satron VOA Manuel utilisateur
SATRON VOA / VOM
QUICK START GUIDE
Contents:
Installation requirements
Electrical requirements
Calibration Procedures
Electrical connections:
N0T housing
(Same for NRT)
B0T housing
M12 Connector 2
2nd 4…20mA loop
3x digital input
3x digital output
M12 Connector 1
Power 24VDC 250mA
Turbidity 4…20mA
active loop
H0T housing
L0V housing
Cable to probe
PIN 7, 8 & 9
Power 24VDC 250mA
Turbidity 4…20mA
active loop
Electrical requirements:
24VDC 250mA
Cross section of wire 0.34mm2
Housing: B0T, H0T, HRT, N0T, NRT:
Housing: L0V:
Analog output signal according to NAMUR NE 043:
Installation requirements VOAxxxxxxxxxxG1
Mounting recommendations:
• Minimum pipe diameter: 38mm (1.5”)
• Process connection direction:
Vertical: upwards flow with leak detection port facing down.
Horizontal: on the bottom or side with leak detection port facing down.
• Cable entry direction: from below
Installing 45/G1" Hygienic Welding adapter M548101, refer to datasheet for welding instructions.
Tightening torque: 60 +/- 20 Nm
Replacement o-ring 17x20mm EPDM/FPM/FFPM
Do not put sealing tape or paste on the threaded connection.
VO sensor
G1” Thread
M548101
45.5mm = 1.79”
Installation requirements for Clamp connection: VOA xxxxxxxxxxTA / TB / TN
Mounting recommendations:
Tri-Clamp connections are hygienic and easy to install but they can trap air that can cause a malfunction.
•Distance from sensor lens to inner pipe wall should be kept to a minimum “d1”
• Minimum pipe diameter: 38mm (1.5”)
• Process connection direction:
Vertical: upwards flow
Horizontal: on the side
• Cable entry direction: from below
d1
VO sensor
Tri-Clamp
Process valve, in this example 30.6%
Press Esc to skip 20mA.
Press Esc to skip 4mA.
2 point calibration:
Ce manuel convient aux modèles suivants
1
Autres manuels satron Accessoires
