To remove the filter from the portafilter, reach either with your fingernails or with a thin, hard object between the filter
and portafilter and pry out the filter.
Filling the Filter With Coffee Powder
1.
Use the measuring spoon to pour the quantity of coffee powder you want into the desired filter in the portafilter (12).
One heaped measuring spoon is equivalent to roughly one filled small filter.
2.
Press down the coffee powder in the filter with the tamper.
Only ever use pure espresso / coffee powder which is not ground too fine. Coffee substitute or coffee extract contain
sticky substances which can block the sieves.
Inserting / Removing the Portafilter
1.
Insert the portafilter (12) into the device so that the two locking lugs on the portafilter sit in the recesses which are
provided for them on the device. Twist the portafilter anticlockwise to secure it (Picture C).
2.
To remove the portafilter from the device, turn it clockwise a little and then pull it out downwards.
3.
To remove the used coffee powder, tap the portafilter gently against an edge (e.g. of a dustbin, a bowl or similar object)
so that the compressed coffee powder can be released. Dispose of the coffee powder in an environmentally friendly
manner.
Cup Warmer
The device features a cup warmer (15) which is heated automatically as soon as the device is switched on. Turn over the
cups which are to be heated and place them on the cup warmer for approx. 5 – 10 minutes (Picture D).
Switch On
When the device is first switched on, the red control lamp (18) flashes and you will hear two beeps several times in
succession to indicate that the device is not yet ready for operation.
1.
Place a cup or a small vessel under the coffee outlet (14).
2.
Press any button. The device draws water and fills the water system with liquid. A small amount of water always runs
through here. The device is now ready for operation.
3.
Press the button (16) to switch on the device and preheat the water. The control panel flashes during the heating
process.
Programming Quantities
Both the quantity of espresso and the quantity of milk can be programmed for each function. This allows you to set
the perfect quantity of espresso and milk to suit your own taste.
The set quantities are saved until a new quantity is set.
Espresso, Double Espresso, Milk Froth
1.
Fill the device as if a speciality coffee is to be prepared
2.
If necessary, fold out the milk nozzle (8) using the lever (7) (Picture E).
3.
Place a suitable cup below the coffee outlet (14) or the milk nozzle.
4.
Select the function that is to be reprogrammed. Press the appropriate button (a beep sounds) and keep it held down
(another beep sounds).
5.
The device starts to prepare espresso or make milk froth.
6.
Only let go of the button once the quantity of milk or espresso that you want has passed through. You will hear three
beeps. This quantity is now saved under the corresponding function.
Cappuccino and Latte Macchiato
This process must be carried out twice for latte macchiato and cappuccino: Once for the quantity of espresso and once
for the quantity of milk:
1.
On the first operation, set the quantity of milk you want in the manner described in the previous section. Make sure
that the milk nozzle (8) is folded out and there is a cup below the milk nozzle.
2.
Start a second operation by pressing the appropriate button again. A beep sounds.
3.
Wait until the quantity of milk has passed through.
4.
As soon as the device starts to make espresso, press the appropriate button again and hold it down. Another beep
sounds.
5.
Only let go of the button again once the quantity of espresso that you want has passed through. You will hear three
