Saxby Lighting Flexline Kit Manuel

Instruction leaflet

Flexline Kit

52305, 52306

Waste electrical products should not be disposed of with household waste. Please recycle where facilities

exist. Check with your Local Authority or retailer for recycling advice.

Recycling advice

Commissioning

place.

V2 16/04/2021

WWW.saxbylighting.com Saxby lighting. BH17 7BY

For your safety, always switch off the power supply before changing lightbulbs, or cleaning.

Safety information

Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and

satisfactory operation of this product. Please retain these instructions for future reference.

Warning

The power supply is Double Insulated and does not

require connection to an Earth circuit.

The LED strips are Safety Extra Low Voltage and

must not be earthed.

Please read these instructions carefully before

commencing any work.

This unit must be fitted by a competent and qualified

electrician.

Install in accordance with IEE Wiring regulations and

current Building Regulations.

This system operates at Safety Extra Low Voltage

(12V), via a LED driver. Never connect the light fittings

directly to the mains without using a LED driver.

Ensure that the supplied LED driver is used.

The mains plug must be situated indoors (e.g. house,

garage, shed) in order to protect it from the elements.

Do not exceed the LED driver load. LED drivers may

require a minimum load to operate.

Always disconnect the LED driver from the mains

when installing or maintaining this system.

This system contains non-replaceable parts and

cannot be serviced. If damage occurs the part should

be scrapped.

This product cannot be dimmed.

This product is rated at IP20

Waste electrical products should not be disposed of

with household waste. Please recycle where facilities

exist. Check with your local authority or retailer for

recycling advice.

Specification

Dimensions : 8.0mm wide, 2.5mm high, 5m long

Voltage : 240V ~ 50Hz

LED Voltage : 12V d.c.

Lumens : 1260 lm

Layout

which can be stuck to most surfaces.

of 100mm or multiples of 100mm.

ensuring the cables will reach the distance between

the power supply and the Flexline LED position.

cause a hazard. Position cables and Flexline LED's

away from areas where they may be at risk from

being cut, trapped or damaged.

conduit or plastic trunking.

Basic Installation

Specification

The Kit should contain:

indoor mains outlet socket that the system will

connect to. Do not plug-in at this stage.

ensure that the cable can reach when in the desired

position.

lengths, by unplugging the four pin connectors. To

shorten the flexline to a specific length, then it can

be done in multiples of 100mm. Look for the line on

the strip with four copper pads, as shown below.

anywhere else on the strip as this will cause the

Flexline strip to stop working. Please note that once

cut, these strips can only be rejoined by soldering.

connector on the Flexline strip observing the correct

polarity (align arrows as shown below).

Ce manuel convient aux modèles suivants

Autres manuels Saxby Lighting Équipement d'éclairage

Saxby Lighting

Saxby Lighting 48700 Manuel

Saxby Lighting

Saxby Lighting Hero CCT Manuel utilisateur

Saxby Lighting

Saxby Lighting Lucca Wall 67176 Manuel

Saxby Lighting

Saxby Lighting Odyssey Spike Manuel

Saxby Lighting

Saxby Lighting HeroPro CCT Microwave Emergency Manuel utilisateur

Saxby Lighting

Saxby Lighting Odyssey Bollards ST501228 Manuel utilisateur

Saxby Lighting

Saxby Lighting 75145 Manuel

Saxby Lighting

Saxby Lighting 73666 Manuel

Saxby Lighting

Saxby Lighting Kios 2 Manuel utilisateur

Saxby Lighting

Saxby Lighting Odyssey 78667 Manuel utilisateur

Saxby Lighting

Saxby Lighting 13929 Manuel utilisateur

Saxby Lighting

Saxby Lighting Axial Rectangular Manuel utilisateur

Saxby Lighting

Saxby Lighting Surge PIR Manuel

Saxby Lighting

Saxby Lighting Regen Manuel

Saxby Lighting

Saxby Lighting Aqualine Kit Manuel

Saxby Lighting

Saxby Lighting EL-20079 Manuel

Saxby Lighting

Saxby Lighting Tribeca Wall Manuel

Saxby Lighting

Saxby Lighting 75922 Manuel

Saxby Lighting

Saxby Lighting 13801 Manuel utilisateur

Saxby Lighting

Saxby Lighting Sight Twin Spot Manuel

Saxby Lighting

Saxby Lighting Louvre Photocell Manuel utilisateur

Saxby Lighting

Saxby Lighting 81572 Manuel utilisateur

Saxby Lighting

Saxby Lighting Reeve 2 Manuel

Saxby Lighting

Saxby Lighting E27 LED GLS Manuel

Manuels Équipement d'éclairage populaires d'autres marques

Brizo

Brizo 8SP-MU-4 Manuel utilisateur

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuel utilisateur

IKEA

IKEA BJÖRKSPIREA Manuel utilisateur

Laserworld

Laserworld Evolution Series ES-400RGB Manuel utilisateur

Alien

Alien RG STAR Manuel utilisateur

EuroLite

EuroLite LED B-40 Manuel utilisateur

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuel utilisateur

Commercial Electric

Commercial Electric 54568141 Manuel utilisateur

CREE LIGHTING

CREE LIGHTING 304 Series Manuel utilisateur

Goobay

Goobay 49867 Manuel utilisateur

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuel utilisateur

Alkalite

Alkalite Krypton KT-81 Manuel utilisateur

Clas Ohlson

Clas Ohlson GU10 Manuel utilisateur

DTS

DTS DELTA 10 F Manuel utilisateur

ring

ring Solar Steplight Manuel utilisateur

One Stop Gardens

One Stop Gardens 57696 Instructions de montage

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuel utilisateur

SIREM

SIREM Swimeo A2 Manuel utilisateur