Installation Procedures
Installation Method One (Recommended)
1. Dismantle the old bidet seat and lid.
Loosen the hinge and remove the old bidet seat and lid.
Keep this side with FRONT up
Installation
template *Butterfly nuts are only used for
the optional installation method two.
Installation template
Installation template
Installation Method Two
1. Dismantle the old bidet seat and lid, and place the installation template on the ceramic, as described in step 1 and step 3 of the
installation method one.
2. Put the adapter plate over the toilet seat’s mounting holes in the ceramic of the connecting bolts with adjusting pieces. Screw the nuts
from underneath the toilet. Then tighten them to secure the adapter plate. Refer to the step 4 of the installation method one.
3. Complete the following installation procedures, as described in step 5 and step 6 of the installation method one.
2. Install the expansion nuts.
Insert the expansion nuts into the holes of the ceramic. Be
sure to firmly press down so the top of the expansion nut is
flush with the ceramic toilet surface.
3. Install the installation template.
4. Fix the adaptable panel.
Attach the adapter plate. Attach the adapter plate in the toilet
seat holes. Adjust the connecting bolts’ and adjusting pieces’
position to line up the connecting bolts to the expansion nuts.
Then tighten them to secure the adapter plate.
5. Remove the installation template. 6. Mount the Saniwise Bidet Seat.
Keep the fixing slots under the Saniwise Bidet Seat aiming
at the slots on the adaptable panel. Push the Saniwise Bidet
Seat to the end. Now, the Saniwise Bidet Seat is installed
successfully.
Fixing slots under the
Saniwise Bidet Seat
Bidet seat and lid
Place the installation template on the ceramic.
