SH 075 MIDI Guitar Converter Owners Manual v.1
SHADOW ELECTRONICS
Installing SH 075 on your Guitar
1. Unscrew the strap button and place the unit on the guitar as shown (figure 1).
2. Reinstall the strap button screw through the converter bracket.
3. Mount the pickup under the strings as close to the bridge as possible using the
enclosed screws. OPTION: If you want to avoid screw holes, use the included
double sided adhesive tape.
IMPORTANT:
The end of the pickup with the cable must be under the low E string (No. 6). The
pickup should not be more than 1 mm to 1.5 mm (1/32" to 1/16") away from the
strings. The strings must run over the center of the magnetic pole pieces. This will
ensure accurate tracking. If there is not enough clearance between the body and
the strings to mount the pickup, then raise the bridge saddles and shim the neck
accordingly.
4. Plug the pickup into the converter as illustrated.
SH 075: Distribution Box:
1. SH 075 output (5 Pin DIN connector
13. Input for SH 075 cable (5 Pin DIN connector)
2. Guitar Input (mini phone)
14. Guitar Audio Output Jack
3. Synth Volume Control
15. Power Adaptor Input Connector
4. Dynamic Range Control
16. MIDI OUT Connector
5. Hex Pickup Input Connector
6. MONO/POLY Mode LED
7. Pitch BEND On/Off LED
8. MIDI ON/OFF LED
9. MODE Select Key
10. MIDI ON/OFF Key
11. String sensitivity Trim Pots
12. Numeric Key Pad
GUITAR INSTRUCTIONS Connecting The System
A.) Connect the 5 pin cable between SH 075 and the Distribution Box.
B.) Use the included phone to mini phone jumper cable to connect from SH 075 Guitar
Input (2) to your guitar's output.
C.) Connect a MIDI cable from Distribution Box (16) to the MIDI Input on your Synth.
D.) Using a shielded guitar cable, go from the Guitar Output (14) on the Distribution
Box to your amplifier's Guitar Input.
E.) Connect the Power adaptor to input 15 on the Distribution Box.
F.) Make sure the Power Adaptor voltage is correct (120VAC input, 9VDC output for
North America), then plug the adaptor into the wall.
If all is correct, the MIDI ON LED (8) will light and SH 075 is ready for use.
page 1
