Sangean PR-D3L Manuel utilisateur

All manuals and user guides at all-guides.com

all-guides.com

1. Read and understand all safety and operating instructions before

the radio is operated.

2. Retain instructions: The safety and operating instructions should

be retained for future reference.

3. Heed warnings. All warnings on the appliance and operating

instructions should be followed.

4. Follow all operations and use instructions.

5. Water and Moisture: The appliance should not be used near

water.Do not use near a bathtub,washbowl, laundry tub,

kitchen sink,wet basement,swimming pool,etc.

6. Unplug the radio from the AC power outlet before cleaning. Use only

a damp cloth for cleaning the exterior of the radio.

7. Do not place the radio on an unstable cart,stand,bracket or

table. The radio may fall,causing serious personal injury and

damage to the radio.

8. Ventilation:This radio should be situated so that its location or

position does not interfere with its proper ventilation. For

example,the radio should not be used on a bed,sofa,rug or

other soft surfaces that may block the ventilation openings.

It should not be placed in a built-in situation like a cabinet that

May reduce air flow through the ventilation openings.

9. Power sources:The radio should be operated only from the type

of power source indicated on the marking label. If you are not

sure of the type of power supply to you home,consult your radio

dealer of power company.

IMPORTANT SAFETY INSTRUCTIONS

All manuals and user guides at all-guides.com

10.Power cords:The power cord should be positioned so it is not

walked on,pinched,or items placed on top of it.Pay particular

attention to cords at plugs,convenience receptacles,and the

point where they exit from the unit.Unplug the power cord by

gripping the power plug,not the cord.Operate the radio using

only the correct type of power source indicated.If you are not

sure of the type of power supply to you home,consult you

dealer or local power company.

11.Do not overload wall outlets or extension cords.The can result

in a risk of fire or electrical shock.Never insert objects of any

kind into the radio through openings.

the objects may touch dangerous voltage points or short out

Parts.This could cause a fire or electrical shock.

12.If the radio is left unattened and unused for long periods of

time,unplug it from the wall outlet.This will prevent damage

caused by lightning or power line surges.

13.If the radio is left unattended and unused for long periods of

time,remove the batteries.The batteries may leak and damage

furniture or your radio.

14.Do not attempt to service the receiver yourself.Removing the

cover may expose you to dangerous voltage,and will void the

warranty.Refer all servicing to authorized service personnel.

15.Object and Liquid Entry-Never push objects of any kind into

this radio through openings as they may touch dangerous

voltage points or short-out parts that could result in a fire or

electric shock.Never spill liquid of any kind on the product.

16.The appliance should be serviced by qualified service

personnel when:

A:The power supply cord or the plug has been damaged.

B:Objects have fallen or liquid has been spilled into the radio.

C:The radio has been exposed to rain or water.

D:The radio dose not appear to operate normally or exhibits a

Marked change in performance.

E:The radio has been dropped,or the enclosure damaged.

All manuals and user guides at all-guides.com

TelescopicAerial

Power on/off

Preset buttons 1-5

Alarm On LED indicator

Alarm Set

Alarm mode set

Display

Wave band selection and time set button

Light button

Display button(clock/alarm time/radio frequency)

Sleep button

Treble/Bass Tonecontrol

Tuning up/down

Rotary running

Lock switch

Volume control

Earphones jack

Battery Compartment

AC socket

RESET button

Battery level indicator

Real time symbol

Sleep indicator

Snooze symbol

Memory/Sleep timer time

Frequency unit

Key lock indicator

Tuning indicator

Frequency and clock

Alarm status indicator

Wave band

AM/PM indicator

CONTROL LOCATIONS

DISPLAY INFORMATION

12 13

All manuals and user guides at all-guides.com

MAXMAX MINMIN

DISPLAY

MANUAL / AUTO SEEK

BAND

BASSTREBLE

POWER

ON/OFF

1122334455

MODE

TUNING

TUNTUN

FM MW

-ALARM-

MHZ

KHZ

All manuals and user guides at all-guides.com

This radio can be operated using:4 Alkaline UM-1(D size)

batteries AC power (230V/50Hz)

(1) Position the radio face down.

(2) Press the catch and pull out the cover of battery compartment.

(3) Insert 4 UM-1(D size)batteries.

(4) Replace the battery cover.

The battery indicator will display the battery level for

approximately 7 seconds after radio is switched on. The battery

indicator will show when the battery in full power level.

when Display battery indicator shows ,the batteries

should be replaced. After removing the batteries, you have

approximately 3 minutes to replace the batteries after which

clock and memory information will be lost.

Before plug the AC cord into Ac socket, make sure the AC

voltage is 230V AC/50Hz.

The AC cord should be disconnected from the mains supply

when not in use

The clock will start running when the batteries are installed or

AC power is plugged in.The display will show 0:00 and real

time symbol ' '.

CHOOSING A POWER SUPPLY

INSTALLING BATTERIES

BATTERY REPLACEMENT

USING THE AC LINE-IN

SETTING THE CLOCK

All manuals and user guides at all-guides.com

all-guides.com

(1) The real time can be set while radio is off.

(2) Press Time Set button,the HOUR digits wil flash,press

Tuning Up/Down to adjust the required hour time.

(3) Press Time Set button again,the MINUTE digits will flash,

press Tuning Up/Down button again to adjust the required

minute time.

(4) Press Time Set button again to complete time setting.

(1) Alarm time can be set while radio is on or off.

(2) Press and hold Alarm Set button for more than 2 seconds

until Hour digit and alarm symbol flash.

(3) Press Alarm Mode button to change the alarm mode to alarm

by radio(Display shows -ALARM )or alarm by buzzer

(Display shouw ALARM-).

(4) Press Time Set button and same procedures to set real time

to set alarm time.

(5) To cancel the Alarm set,press and hold Alarm SET button for

more than 2 seconds until alarm symbol disappears.

When alarm is on,Alarm on LED will flash.Press POWER

button to turn it off for 24 hours.alarm will last for one hour if

not turned off by pushing the POWER button.

(1) Select the Radio Alarm mode by pressing alarm mode button.

(2) If radio alarm is selected,when the alarm is on,the radio will

play the last station selected.

REAL TIME SETTING

ALARM TIME SETTING

ALARM ON

RADIO ALARM

All manuals and user guides at all-guides.com

HWS ALARM

SNOOZE

RADIO OPERTION

WAVEBAND SELECTION

A repeating beep tone will sound when using HWS alarm.The

alarm beep will increase in volume every 15 seconds for one

minute followed by 1 minute silence before repeating the cycle.

The HWS alarm will sound for one hour unless turned off by

pressing the POWER button.

When the alarm is on,press any buttons except POWER button,

the alarm will be in Snooze function for an interval of 5 minutes

before pressing POWER button to turn it off.Display will flash

Snooze symbol and alarm status.

There are three wavebands in PR-D3L unit

Waveband Frequency Aerial Type

FM 87.5-108 MHz Telescopic

Fully extend the aerial,

angle and rotate for best

Reception.

MW 522-1710KHz Internal

Rotate for bestreception.

LW 144-279KHz same as MW

There are 4 different available tuning methods:

Manual tuning,Rotary tuning,Scan tuning and Memory recall

tuning.

All manuals and user guides at all-guides.com

(1) Press Power button to turn on the radio.

(2) Select waveband by pressing Wave Band selector.

(3) Asingle press on the either Tuning Up or Down button will

change the frequency up or down for MW,LW and FM bands.

Note: Each press of the Tuning Up or Down button will change

the frequency in increment of

FM 100KHz

MW 9KHz

LW 9KHz

Rotate tuning knob will change FM,MW and LWbands frequency.

FM 50KHz

MW 9KHz

LW 9KHz

(1) Turn on the radio by pressing POWER button.

(2) Select a waveband.

(3) Press and hold down either Tuning Up or Down button for

more than 0.5 second to commence scan tuning.The radio

will scan and stop automatically each time it finds an active

station.

(4) When the waveband end is reached,the radio will beep and

continue tuning from the opposite waveband end.

MANUAL TUNING

ROTARYTUNING

SCAN TUNING

All manuals and user guides at all-guides.com

MEMORYTUNING

RECALL ASTATION FROM PRESET MEMORY

SLEEP FUNCTION (AUTO SHUT-OFF)

LIGHT

There are 5 memory presets for each waveband.

(1) Tune to the desired frequency or channel using one of the

previously described tuning methods.

(2) Press any desired PRESET button and hold down for 2

seconds.

The Display will show the preset number and M will flash and

stop with a beep sound indicating the radio station has been

stored.

(1) Select the required waveband.

(2) Press any of the PRESET button you required for.

The radio will instantly tune to the station and the Display will

show its frequency and memory location.

Press Sleep button, the indicator and 90 minutes

appear on the display, keep pressing the button until the desired

sleep time from 90 to 15 minutes appears on the display.

Release button whenever the sleep time shown on the

display is acceptable to you.

To cancel the sleep function, simply press Power On/Off button.

If the radio is operated by Ac power as long as the radio is

turned on, the display illumination will be always on unless you

press the LIGHT button to turn it off.

However if you use batteries as radio power,whenever you

need display illumination,press LIGHT button.Illumination will

turn off automatically 2 minutes after radio operations are

completed or you may turn it off by pressing the LIGHT button.

All manuals and user guides at all-guides.com

Autres manuels pour PR-D3L

Table des matières

Autres manuels Sangean Radio

Sangean

Sangean WFT-2D Manuel utilisateur

Sangean

Sangean PR-D3 Manuel utilisateur

Sangean

Sangean dpr-39 Manuel utilisateur

Sangean

Sangean HDR-1 Manuel utilisateur

Sangean

Sangean SR-25 Manuel utilisateur

Sangean

Sangean WR-2 Manuel utilisateur

Sangean

Sangean WR-3 Manuel du propriétaire

Sangean

Sangean WFR-1 - DATASHEET 3 Manuel utilisateur

Sangean

Sangean WFR-20 Manuel utilisateur

Sangean

Sangean RCR-22 Manuel utilisateur

Sangean

Sangean WFT-1 Manuel utilisateur

Sangean

Sangean ATS-909 Manuel utilisateur

Sangean

Sangean WFR-1 - DATASHEET 3 Manuel utilisateur

Sangean

Sangean HDR-1 Manuel utilisateur

Sangean

Sangean HDR-16 Manuel utilisateur

Sangean

Sangean DDR-63 - PRODUCT DESCRIPTION Manuel utilisateur

Sangean

Sangean PT-633 Manuel utilisateur

Sangean

Sangean U4 DBT+ Manuel utilisateur

Sangean

Sangean Pocket 320 Manuel utilisateur

Sangean

Sangean DPR-15 Manuel utilisateur

Sangean

Sangean U-1 Manuel utilisateur

Sangean

Sangean ATS-909X2J Manuel utilisateur

Sangean

Sangean SG-622 - MANUAL 2 Manuel utilisateur

Sangean

Sangean WR-50 Manuel utilisateur

Manuels Radio populaires d'autres marques

EisSound

EisSound KBSound iSelect Manuel utilisateur

Midland

Midland 1001LWX Manuel utilisateur

Konig

Konig HAV-SR41 Manuel utilisateur

Roberts

Roberts exprssion Manuel utilisateur

VDigi

VDigi DD3.0 Manuel utilisateur

Radio Shack

Radio Shack 21-1863 Manuel utilisateur

Roberts

Roberts Stream 207 Manuel utilisateur

Sony

Sony Walkman SRF-M97 Manuel utilisateur

Stanley

Stanley FatMax FMC770 Manuel utilisateur

auna

auna DAB-Radio 10026947 Manuel utilisateur

SOUNDMASTER

SOUNDMASTER UR190 Manuel utilisateur

HYT

HYT TC-320 Manuel utilisateur

auna multimedia

auna multimedia Yellowstone 10026851 Manuel utilisateur

B-Tech

B-Tech GMRS-V2 Manuel utilisateur

Weierwei

Weierwei VEV-V8 Manuel utilisateur

SOUNDMASTER

SOUNDMASTER DAB750 Manuel utilisateur

Telefunken

Telefunken TF-1505 Manuel utilisateur

Makita

Makita LXRM03 Manuel utilisateur