SERIAL SPLIT MODE TIP: To set up an AAAB
type structure, where Sequence A plays
STAGES 1-4 three times, then Sequence B
plays STAGES 5-8 once;
Set the following values 5, 3, 1 respectively.
5 = Split point, 3 = A repeats, 1 = B repeats.
When in Split Mode, the sequencer will play
both A & B sequences simultaneously, but the
B repeat count is used as a clock-count
multiplier.
Eg. If B repeats are set to 3, and a Stage Count
on Sequence B is set to 4, then that stage will
play 12 clock pulses. [ 3 x 4 = 12 ]
VOLTAGE MODE
Slide this switch to set the
voltage range of the CV.
For CH1 this can be set to 2V Quantised, 5V
Quantised, or 5V Non-Quantised.
For CH2 2V or 5V Quantised only.
GLIDE PROG is used to set the glide
ON/OFF per stage. When the sequencer is
stopped, Stored CV values for CH2 CV and
MIDI Note Velocity can be set.
To set the glide per stage, use PREV/NEXT
controls to select stage, indicated by the
flashing Green LED.
Push RESET to toggle On/Off the Glide
setting for this stage. Stages with glide set On
are indicated by a solid Green LED.
When the sequencer is stopped, the GATE
TIME control is used to adjust the Stored CV
value of the stage indicated by the flashing
Green LED. The Stored CV values are used for
the velocity of MIDI Note output.
When not in Split Mode, the Stored CV values
are output from the CH2 CV output.
NB On the back of the module there is a micro
switch to select 2V or 5V for the non-quantised
CH1 CV range.
CH1 CV OUT
CV output from the
current stage in the Sequence.
[NB Stages set to Gate Mode Off do not
update the CV Output]
CH1 GATE OUT
Gate output from the
current stage.
CH2 CV GATE / SYNC
OUT
CV output for the Stored
CV of current stage. Use the supplied Y-cable.
CV [ Black jack ], Gate [ Grey jack ].
In Split Mode, the CV and Gate from
Sequence B are output from CH2.
Sync pulse for start of sequence, is sent via the
Gate [ Grey jack ] when using the supplied
Y-cable. Except when using Split mode.
TIP: If using only the CV of CH2, a standard
mono jack cable can be used instead.
CLOCK IN / OUT
Can be used for clock
input, or clock output.
[NB If using an external clock, it is a good idea
to stop the internal clock first ! ]
MIDI IN / RESET IN
Can accept MIDI CLOCK
sync from external units
such as drum machines, and also MIDI NOTE
input for shifting the Root Note key of the
sequence.
When the RESET menu option is selected, this
input becomes a standard RESET input.
MIDI OUT JACK
Outputs MIDI NOTES from
CH1, and MIDI CLOCK
sync, with stop, start, reset commands.
NB On the back of the module PCB are two
micro switches to set the type of TRS MIDI.
The supplied cable is Type B, which we
recommend.
3
