Samsung SyncMaster 3 series Manuel utilisateur

SyncMaster 3

36 Cm ( 14” Diagonal )

Basic:CQA4147

CQA4147L

User’s Manual

COLOR DISPLAY UNIT

TABLE OF CONTENTS

INTRODUCTION

FOREWORD

FEATURES

FCC, IC AND SAFETY INFORMATION

FCC INFORMATlON..

IC COMPLIANCE NOTICE

WARNING AND CAUTIONS

SAFETY TIPS

OPERATING GUIDE

CONNECTING TO YOUR COMPUTER

CONTROL LOCATIONS AND FUNCTIONS

POWER MANAGEMENT SYSTEM

SIGNAL CONNECTlONS AND PIN ASSIGNMENT

TROUBLESHOOTlNG 11

SPEClFlCATlONS

APPENDIX

SIGNAL TIMING CHART

Note

— IBM, VGA, XGA, XGA II and PS/2 are registered trademarks of International Business Machines

Corporation

— Super-VGA(SVGA) and VESA are registered trademarks of the Video Electronics Standards Association.

INTRODUCTION

FEATURES

FOREWORD

First, we would like to thank you for your

purchase of this monitor. This monitor is 14

inch, high resolution, color display monitor.

This manual covers the use, and points of

caution, when operating this monitor.

Please take the time to read this manual so

that you will obtain the best performance

and most use from your monitor. After

reading the manual, store it in a safe place

for future reference.

The contents of your monitor carton should

contain:

- CQA4147, CQA4147L monitor

- Tilt and swivel stand

- This manual

- Power cord

- 9-15 pin signal cable

MPR II compliance

Model numbers with a “L” suffix comply with

SWEDAC (MPR II) recommendations for

reduced electric and magnetic fields.

36 cm (14”) [ 33.5 cm (13.2”) visual] high

performance CRT.

-Available in 0.28 mm dot pitch

Automatically scans frequencies from

31.47KHz / 70Hz, 31.47KHz / 60Hz,

35.52KHz / 87Hz, 37.86KHz / 72.8Hz,

35.16KHz / 56Hz, 37.88KHz / 60.3Hz.

37.50KHz / 75Hz.

Compatible with a wide variety of video

standards including VGA, IBM 8514/A

(XGA), and Super-VGA.

Supports VESA flicker-free modes.

Size and position controls are located up

front for easy and accurate adjustment.

The optional tilt and swivel stand may be

attached to provide a variety of viewing

angles, or not attached if limited

workspace is a consideration.

Power supply operates on AC 100 - 240

Volt 60/50Hz for use all over the world.

Your display has been designed to

operate on all power systems, including

“IT” power systems.

Power Management System

Power management circuit, when

signaled by the computer system, will

reduce power consumption when the

computer system is not in use.

FCC, IC AND SAFETY INFORMATION

FCC INFORMATION

INSTRUCTIONS TO USER

Note: This equipment has been tested and

found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide

reasonable protection against harmful

interference in a residential installation. This

equipment generates, uses and can radiate

radio frequency energy and, if not installed

and used in accordance with the instructions,

may cause harmful interference to radio

communications. However, there is no

guarantee that interference will not occur in

a particular installation. If this equipment

does cause harmful interference to radio or

television reception, which can be

determined by turning the equipment off and

on, the user is encouraged to try to correct

the interference by one or more of the

following measures:

Reorient or relocate the receiving

antenna.

Increase the separation between the

equipment and receiver.

Connect the equipment into an outlet on

a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced

radio / TV technician for help.

INFORMATION TO USER

Changes or modifications not expressly

approved by the party responsible for

compliance could void the user’s authority to

operate the equipment.

If necessary, consult your dealer or an

experienced radio/television technician for

additional suggestions. The user may find the

following booklet helpful, prepared by the

Federal Communications Commission. “How

to Identify and Resolve Radio/TV

Interference Problems” This booklet is

available from the U.S. Government Printing

Office, Washington, D.C.20402, Stock

number 004-000-00345-4.

WARNING

User must use properly shielded power

supply cord and interface cables to comply

with the requirements of the FCC.

Provided with this monitor is a detachable

power supply cord with IEC320 style

terminations. It may be suitable for connection

to any UL Listed personal computer with

similar configuration. Before making the

connection insure that the voltage rating of the

computer convenience outlet is the same as

the monitor and that the ampere rating of the

computer convenience outlet is equal to or

exceeds the monitor current rating.

For 120 Volt applications use only UL Listed

Detachable Power cord with NEMA

configuration 5-15P type ( parallel blades )

plug cap. For 240 Volt applications use only UL

Listed Detachable power supply cord with

NEMA configuration 6-15P type ( tandem

blades ) plug cap.

IC COMPLIANCE NOTICE

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing

Equipment Regulations of ICES-003.

Cet appareil numérique de la Classe B respecte toutes les exigences du Règlement ICES-003 sur

le Matériel brouilleur du Canada.

WARNING AND CAUTIONS

The lightning flash and arrowhead within the triangle is a warning

sign alerting you of “dangerous voltage” inside the product.

The exclamation point within the triangle is a warning sign alerting

you of important instructions accompanying the product.

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT

REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

SAFETY TIPS

Make sure the voltage designation on

your monitor corresponds to local

electrical supply before connecting the

AC power cord to an outlet.

To avoid electric shock, never touch the

inside of the monitor. Only a qualified

technician should open the monitor's

case.

Never use your monitor if the power cord

has been damaged. Do not allow

anything to rest on the power cord, and

keep the cord away from where people

will walk on it.

Be sure to hold the plug, not the cord,

when disconnecting the monitor from an

electric socket.

Openings in the monitor cabinet are

provided for ventilation. To prevent

overheating, these openings should not

be blocked or covered. Also, avoid using

the monitor on a bed, sofa, rug, or other

soft surface, because doing so may block

the ventilation openings in the bottom of

the cabinet. If you put the monitor in a

bookcase or some other enclosed space,

be sure that adequate ventilation is

provided.

Never insert anything metallic into the

monitor openings. Doing so may create a

danger of electric shock.

Put your monitor in a location with low

humidity and a minimum of dust. Avoid

places like damp basements or dusty

hallways.

8. Do not expose the monitor to rain or use

it near water (in kitchens, next to

swimming pools, etc.). If the monitor

accidentally gets wet, unplug it and

contact an authorized dealer

immediately. You can clean the monitor

with a damp cloth when necessary, but

be sure to unplug the monitor first.

9. Place the monitor on a solid surface, and

treat it gently. The screen is made of

glass and can be damaged if dropped or

hit sharply.

10.

If your monitor does not operate

normally; in particular, if there are any

unusual sounds or smells coming from it,

immediately unplug it and contact an

authorized dealer.

11.

High temperatures can cause trouble.

Don’t try to use your monitor in direct

sunlight, and keep it away from heaters,

stoves, fireplaces and other sources of

heat.

12.

Unplug the monitor when it is going to

be left unused for an extended period of

time.

13.

Unplug your monitor from the AC outlet

before any service.

14.

Install your AC outlet near the monitor

and be sure to be easily accessible.

OPERATING GUIDE

CONNECTING TO YOUR COMPUTER

Signal Input

AC Cord Inlet

Power (On/Off)

Power Indicator

This monitor can be connected to any IBM compatible analog display adapter.

Such adapters include VGA, 8514/A, XGA, and the built-in video system of IBM PS/2 computers

and compatibles.

To attach the monitor to your system, use the following instructions:

Turn off the power to the computer.

Insert the AC power cord into monitor

and then into an AC power outlet.

Connect the 9-pin side of the signal

cable to the 9-pin D-SUB connector on

the rear side of the monitor.

Connect the 15-pin side of the signal

cable to the video output port of your

video controller.

Note: Please see the connector pin

assignment chart for the video controller

(video controller manual) and the connector

pin assignment chart for the monitor (Page

10 this manual) if the video controller does

not have a standard 15 pin D-SUB connector.

Before turning on the power to the

monitor and computer, check your

computer’s owner’s manual for

instructions about turning on equipment

connected to the computer. Also, check

for any instructions for your video system

when using a multi-sync monitor. In

some cases, jumper or switch settings

may be required for the video board to

output extended resolution modes.

To turn on the monitor, push the power

switch. The power indicator LED will

light. To turn the monitor off, push the

power switch once again. The power

indicator LED will also turn off.

CONTROL LOCATIONS AND FUNCTIONS

BEFORE OPERATING THE MONITOR

Please take the time to familiarize yourself with the locations and functions of all the monitor’s

controls so that you can adjust it for the optimum display.

Front View

Power Switch (PUSH)

Brightness Control

Contrast Control

8. Side Pin Control

7. V-Size Control

6. H-Size Control

5. V-Position Control

4. H-Position Control 7

1. Power Switch

Use to turn monitor power on and off. Push

switch once to turn monitor power on. LED

power on indicator will also turn on. Push

switch once again to turn monitor power

off.

2. Brightness Control

Use to adjust the overall brightness of the

displayed image.

3. Contrast Control

Use to adjust the contrast level of the

displayed image. Contrast controls the

difference between dark and light areas of

the displayed image.

4. H-Position Control

Adjust this the control for the proper

horizontal position (centering) of the

display.

5. V-Position Control

Adjust this control for the proper vertical

position (centering) of the display.

6. H-Size Control

Adjust this control for the desired

horizontal size (width) of the display.

7. V-Size Control

Adjust this control for the desired vertical

size of the display.

8. Side Pin Control

Adjust this control, to correct the vertical

sides of the display from bowing out

(barrel distortion) or bowing in (pincushion

distortion).

Autres manuels pour SyncMaster 3 series

Table des matières

Autres manuels Samsung Moniteur

Samsung

Samsung SyncMaster S19B300N Manuel utilisateur

Samsung

Samsung S27BG65 Series Manuel utilisateur

Samsung

Samsung SyncMaster 770TFT Manuel utilisateur

Samsung

Samsung S20C301FL Manuel utilisateur

Samsung

Samsung 225BW - SyncMaster - 22" LCD Monitor Manuel utilisateur

Samsung

Samsung 400UXn-M - 40" LCD Public Info Display Manuel utilisateur

Samsung

Samsung DM82E-BM Manuel utilisateur

Samsung

Samsung Bixolon BCD-1000 Series Manuel utilisateur

Samsung

Samsung 2493HM - SyncMaster - 24" LCD Monitor Manuel utilisateur

Samsung

Samsung SBB-MBOXR48 Manuel utilisateur

Samsung

Samsung 400UXn-M - 40" LCD Public Info Display Guide de l'utilisateur

Samsung

Samsung 2443BWX - SyncMaster - 24" LCD Monitor Manuel utilisateur

Samsung

Samsung SyncMaster 2043SNX Manuel utilisateur

Samsung

Samsung 2493HM - SyncMaster - 24" LCD Monitor Manuel utilisateur

Samsung

Samsung SyncMaster 153V Manuel utilisateur

Samsung

Samsung SyncMaster T24A350 Mode d’emploi

Samsung

Samsung S34A65 Series Manuel utilisateur

Samsung

Samsung Flip WM65R Manuel utilisateur

Samsung

Samsung SyncMaster 730BF Manuel utilisateur

Samsung

Samsung 2493HM - SyncMaster - 24" LCD Monitor Manuel utilisateur

Samsung

Samsung C24F392FH series Manuel utilisateur

Samsung

Samsung S22D360Q Manuel utilisateur

Samsung

Samsung SyncMaster 2043SN Manuel utilisateur

Samsung

Samsung SAMTRON 52V Manuel utilisateur

Manuels Moniteur populaires d'autres marques

Linear Acoustic

Linear Acoustic LQ-1000 Manuel utilisateur

AOC

AOC I2579V Manuel utilisateur

Gateway

Gateway FPD1520 Manuel utilisateur

Furuno

Furuno Mu 120c Manuel utilisateur

Asus

Asus VB171D - 17" LCD Monitor Manuel utilisateur

Dell

Dell S2230MX Instructions d'utilisation

Philips

Philips 107C64 Manuel utilisateur

Dell

Dell S2409WFP Manuel utilisateur

EverFocus

EverFocus EN-7517E Manuel utilisateur

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Manuel utilisateur

Dell

Dell Precision 7680 Mode d’emploi

LG 50PM1M - - 50" Plasma Panel Manuel utilisateur

Bosch

Bosch DDU 9 Manuel utilisateur

Acer

Acer A231HL Manuel utilisateur

Philips

Philips 86BDL4152T Manuel utilisateur

NEC

NEC AccuSync LCD5V Manuel utilisateur

Emay

Emay SleepO2 Manuel utilisateur

IBM

IBM 6360 Instructions d'installation