Sealey VS270 Manuel utilisateur
MULTI VOLTAGE GLOW PLUG TESTER
MODEL NO: VS270
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using tools.
9Maintain tester in good and clean condition for best and safest performance.
9Wear approved eye protection. A full range of personal safety equipment is available from your Sealey stockist.
9Wear suitable clothing to avoid snagging. DO NOT wear jewellery and tie back long hair.
9Account for all tools and parts being used and DO NOT leave any in or near the engine.
8DO NOT use tester if damaged.
9Vehicle should be in a well ventilated area.
IMPORTANT: These instructions are provided as a guide only. Always refer to the vehicle manufacturer’s service instructions, or a
proprietary manual, to establish the current procedure and data.
WARNING! The warnings referred to in this guide cannot cover all possible conditions and situations that may occur. It must be
understood that common sense and caution are factors which cannot be built into this product, but must be applied by the operator.
2. INTRODUCTION
Designed to test low voltage glow plug operation on modern diesel engines. Prevents glow plug damage caused by testing with the vehicle
battery. Glow plugs can be tested whist in situ. Supplied in storage case with instructions. Requires 9V battery (not supplied).
3. OPERATION
3.1. To t the battery remove rubber case, the battery compartment is located on the base of back of the unit.
3.2. MULTI VOLTAGE GLOW PLUG TESTER
3.2.1. Many modern diesel engines have low voltage glow plugs tted, this type of glow plug cannot be tested using the vehicle battery
voltage as damage may occur.
VS270 Issue 1 06/11/19
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear eye
protection
Wear protective
gloves
Wear safety
footwear
Wear protective
clothing
3.3. INITIALISATION
3.3.1. Before the tester is used for the rst time, or if any other type of test probe is used than the one supplied, the device will need to be
initialised as follows;
1. Fit the connection leads to the unit observing the polarity.(Remove dust caps and replace after use).
2. Connect the red probe to the black clip.
3. Press and hold the power button, the tester will count from 0 to 5, continue to hold until “Zero” is displayed.
4. The tester is now ready for use.
3.4. TESTING METHOD
1. Disconnect the electrical connection to the glow plug(s).
2. Connect the black earth lead to a clean ground connection on the vehicle.
3. Press the power button to switch on the tester.
4. Touch the red probe to the positive (+) terminal of the glow plug.
5. The tester will show the condition of the glow plug within a few seconds.
4. MAINTENANCE
9Keep tester clean and dry.
8DO NOT use if leads are damaged.
9Replace batteries as required.
g.1 g.2 g.3
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
BATTERY REMOVAL
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack
Sealey Ltd Batteries Producer Registration Number (BPRN) is BPRN00705.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Original Language Version
© Jack Sealey Limited VS270 Issue 1 06/11/19
Parts support is available for this product. Please email sales@sealey.co.uk or telephone 01284 757500
Table des matières
Autres manuels Sealey Équipement de test
Sealey
Sealey AUTO SERVICE VSE206 Manuel utilisateur
Sealey
Sealey BT2003.V4 Manuel utilisateur
Sealey
Sealey VS925 Manuel utilisateur
Sealey
Sealey BT102.V2 Manuel utilisateur
Sealey
Sealey VS001 Manuel utilisateur
Sealey
Sealey BT91/7.V3 Manuel utilisateur
Sealey
Sealey Auto Service TA111.V2 Manuel utilisateur
Sealey
Sealey GT117 Manuel utilisateur
Sealey
Sealey CV0011.V3 Manuel utilisateur
Sealey
Sealey VSE210 Manuel utilisateur
Sealey
Sealey VS0275 Manuel utilisateur
Sealey
Sealey TA120 Manuel utilisateur
Sealey
Sealey MC105 Manuel utilisateur
Sealey
Sealey BT91/7PF.V2 Manuel utilisateur
Sealey
Sealey TA301 Manuel utilisateur
Sealey
Sealey BT103 Manuel utilisateur
Sealey
Sealey HBS97.V2 Manuel utilisateur
Sealey
Sealey Auto Service Line TA131 Manuel utilisateur
Sealey
Sealey VS4021 Manuel utilisateur
Sealey
Sealey Auto Service Line VS2030 Manuel utilisateur
Manuels Équipement de test populaires d'autres marques
SMART
SMART KANAAD SBT XTREME 3G Series Manuel utilisateur
Agilent Technologies
Agilent Technologies BERT Serial Manuel utilisateur
Agilent Technologies
Agilent Technologies N3280A Manuel utilisateur
Vernier
Vernier Go Direct Voltage Manuel utilisateur
Lifeloc
Lifeloc R.A.D.A.R. Manuel utilisateur
Fluke
Fluke T5-600 Instructions d'utilisation et d'installation
