Saxby Lighting Scoop Rectangular Recessed Manuel

Scoop Rectangular

Recessed

78542

Instruction leaflet

Care and Safety

• We recommend cleaning with a soft dry cloth. Do not use solvents or abrasive cleaners as these could damage

the finish.

• For your safety, always switch off the supply before cleaning.

Iss1 29/10/2018

WWW.saxbylighting.com Saxby lighting. BH23 3PE

Wiring

Check that...

You have correctly identified the wires.

•

The connections are tight.

• No loose strands have been left out of the connection

block.

Having correctly identified the wiring from your existing

light fitting, pull the wire through the hole and connect

to the connection block inside the LED driver in the

following way:

This unit is double insulated and must not be earthed. If

there are any incoming earth cables, they must be joined

together and well insulated with good quality insulation

tape. This is to ensure earth continuity throughout your

property.

Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and

satisfactory operation of this product. Please retain these instructions for future reference.

Warning

Technical data

Please read these instructions carefully before

commencing any work.

This system contains non-replaceable parts and

cannot be serviced. If damage occurs the part

shouldbe scrapped.

The external flexible cable or cord of this luminaire

cannot be replaced . if the cord is damaged, the

luminaire must be destroyed.

This unit must be fitted by a competent and

qualified electrician.

Check the pack and make sure you have all of the

parts listed.

To prevent electrocution switch off at mains supply

This light fitting must be connected to a fused circuit.

before installing or maintaining this fitting.

Ensure other persons cannot restore the electrical

supply without your knowledge.

Install in accordance with IEE Wiring regulations

and current Building Regulations.

Supply

Bulb Type:

Voltage: 240 V~, 50 Hz

LED (35W) COB / 4000K

The light source of this luminaire is not replaceable; when the light source reaches its end of life

the whole luminaire shall be replaced.

Conformity with all relevant EC Directive requirements.

Waste electrical products should not be disposed of with household waste.

Please recycle where facilities exist.Check with your Local Authority or

local store for recycling advice.

Luminaires not suitable for covering with thermally insulating material.

The power supply is Double Insulated and does not require connection to an Earth circuit.

Minimum distance from lighted objects (0.5 metres)

Installation

Existing fittings must be completely removed before installation of a new product. Before removing the

existing fitting, carefully note the position of each set of wires.

• The ceiling surface must be flat and smooth to ensure a good fit.

• Note that the power needs to be isolated/switched off at the fuse board.

• Plan the desired layout of these fittings carefully, ensuring the cables will reach the distances between

the LED Driver and each light fitting. Ensure that there is adequate ventilation for theLED Driver.

•Cut a mounting hole 13 x 22cm in the ceiling taking care not to foul any pipes, mains cables or

joists beneath the surface.

Fig 1. (Recessed) Fig 2. (Wall)

•It is always recommended to cut the hole slightly smaller than the size specified, and then file the hole

until the recessed unit fits snugly.

•Push the spring clips upwards and fit into the ceiling hole, then push the unit up until firmly in position,

ensuring that no cables are trapped.

•Ensure that the product is sitting properly in the hole.

•It can also be used as a wall light, using the supplied screws to mount the light on the wall. See Fig 2.

•Switch on. Your light is now ready for use.

See wiring

• The minimum ceiling void depth is 90mm. when more than one downlight is installed, the minimum

distance between units is 500mm. the unit must be located a minimum distance of 50mm from a joist.

IP20

0,5

If replacing an existing fitting, make a careful note

of the connections.

13 X 22cm

As a wall light, it is recommended

to stick the drive on the back

of the product.

Ce manuel convient aux modèles suivants

Autres manuels Saxby Lighting Équipement d'éclairage

Saxby Lighting

Saxby Lighting 13889 Manuel utilisateur

Saxby Lighting

Saxby Lighting Tango Manuel utilisateur

Saxby Lighting

Saxby Lighting 1818PIR Manuel

Saxby Lighting

Saxby Lighting Sight ECO Manuel utilisateur

Saxby Lighting

Saxby Lighting SIGHTPRO 108087 Manuel utilisateur

Saxby Lighting

Saxby Lighting 43810 Manuel

Saxby Lighting

Saxby Lighting Axial Rectangular Manuel utilisateur

Saxby Lighting

Saxby Lighting Regen Manuel

Saxby Lighting

Saxby Lighting Sight Plus 72638 Manuel

Saxby Lighting

Saxby Lighting 73666 Manuel

Saxby Lighting

Saxby Lighting HeroPro CCT Microwave Emergency Manuel utilisateur

Saxby Lighting

Saxby Lighting Kios 2 Manuel utilisateur

Saxby Lighting

Saxby Lighting Picco Manuel utilisateur

Saxby Lighting

Saxby Lighting Severus CCT Manuel utilisateur

Saxby Lighting

Saxby Lighting SHIELDPRO CCT 90376 Manuel utilisateur

Saxby Lighting

Saxby Lighting Reeve Connect Batten Series Manuel

Saxby Lighting

Saxby Lighting E27 LED GLS Manuel

Saxby Lighting

Saxby Lighting Lucca Wall 67176 Manuel

Saxby Lighting

Saxby Lighting 76768 Manuel

Saxby Lighting

Saxby Lighting Sight Twin Spot Manuel

Saxby Lighting

Saxby Lighting 101626 Manuel utilisateur

Saxby Lighting

Saxby Lighting EL-20079 Manuel

Saxby Lighting

Saxby Lighting 78965 Manuel utilisateur

Saxby Lighting

Saxby Lighting Sight Twin Spot Manuel

Manuels Équipement d'éclairage populaires d'autres marques

Brizo

Brizo 8SP-MU-4 Manuel utilisateur

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuel utilisateur

IKEA

IKEA BJÖRKSPIREA Manuel utilisateur

Laserworld

Laserworld Evolution Series ES-400RGB Manuel utilisateur

Alien

Alien RG STAR Manuel utilisateur

EuroLite

EuroLite LED B-40 Manuel utilisateur

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuel utilisateur

Commercial Electric

Commercial Electric 54568141 Manuel utilisateur

CREE LIGHTING

CREE LIGHTING 304 Series Manuel utilisateur

Goobay

Goobay 49867 Manuel utilisateur

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuel utilisateur

Alkalite

Alkalite Krypton KT-81 Manuel utilisateur

Clas Ohlson

Clas Ohlson GU10 Manuel utilisateur

DTS

DTS DELTA 10 F Manuel utilisateur

ring

ring Solar Steplight Manuel utilisateur

One Stop Gardens

One Stop Gardens 57696 Instructions de montage

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuel utilisateur

SIREM

SIREM Swimeo A2 Manuel utilisateur