Technical data - Hyperamp HA 1510 REV
Output: 1 VA an 4 / 8 Ohm (switchable) *
Speaker: 10’’ Jensen P10R 8 Ohm “SPECIAL DESIGN“
Power amplifier: Class A (2 x EL84)
Level indicator: EM84 (magic eye), at the front
Input1: Guitar socket 6,3 mm (mono), -10 dBu at 1 MOhm
Input2: XLR-socket, -30 dBu at 200 Ohm ***
Effects: parallel, with Level-(Reverb-) control **
DI-output: XLR with transformer (magnetically shielded)
Sound control: 3 bands
ontrols at the front: INPUT 1, INPUT 2, BASS, MIDDLE, TREBLE, VOLUME,
EFFECT/REVERB, Standby-switch, line-switch, operation
light
ontrols at the rear: Electric supply with fuse and replacement fuse, sockets
EFF RET and EFF SEND, XLR-socket DI OUT, socket for
ext. speaker EXTERN, socket for int. speaker INTERN,
Impedance switch 4 / 8 Ohm
Tube assembly: 1 x EZ81, 2 x EL84, 1 x ECC81, 2 x ECC83, 1 x EM84
Spring reverb: Accutronics, 3 springs (HA1 10REV only)
Dimensions (in mm): 484 x 480 x 260 mm
Weight: HA1 10: ~13, kg, HA1 10REV: ~14, kg
* Through a second speaker jack an external 8 Ohm speaker can be connected, the impedance switch
then has to be turned to 4 Ohm. In normal action without an additional speaker it is set to 8 Ohm.
** Applying the parallel effects loop the direct signal in the amp is mixed up with the effect's signal.
The disadvantage is that some effects are limited (e.g. distortion). The advantage is that the direct
signal is conducted to the power amplifier as the crow flies and therefore remains unaltered. With the
HA1 10REV the EFF/REV-control adjusts the amount of reverb. If an external effect-pedal is connected
to the EFFECT RETURN jack, the internal spring reverb is switched off.
*** This Input ( ) is silenced if a guitar plug is connected to Input (1).
