIONS ............................................. 9
• IN CASE OF ABNORMAL CONDITIONS ....... 10
• CALCULATION EXAMPLES ...........................92
• EURO CONVERSION ................................... 112
To insure trouble-free operation of your SHARP
calculator, we recommend the following:
1. The calculator should be kept in areas free from
extreme temperature changes, moisture, and
dust.
2. A soft, dry cloth should be used to clean the
calculator. Do not use solvents or a wet cloth.
3. Since this product is not waterproof, do not use
it or store it where fluids, for example water, can
splash onto it. Raindrops, water spray, juice,
coffee, steam, perspiration, etc. will also cause
malfunction.
4. If you pull out the power cord to cut electricity
completely, the presently stored conversion
rate will be cleared.
5. If service should be required on this equipment,
use only a SHARP servicing dealer, a SHARP
approved service facility or SHARP repair
service where available.
6. Do not wind the AC cord around the body or
otherwise forcibly bend or twist it.
SHARP will not be liable nor responsible for
any incidental or consequential economic or
property damage caused by misuse and/or
malfunctions of this product and its peripherals,
unless such liability is acknowledged by law.
EL-2607PC(AGO)-Eng 03.11.13, 0:25 PM2
3
POWER SWITCH; PRINT / ITEM
COUNT MODE SELECTOR:
“OFF”: Power off.
“•”: Power ON. Set to the non-print mode.
“P”: Power ON. Set to the print mode.
“P•IC”: Power ON. Set to the print and item count
mode.
1) The counter will count the number of times that
the key has been pressed in addition.
Note: •Each time the key is used in
subtraction, 1 will be subtracted from
the count.
•The count is printed when the calculated
result is obtained.
•Pressing of the , , , or
key clears the counter.
2) When the grand total/rate setting mode selector
is in the ON position (GT), the counter will count
the number of times that the calculation results
have been stored in the grand total memory. To
print and clear the count, press the key.
OPERATING CONTROLS 3) The memory item counter will count the number
of times that the key has been pressed in the
addition.
Note: •Each time the key is used in the
subtraction, 1 will be subtracted from
the count.
•The count is printed when the memory
is recalled.
•Pressing of the key clears the
counter.
Note: The counter has a maximum capacity of 3
digits (up to ±999). If the count exceeds the
maximum, the counter will recount from
zero.
DECIMAL SELECTOR:
Presets the number of decimal places in the
answer. In the ‘‘F’’ position, the answer is displayed
in the floating decimal system.
CONSTANT/ADD MODE SELECTOR:
‘‘K’’: The following constant functions will be
performed:
EL-2607PC(AGO)-Eng 03.11.13, 0:25 PM3
4
Multiplication:
The calculator will automatically remember the first
number entered (the multiplicand) and
instruction.
Division:
The calculator will automatically remember the
second number entered (the divisor) and
instruction.
‘‘•’’: Neutral
‘‘A’’: Use of the Add mode permits addition and
subtraction of numbers without an entry of
the decimal point. When the Add mode is
activated, the decimal point is automatically
positioned according to the decimal selector
setting.
Use of , and will automatically override
the Add mode and decimally correct answers will
be printed at the preset decimal position.
ROUNDING SELECTOR:
“”: An answer is rounded up.
“5/4”: An answer is rounded off.
“”: An answer is rounded down.
Note: The decimal point floats during successive
calculation by the use of or .
If the decimal selector is set to “F” then the answer
is always rounded down ( ).
GRAND TOTAL / RATE SETTING MODE
SELECTOR:
“GT”: Grand Total
“•”: Neutral
“ ”: Set this selector to the “RATE SET” posi-
tion before storing each rate.
•Enter the adding conversion rate, then
press .
•A maximum of 6 digits can be stored
(decimal point is not counted as a digit).
Note: •Be sure to set this selector to the
“•” position after storing an each
rate.
•Only one rate can be stored. If
you enter a new rate, the previous
rate will be cleared.
PAPER FEED KEY
LAST DIGIT CORRECTION KEY
GRAND TOTAL KEY
CLEAR ENTRY KEY
TOTAL KEY
EL-2607PC(AGO)-Eng 03.11.13, 0:25 PM4
5
MULTIPLICATION KEY
DIVISION KEY
MINUS EQUAL KEY
PLUS EQUAL KEY
CHANGE SIGN KEY
MARKUP KEY
MEMORY TOTAL CLEAR KEY
MEMORY SUBTOTAL RECALL KEY
MEMORY PLUS KEY
MEMORY MINUS KEY
CONVERSION KEY (TO A NATIONAL
CURRENCY)
CONVERSION KEY (TO THE EURO
CURRENCY)
PERCENT KEY
NON-ADD/SUBTOTAL KEY:
Non-add – When this key is pressed right
after an entry of a number in the
Print mode, the entry is printed on
the left-hand side with the symbol
“#”.
This key is used to print out
numbers not subjects to calcula-
tion such as code, date, etc.
Subtotal – Used to get subtotal(s) of additions
and/or subtractions. When
pressed following the or
key, the subtotal is printed with
the symbol “
◊
” and the calculation
may be continued.
By pressing this key even in the Non-print
mode, the displayed number is printed
with the symbol “P”.
AVERAGE KEY:
Used to calculate the average.
DISPLAY SYMBOLS:
M: A number has been stored in memory.
–: The display value is negative.
E: Error or overflow of capacity.
•:Appears when a number is in the grand total
memory.
* Although all available symbols are shown here
for instruction purposes, these symbols will not
appear on the screen simultaneously.
EL-2607PC(AGO)-Eng 03.11.13, 0:25 PM5
6
INK RIBBON REPLACEMENT
1. Remove the paper roll from the calculator.
(Tear the paper and remove it from the print
mechanism by using .)
2. Turn the power off before replacing ribbon.
3. Remove the printer cover. (Fig. 1)
4. Remove the old ribbon by pulling it up.
5. Insert the new ribbon.
6. With the black side of the ribbon facing
upwards, place one of the reels on the reel
shaft on the right. (Fig. 2) Make sure that the
reel is securely in place.
7. Thread the ribbon around the outside of the
metal guides. (Fig. 3)
8. Take up any slack by manually turning one of
the reels.
9. Replace the printer cover. (Fig. 4)
10. Replace the paper roll.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
EL-2607PC(AGO)-Eng 03.11.13, 0:25 PM6
7
Never insert paper roll if torn. Doing so will
cause paper to jam.
Always cut leading edge with scissors first.
1) Insert the leading edge of the paper roll into the
opening. (Fig. 1)
2) Turn the power on and feed the paper by
pressing . (Fig. 2)
3) Insert the paper roll to the paper holder. (Fig. 3)
PAPER ROLL REPLACEMENT
Fig. 1
Fig. 2
Fig. 3
DO NOT PULL PAPER BACKWARDS AS THIS
MAY CAUSE DAMAGE TO PRINTING
MECHANISM.
EL-2607PC(AGO)-Eng 03.11.13, 0:25 PM7
8
There are several situations which will cause an
overflow or an error condition. When this occurs,
“E” will be displayed. The contents of the memory
at the time of the error are retained.
If an “0•E” is displayed at the time of the error,
must be used to clear the calculator. If an “E” with
any numerals except zero is displayed, the error
may be cleared with or and the calculation
can still be continued.
Also, in rare cases, printing may stop midway and
the indication “E” appear on the display. This is not
a malfunction but is caused when the calculator is
exposed to strong electromagnetic noise or static
electricity from an external source. Should this
occur, press the key and then repeat the
calculation from the beginning.
Error conditions:
1. Entry of more than 12 digits or 11 decimals.
This error can be cleared with or .
2. When the integer portion of an answer exceeds
12 digits.
ERRORS 3. When the integer portion of the contents of the
memory or grand total memory exceeds 12
digits.
(Ex. 999999999999 1 )
4. When any number is divided by zero.
(Ex. 5 0 )
EL-2607PC(AGO)-Eng 03.11.13, 0:25 PM8
Table des matières
Langues :
Autres manuels Sharp Calculatrice
Sharp
Sharp EL-2902E Manuel utilisateur
Sharp
Sharp Elsimate EL-337C Manuel utilisateur
Sharp
Sharp Elsimate EL-337C Manuel utilisateur
Sharp
Sharp ELSIMATE EL-371S Manuel utilisateur
Sharp
Sharp EL-520V Manuel utilisateur
Sharp
Sharp EL-2910R Manuel utilisateur
Sharp
Sharp COMPET PC-1001 Manuel utilisateur
Sharp
Sharp EL-334M Manuel utilisateur
Sharp
Sharp EL-T100A Manuel utilisateur
Sharp
Sharp EL-500W Manuel utilisateur
Sharp
Sharp COMPET CSA-2130 Manuel utilisateur
Sharp
Sharp EL-1607P Manuel utilisateur
Sharp
Sharp EL-364 BBK - El364bbk 12 Digit Slim Design Manuel utilisateur
Sharp
Sharp EL-344R Manuel utilisateur
Sharp
Sharp EL-2607RIII Manuel utilisateur
Sharp
Sharp CS-4194H Manuel utilisateur
Sharp
Sharp Elsi Mate EK-244T Manuel utilisateur
Sharp
Sharp WriteView EL-W531X Manuel utilisateur
Sharp
Sharp EL-9600 Manuel utilisateur
Sharp
Sharp EL-W506B Manuel utilisateur
