2
Replacing Battery
When the batteries are insufficient, the following phenomenon occurs. Replace batteries immediately.
⚫The display dims.
⚫The volume of sound gets smaller or buzzer does not sound at all.
⚫Sensor does not work (the timer does not start even if put a hand over the sensor)
(1) Open the battery compartment lid.
(2) Remove the used batteries.
(3) Load new batteries with the right polarity (+ and -).
(4) Close the battery compartment lid.
·Always use new and the same type of batteries for a
battery replacement.
·The preset battery may not last long since it was installed
for a monitoring purpose.
·Do not dispose of exhausted batteries in a fire.
·For environmental conservation, dispose of used batteries in compliance with local rules and regulations.
Warnings
This model is not waterproof. Be sure to put the unit at the place never splashing water
Do not solder, short-circuit, disassemble, heat or fire a battery to avoid an exothermic heat, a leakage of battery fluid or
an explosion.
If the leaked fluid is spilt on your clothes or your skin, wash it off with water and if it gets into your eyes, wash it off
with clean water and seek a medical attention immediately.
Batteries pose a danger of suffocation or poisoning if swallowed. Keep batteries out of reach of children.
When disposing or storing a battery, seal the battery terminals with a tape to keep away from a direct contact with metals
and other batteries since the contact might cause an explosion or damage.
For environment conservation, dispose used batteries in compliance with local rules and regulations.
Specifications
Cat. No. : 1707-20
Name : Countdown Timer
Model : TM-27
Material of Main body : ABS resin
Power Requirements : “AAA”size manganese battery x 3 pcs.
Battery life : Approx. one year (in use of 20 times per day)
Dimensions : 114 (W) x 62 (H) x 24 mm (D)
Weight : approx. 110 g (including batteries)
3-4 Kanda-kajicho, Chiyoda-ku, Tokyo 101-0045 Japan
https://www.sksato.co.jp/en/ Q.06
