SEIKAKU TECHNICAL GROUP RVC-100D Manuel utilisateur
RVC-100D
Remote Volume Control
1. Introduction
The RVC-100D is a professional and touch-sensitive volume controller, which
is flexible and easy to use. This volume controller can be assigned to any
output of the host. It can also route any input to any output like in the Matrix
menu of the Editor Software.
2. Summary of features
1)1 input.
2)1 link output.
3)LCD display the control in real time, also can control the MATRIX-A8
through the touch screen.
3.Ports and LCD display screen introduction
1) Input: Control signal input, connection to MATRIX A8 or RD-100EX. Cable
specifications: CAT-5 or higher shielded cable, the maximum cable length
is 100 meters.
2) Link: Control signal output, daisy connection for additional remote
controller. Cable specifications: CAT-5 or higher shielded cable, the maxi-
mum cable length is 100 meters.
3) Power input port, +24V Aux power input, it is needed when link two or
more RVC-100D.
134 2
- 1 -
4) LCD: it displays the connection status, ID number, volume, model,
channel selection and other information.
The installation diagram is as follows:
4. CAT-5 or higher shielded cable
- 2 -
5. Control interface introduction
1) RVC-100D main page
Connect the RD port of MATRIX-A8 to the In port of RVC-100D . After the
MATRIX-A8 has successfully recognized and connected to the RVC-100D,
the indicator on the lower left will flash, the device address MATRIX-A8
assigned to the RVC-100D also will be displayed.
You can enter four sub-pages respectively by click the corresponding
buttons on the main interface, namely "Output Setting" "Input Setting"
"Scene Setting" "System Setting".
2) RVC-100D sub-pages
- 3 -
- 4 -
a) Output Setting
You can adjust the output volume, mute and the changes of the output
volume can be seen through the volume indicator in this page;
You can switch the output channel by "left and right arrow", and "up and
down button" to switch the input channel;
Switch "ON" "OFF" to customize the input channel routing to the selected
output channel.
b) Input Setting
You can adjust the input volume, mute and the changes of the input volume
can be seen through the volume indicator in this page;
The input channel can be switched by "up and down button".
NF05198-1.0
- 5 -
c) Scene Setting
Click the "up and down button" to switch to the previous page or next scene,
and then click on the desired scene to load (The default scenes loaded in
this page are set and saved on the MATRIX-A8 software).
d) System Setting
It shows the device name in this page;
Device address that MATRIX-A8 assigned to RVC-100D and firmware version;
All pages can be switched to Chinese or English through "Chinese" "English"
button.
Table des matières
Manuels Télécommande populaires d'autres marques
Panasonic
Panasonic EUR7622KB0 Manuel utilisateur
Bang & Olufsen
Bang & Olufsen Beo4 Manuel utilisateur
Sunwave Tech.
Sunwave Tech. RemoteComm SRC-7000 Manuel utilisateur
Multiplex
Multiplex PROFI TX 9 Manuel utilisateur
One Remote
One Remote RMB4 Manuel utilisateur
FUTABA
FUTABA 9ZAP - PART2 Manuel utilisateur
