1. Place the wireless receiver unit on or near the TV or
monitor where you want to install it.
2. Set the right angle of the flat pitted face of the antenna
toward the transmitter's antenna.
3. Connect the supplied 500 ma AC adaptor to the DC IN
jack at the rear of the receiver and plug it into 120V AC
outlet.
4. Turn on the power switch. The red LED (channel
indicator light) on the receiver will indicate that the unit
is turned on.
WIRELESS OPERATION
Make sure TV or monitor is turned on before using
system.
1. Set your TV and VCR to either channel 3 or 4,
whichever is better for reception in your area. Be sure to
set the wireless receiver to same channel as your TV and
VCR.
2. The flat pitted face of the antenna on the receiver
should be facing the transmitter to get the best picture
and sound.
3. Each home or office has different reception. Different
construction products such as foil insulation, heating
ducts, steel studs, etc., will create different reception
conditions. It may be necessary to set the right angle of
the antenna or move the wireless transmitter and wireless
receiver to get the best reception. Placing the wireless
receiver on a shelf near the TV/monitor or VCR may
improve the reception.
Operation With TV
1. If your TV has A/V jacks, connect one set of A/V cables to
the TV's A/V jacks and to the A/V jacks on the receiver. Be
sure the yellow, red and white plugs match the yellow, red and
white jacks on both the TV and the receiver. If the TV has
only a single jack for audio input, connect the white plug to
that jack.
2. If your TV has only a single coaxial input, connect a length
of coaxial cable from it to the output port of the A/B switch
(not supplied). Then connect coaxial cable from one of the
switch's input ports to the connector labeled TO TV on back
of the receiver, and connect your cable TV or antenna input to
the switch's other input port. Set the channel 3/4 switch on the
back of the receiver whichever channel (3 or 4) is not used by
any local TV stations. Then tune the TV to that station.
3. If using an A/B switch (not supplied), select between
viewing the BarnCam reception and the cable antenna signal
on the TV by moving the switch either to A or B.
4. Make sure the ON/OFF switch is in the ON position. Plug
one end of the receiver’s power adaptor into the back of the
receiver and the other end into any 120 V wall outlet. Use
only the adaptor provided.
5. Locate and orient the receiver according to the Setup
instructions in this manual.
