Ryobi RY253SS Manuel utilisateur

First Time Start

First Time Assembly

Remove product from carton.

Assemble per instructions

in your operator’s manual.

WARNING: This Quick Start Guide is not a substitute for reading the

operator’s manual. To reduce the risk of injury, user must read and understand

operator’s manual before using this product.

Align and assemble 2 booms

until fully seated.

Snap shield into place over boom and bracket.

Secure with bolt and wing nut as shown.

Spread handle over boom and

snap into place. Secure with

bolt and wing nut.

- OR -

Curved Shaft

Straight Shaft

Mix 2.6 oz. 2-cycle oil with

1 gallon of fresh gasoline in

separate gas container. Shake,

then pour into trimmer tank.

Place trimmer on ground

with the trim head end facing

away from you.

Set choke lever to

FULL CHOKE position.

Repeatedly press the primer

bulb 10 times.

SQUEEZE THROTTLE

TRIGGER FULLY and pull

starter grip and rope until

engine attempts to start (no

more than 4x).

NOTE: If engine does not

start, return to step 7 and

repeat.

SET TO HALF CHOKE position.

SQUEEZE THROTTLE

TRIGGER FULLY and pull

starter grip until engine

runs. Allow engine to run

10 seconds, set to RUN

position.

You are now ready to Trim!

If engine did not start,

REPEAT STEPS

To stop trimmer, press

the red switch located

on the top of the

trigger housing.

Go to www.ryobitools.com and register your new tool online.

For any questions about operating or maintaining your product,

call the Ryobi™Help Line!

1-800-860-4050

Your Product has been fully tested prior to shipment to

ensure your complete satisfaction. Troubleshooting tips are

also available in your operator’s manual.

For additional registration instruction, refer to operator’s manual.

10X

TRIM!

991000348

1-14-15 (REV:01)

–

First Time Start

First Time Assembly

Remove product from carton.

Assemble per instructions

in your operator’s manual.

WARNING: This Quick Start Guide is not a substitute for reading the

operator’s manual. To reduce the risk of injury, user must read and understand

operator’s manual before using this product.

Align and assemble 2 booms

until fully seated.

Snap shield into place over boom and bracket.

Secure with bolt and wing nut as shown.

Spread handle over boom and

snap into place. Secure with

bolt and wing nut.

- OR -

Curved Shaft

Straight Shaft

Mix 2.6 oz. 2-cycle oil with

1 gallon of fresh gasoline in

separate gas container. Shake,

then pour into trimmer tank.

Place trimmer on ground

with the trim head end facing

away from you.

Set choke lever to

FULL CHOKE position.

Repeatedly press the primer

bulb 10 times.

SQUEEZE THROTTLE

TRIGGER FULLY and pull

starter grip and rope until

engine attempts to start (no

more than 4x).

NOTE: If engine does not

start, return to step 7 and

repeat.

SET TO HALF CHOKE position.

SQUEEZE THROTTLE

TRIGGER FULLY and pull

starter grip until engine

runs. Allow engine to run

10 seconds, set to RUN

position.

You are now ready to Trim!

If engine did not start,

REPEAT STEPS

To stop trimmer, press

the red switch located

on the top of the

trigger housing.

Go to www.ryobitools.com and register your new tool online.

For any questions about operating or maintaining your product,

call the Ryobi™Help Line!

1-800-860-4050

Your Product has been fully tested prior to shipment to

ensure your complete satisfaction. Troubleshooting tips are

also available in your operator’s manual.

For additional registration instruction, refer to operator’s manual.

10X

TRIM!

991000348

1-14-15 (REV:01)

–

First Time Start

First Time Assembly

Remove product from carton.

Assemble per instructions

in your operator’s manual.

WARNING: This Quick Start Guide is not a substitute for reading the

operator’s manual. To reduce the risk of injury, user must read and understand

operator’s manual before using this product.

Align and assemble 2 booms

until fully seated.

Snap shield into place over boom and bracket.

Secure with bolt and wing nut as shown.

Spread handle over boom and

snap into place. Secure with

bolt and wing nut.

- OR -

Curved Shaft

Straight Shaft

Mix 2.6 oz. 2-cycle oil with

1 gallon of fresh gasoline in

separate gas container. Shake,

then pour into trimmer tank.

Place trimmer on ground

with the trim head end facing

away from you.

Set choke lever to

FULL CHOKE position.

Repeatedly press the primer

bulb 10 times.

SQUEEZE THROTTLE

TRIGGER FULLY and pull

starter grip and rope until

engine attempts to start (no

more than 4x).

NOTE: If engine does not

start, return to step 7 and

repeat.

SET TO HALF CHOKE position.

SQUEEZE THROTTLE

TRIGGER FULLY and pull

starter grip until engine

runs. Allow engine to run

10 seconds, set to RUN

position.

You are now ready to Trim!

If engine did not start,

REPEAT STEPS

To stop trimmer, press

the red switch located

on the top of the

trigger housing.

Go to www.ryobitools.com and register your new tool online.

For any questions about operating or maintaining your product,

call the Ryobi™Help Line!

1-800-860-4050

Your Product has been fully tested prior to shipment to

ensure your complete satisfaction. Troubleshooting tips are

also available in your operator’s manual.

For additional registration instruction, refer to operator’s manual.

10X

TRIM!

991000348

1-14-15 (REV:01)

–

Autres manuels pour RY253SS

Table des matières

Autres manuels Ryobi Tondeuse

Ryobi

Ryobi RBC1020 Manuel utilisateur

Ryobi

Ryobi RY29550 Manuel utilisateur

Ryobi

Ryobi AHF04G Manuel utilisateur

Ryobi

Ryobi P20010 Manuel utilisateur

Ryobi

Ryobi RHT5550 Manuel utilisateur

Ryobi

Ryobi RHT-600R Manuel utilisateur

Ryobi

Ryobi RPHT254O Manuel utilisateur

Ryobi

Ryobi RY25CSEMC Manuel utilisateur

Ryobi

Ryobi CHT1850LBC Manuel utilisateur

Ryobi

Ryobi RY4CSS Manuel utilisateur

Ryobi

Ryobi RLT-552 Manuel d'utilisation

Ryobi

Ryobi HT816r, HT818r, HT822r Manuel utilisateur

Ryobi

Ryobi 140R Manuel utilisateur

Ryobi

Ryobi P2605 Manuel utilisateur

Ryobi

Ryobi ZR51950A-250000001 Manuel utilisateur

Ryobi

Ryobi 780r Manuel utilisateur

Ryobi

Ryobi P2004 Manuel utilisateur

Ryobi

Ryobi RLT1038 Manuel utilisateur

Ryobi

Ryobi RHT1851R25F Manuel utilisateur

Ryobi

Ryobi RBC42FSBO Manuel utilisateur

Ryobi

Ryobi RY15523 Manuel utilisateur

Ryobi

Ryobi P600 Manuel utilisateur

Ryobi

Ryobi P601 Manuel utilisateur

Ryobi

Ryobi RY34440 Guide d'application

Manuels Tondeuse populaires d'autres marques

MTD

MTD HT 51 E Manuel utilisateur

McCulloch

McCulloch T22 LS Manuel utilisateur

COCKRAFT

COCKRAFT PRO HL36-S Manuel utilisateur

Grizzly

Grizzly CT 1800 Li Manuel utilisateur

Peco

Peco Z Trimmer ZT-3000 Manuel utilisateur

Solo

Solo 116 Manuel utilisateur

Stiga

Stiga ST 1200 Manuel utilisateur

Echo

Echo GT-225 - 10-09 Manuel utilisateur

RedMax

RedMax BT17 Manuel utilisateur

GreenWorks

GreenWorks STA806 Manuel utilisateur

Parkside

Parkside PHSL 900 A3 Manuel utilisateur

Gardeo

Gardeo PRO GPTHT2560 Manuel utilisateur

Park

Park DT-810870 Manuel utilisateur

Worx

Worx WG209 Manuel utilisateur

Gardenline

Gardenline 43671/HTKS26 Manuel utilisateur

Makita

Makita 3710 Manuel utilisateur

Champion

Champion 100683 Manuel utilisateur

Stihl

Stihl FS 311 Manuel utilisateur