SCS S-3 Manuel utilisateur
www.scssa.co.za
SCS S-3
1.Installation
..............................................................................................................1
2.Outlook / Function
................................................ ..........................................................2-3
3.Device Pairing
...........................................................................................................4-5
4.Group Intercom Mode Pairing (Operating Scenario)
.........................................................................................................6-11
5.Q&A / Warning
.......................................................................................................12-13
Contents:
01
1.Installation
Get Headset base out
Fix Headset in the suitable position ,
hide the speaker cable
Install S-3:Push S-3 to the base ,
the clip will lock S-3 automatically
To Release S-3:Press the right side release
button , pull S-3 up at the same time
Plug in the microphone cable
Remark:Please make sure the mic is close to user’s mouth and speaker close to user’s ears .
Utilise the provided foam spacers to position speakers closer to ears.
12
3
4
5
02
2. Setup / Function
2.1 Setup
Next
lndicator Light
Previous
AUX ln
Function Button
(Roll left - Volume +,
right - Volume -)
Remote
Control
Indicator
lntercom Button
Headset/Microphone
Jack
03
2.2 Function
Switch On / OFF
Cellphone Function
Power Detect & Notification Function
Remote Control
Stand By:After S-3 switch on , remote
controller stay in pairing mode , RC indicator
off.Connect:After pair up with S-3 , RC
indicator flash quickly 3 times , and then starts
flash slowly .Receive:RC indicator flash 1 time
after it receive any button signal .
Voice Command
FM Function
Memory Clean
Switch On:Short press Next button twice
Switch Off:Long press Next button for 1 second .
Volume Up :When FM on ,roll volume + .
Volume Down :When FM on , roll volume - .
Search Previous:When Fm on , short press previous .
Search Next:When Fm on , short press Next.
Push function button and previous button at the same
time when switch on . After you hear voice prompt , the
indicator will flash between blue and red , then the pairing
memory will be cleaned up .
When your S-3 is paired up , short press function button
once , will automatically switch on the voice command
function .
*Cellphone must equipped with this function .
Intercom Function
Answering Call:Short press function once .
Hangup Call:After call , short press function
once .Refuse Call:Long press function button
for 2 seconds .Redial:Short press function
button twice .Volume Up:Roll Volume + while
talking .Volume Down:Roll Volume - while
talking .
Power Detect Function:S-3 has power detect
function , when device is on , short press
previous and next button at the same time ,
recorded voice message will tell you :
Power over 90%
Power over 50%
Power lower than 50%
Power lower than 10%
please recharge immediately
Music Function
Switch On:When device is off , press
intercom+function at same time for 3 seconds .
Switch Off:When device is on , press
intercom+function at same time for 3 seconds .
*For first time use , please recharge the device
until the red light is off .
Play:When device is on , short press Previous twice .
Pause:When music is playing , short press Previous twice .
Volume Up :When music playing ,roll volume + once .
Volume Down :When music playing , roll volume - once .
Play Previous:When music playing ,short press previous .
Play Next:When music playing ,short press Next .
Switch Intercom On:When device on , short press intercom
button once .Switch intercom off:When talking , short press
intercom button once .Volume Up:When talking , roll
Volume + once .Volume Down:When talking , roll
volume - once .
04
3.1 Pair Up to Bluetooth Devices
3.1.1 Pairing Mode
3.1.2 Search Mode
Step 1
When device is on .
Long press function button
Pairing mode , red and blue light flash quickly ,
voice message says pairing .
Step 2
Step 1
When device is on .
Long press intercom button
Search Mode , Red and blue lights flash slowly
Step 2
3.Device Pairing
05
3.2 Pairing With Cellphone
Radio
(Requires 2.5mm to 3.5mm Aux cable)
S-3 equipped with wire connecting function .
Only needs to plug in 2.5mm to 3.5mm aux in cable or radio professional connect cable ,
the wire connecting function will be switch on .
06
4.Group Intercom Mode Pairing
(Operating Scenario)
4.1 Operating Scenario 1:One person use ,
pair to cellphone + Bluetooth GPS device
+ Bluetooth speed detector
Step 1
Step 2
Step 3
At first of all , pair up GPS and cellphone
Pair up S-3 with GPS , after paired , please switch off the Bluetooth function in GPS
Lastly , pair up S-3 with speed detector , after paired , switch on GPS Bluetooth function
07
2:Two person intercom , and pairing to
cellphone + Bluetooth GPS + radio
4.2 Operating Scenario
Pairing Procedure:
Step 1:Switch A to search mode (details to 3.1.2), B to pairing mode(details to 3.1.1) .
when both headset stop blue and red light flashes , they are paired .
Step 2:Switch A to pairing mode (details to 3.1.1 ) , cellphone search this A and pair it up .
Step 3:Keep A in pairing mode(details to 3.1.1 ) , use Bluetooth GPS to search A and pair it up .
Step 4:Use 2.5mm to 3.5mm AUX in cable to connect radio to S-3 ,
S-3 wire connecting function switch on , all audio inter-grade are completed .
*Switch on intercom , both A and B can hear audio from GPS , speed detector or radio .
if A gets an incoming call , device will cut off the intercom .when A’s call is finished ,
device will reconnect automatically .
Rider A
Cellphone
Rider A - S-3 Rider A - S-3
Rider A`s GPS Radio
08
3:Two person intercom , rider A use cellphone +
Bluetooth GPS , rider B use Bluetooth speed detector .
Pairing Procedure:
Step 1:Switch A to search mode (details to 3.1.2) , B to pairing mode (details to 3.1.1) .
when both headset stop blue and red light flashes , they are paired .
at same time instantly switch intercom .
Step 2:Switch A to pairing mode (details to 3.1.1) , cellphone search this S-3 and pair it up .
Step 3:Keep A in pairing mode(details to 3.1.1) , use Bluetooth GPS to search A and pair it up .
Step 4:Set B to pairing mode(details to 3.1.1) , use Bluetooth speed detector to search B and pair up .
*When both headsets are switched off , and A or B want to reconnect , please press
A’s intercom button to reconnect and will be able to share all audio source again .
Rider A
Cellphone
Rider A S-3 Rider A S-3
Rider A GPS Rider B Speedometer
4.3 Operating Scenario
Table des matières
Manuels Accessoires pour motos populaires d'autres marques
SRC
SRC B-TRK502-01-01-SL Manuel utilisateur
3M
3M Speedglas 9100 MP Manuel utilisateur
hepco & becker
hepco & becker 6307520 00 01 Manuel utilisateur
HOMCOM
HOMCOM AA0-077 Manuel utilisateur
hepco & becker
hepco & becker 6307558 00 01 Manuel utilisateur
Wunderkind Custom
Wunderkind Custom 106503-F15 Guide de l'utilisateur
