LED moduｌe is turned on by applying the rated voltage to the power cable of the product.
Inspection 1)
2) Prior to maintenance, be sure to turn off the power.
3) Carry out maintenance properly in accordance with the related law and regulations.
4) If a repair is needed, consult us.
1)
2) For disposal of the product, follow the regulations and rules of your local government.
When reordering, please let us know:
・Drawing or drawing No. for the delivered product
・Manufacturing lot number on the nameplate
1.
2. Prior to maintenance or inspection, be sure to turn off the power.
3. Confirm that the screws and bolts are fastened properly and tightly.
4. In the case of the stanchion type, be sure to provide a support at least 1500 mm above the bottom of the pole.
5. Can be used indoors and outdoors. However, it cannot be used in the following locations.
・Places where heat builds up, places with strong vibrations, places where corrosive gas is generated, places with constant high
temperature and humidity such as commercial bathrooms and saunas, places with constant low temperatures and condensation
such as freezers.
6. Cannot be used as a moving light.
7. In places where water is splashed, apply waterproof treatment to prevent water from entering the screw joint.
8.
9. The supply voltage variation should be within ±6% of the rating.
10. Close unused entries of the junctionl box with plugs (resin).
11. The ambient temperature should be within the range of -20°Cto +50°C. The use of the product out of this range may shorten
the service life.If the ambient temperature range is exceeded, the temperature protection function may dim the light.
The brightness will return to normal when the temperature returns to within the ambient temperature range.
12.
Be sure to ground the e uipment securely.
13. Prior to maintenance or inspection, be sure to turn off the power.
14. To prevent shortening of the service life and malfunction, avoid turning on the fitting in direct sunlight.
15. To avoid noise or malfunctioning, don't use a radio, television or wireless infrared remote control near the fitting.
16.
17.
18.
19.
20. Local replacement of lighting fixture parts such as the light source is not possible. Please contact our sales representative.
21. Do not look directly at the LED while it is lit. It can hurt your eyes.
Don’t open the front glass. The internal components such as the LED lamp become very hot. Don’t touch the LED lamp since a malfunction
or lighting failure might occur.
For white LED lamps, the luminescent color and brightness may vary with individual LEDs because of their nature. Also note that the rate
of attenuation with time varies with individual LED lamps.
How to Use
In cleaning the fitting, gently wipe with water or mild detergent. Don ’ t use thinner, benzene or alkaline detergent. Such
chemicals might cause discoloration or deterioration in uality and strength, resulting in a damage.
Disassembly and Disposal
If the above information is unavailable, give us any material showing the appearance of the product or details of the product specification
(dimensions, mounting interval, lamp type, etc.).
The product must be mounted on a sturdy wall surface or structure which is vibration-free and less susceptible to damage. Otherwise, it
might fall or be damaged.
For use in an unfavorable location (a very hot, cold or humid place or a place in which there is strong wind or vibration, a salt damage
environment or a dusty or corrosive gas atmosphere), a special countermeasure should be taken.
Please use e uipment installation within the installation range described in the range instruction manual. If the angle is out of the range,
an insulation failure or electric shock might result.
When installing the fitting, be sure to connect external wires inside a specified part of the fitting. Don't open any other part of the fitting
unless necessary.
In the period when the product is in use, never disassemble it.
Reordering
CAUTIONS
Fig.23
Nameplate
- 5 -
