RuggedCom WiN52 Series Instructions d'installation et d'utilisation
User’s Manual & Installation Guide for:
WiN52XX/WiN51XX Series Outdoor CPE
ALL RIGHTS RESERVED
Dissemination or reproduction of this document, or evaluation and communication of its contents, is not authorized except where
expressly permitted. Violations are liable for damages. All rights reserved, particularly for the purposes of patent application or trademark
registration.
This document contains proprietary information, which is protected by copyright. All rights are reserved. No part of this document may be
photocopied, reproduced or translated to another language without prior written consent of RuggedCom Inc.
Disclaimer Of Liability
We have checked the contents of this manual against the hardware and software described. However, deviations from the description
cannot be completely ruled out.
RuggedCom shall not be liable for any errors or omissions contained herein or for consequential damages in connection with the
furnishing, performance, or use of this material.
The information given in this document is reviewed regularly and any necessary corrections will be included in subsequent editions. We
appreciate any suggested improvements. We reserve the right to make technical improvements without notice.
Registered Trademarks
RuggedMAX-BST™, RuggedServer™, RuggedWireless™, RuggedCom Discovery Protocol™ (RCDP™), RuggedExplorer™, Enhanced
Rapid Scanning Tree Protocol™ (eRSTP™), are trademarks of RuggedCom Inc. Rugged Operating System® (ROS®) and
RuggedSwitch® are registered trademarks of RuggedCom Inc. Other designations in this manual might be trademarks whose use by
third parties for their own purposes would infringe the rights of the owner.
Warranty
Five (5) years from date of purchase, return to factory. For warranty details, visit www.ruggedcom.com or contact your customer service
representative.
Contacting RuggedCom
Corporate Headquarters US Headquarters Europe Headquarters
RuggedCom Inc
30 Whitmore Road
Woodbridge, Ontario
Canada, L4L 7Z4
Tel: (905) 856-5288
Fax: (905) 856-1995
Toll-free: 1 (888) 264-0006
RuggedCom
1930 Harrison St., Suite 209
Hollywood, Florida
USA, 33020
Tel: (954) 922-7938x103
Fax: (954) 922-7984
Toll-free: 1 (888) 264-0006
RuggedCom
Unit 41, Aztec Centre,
Aztec West, Almondsbury, Bristol
United Kingdom BS32 4TD
Tel: +44 1454 203 404
Fax: +44 1454 203 404
Toll-free: 1 (888) 264-0006
WiN5200 Table of Contents | 3
Table of Contents
Introduction............................................................................................................6
1.1 About this Manual......................................................................................................................7
1.2 General Description..................................................................................................................7
1.2.1 Features ..........................................................................................................................8
1.3 Package Components and Unpacking.................................................................................8
1.4 Safety Information.....................................................................................................................8
Product Description............................................................................................11
2.1 Introduction...............................................................................................................................12
2.2 IEEE 802.16e Mobile WiMAX Compliance........................................................................13
2.3 Block Diagram..........................................................................................................................14
2.4 Features ....................................................................................................................................15
2.4.1 Mobile WiMAX Wave 2 MIMO Features................................................................15
2.4.2 Security..........................................................................................................................17
2.4.3 Time Division Duplexing (TDD)................................................................................20
2.4.4 Coding Rate..................................................................................................................20
2.4.5 Modulation....................................................................................................................20
2.4.6 Convolution Coding Error Correction......................................................................21
2.5 Deployment Models................................................................................................................21
2.5.1 PTP Deployment.........................................................................................................21
2.5.2 PMP Deployment........................................................................................................21
2.5.3 Non Line-of-Sight ........................................................................................................21
2.5.4 Channelization .............................................................................................................21
2.6 Service Flows...........................................................................................................................22
2.6.1 Service Flow Classification.......................................................................................22
2.6.2 Dynamic Service Addition .........................................................................................22
2.6.3 Default Service Flows.................................................................................................23
WiN5200 Table of Contents | 4
2.6.4 Scheduling ....................................................................................................................23
2.7 Physical Description...............................................................................................................24
2.7.1 Physical Interfaces Description................................................................................24
2.7.2 LED Indication Description........................................................................................25
Mounting ..............................................................................................................27
3.1 General......................................................................................................................................28
3.2 Site Survey................................................................................................................................28
3.3 Pole Mounting..........................................................................................................................29
3.4 Wall Mounting..........................................................................................................................29
Installation Procedure ........................................................................................30
4.1 Safety Hazards ........................................................................................................................31
4.2 Tools and Cables Required for the Installation ................................................................31
4.3 Installing the WiN5200...........................................................................................................31
4.3.1 Pole Mounting..............................................................................................................32
4.3.2 Wall Mount....................................................................................................................33
4.4 Cable Connections..................................................................................................................35
4.4.1 Installing the WiN1010 data adapter for WiN5200 ..............................................35
Equipment Configuration and Monitoring........................................................38
5.1 Configuring WiN5200 Basic Parameters...........................................................................39
5.2 Aligning the CPE Antenna.....................................................................................................41
5.2.1 CPE Antenna Alignment Procedure........................................................................42
5.2.2 Link Indication..............................................................................................................43
Management.........................................................................................................44
6.1 General......................................................................................................................................45
6.2 SW Download/Upgrade .........................................................................................................45
6.3 Web-page Management........................................................................................................46
6.4 SNMP Management...............................................................................................................50
WiN5200 Table of Contents | 5
Appendix A –Product Specification.................................................................51
Appendix B –IDU to ODU Cable Specifications..............................................52
List of Acronyms.................................................................................................54
WiN5200 Introduction | 6
1
Introduction
WiN5200 Introduction | 7
1.1 About this Manual
This manual describes the installation procedures of WiN51XX/WiN52XX Outdoor CPE with
Ethernet interfaceand is written for the installers and operators.
WiN51XX/WiN52XX2 products will be referred in this manual as WiN5200 from now on.
The RuggedCom WiN5200 is a member of the Win-Max™ E family, a line of mobile WiMAX
broadband wireless access systems based on the 802.16e mobile WiMAX standard. The Win-
Max™ E family is detailed in the System Description manual ofRuggedCom.
This manual assumes that users have some experience with WiMAX technologies and
procedures.
While some safety precautions are reviewed here, this manual assumes that installers have
been trained in safe installation practices. Users, who are new to WiMAX technologies and
service procedures,should not rely on this manual for comprehensive guidance.
1.2 General Description
The RuggedCom WiN5200 ODU is a member of the Win-Max™ E family, a line of WiMAX
Broadband Wireless Access systems based on the 802.16e mobile WiMAX standard, specially
designed for quadruple-play applications.
WiN5200 is a high-performance outdoor unit that provides complete 802.16e mobile WiMAX
broadband wireless access functionality to a range of indoor multi-service gateways.
The WiN5200 enables the full scope of triple-play (including telephony, data, Video-on-Demand)
over the WiMAX network. In the home, triple play services are distributed to a single gateway
for a simple home-networking solution.
The WiN5200 is based on the IEEE 802.16e standards to effectively meet the unique requirements
of the wireless Metropolitan Area Network (MAN) environment and to deliver broadband
accessservicesto a wide range of customers. Specifically designed for point-to-multipoint
broadband wireless access applications, the WiN5200 provides efficient use of the wireless
spectrum, supporting a range of user environments. The access and bandwidth allocation
mechanisms accommodate hundreds of subscriber units per sector, supporting differentiated
services to a multiple of end-users.
WiN5200 Introduction | 8
1.2.1 Features
• Intelligent WiMAX subscriber unit for wireless triple-play service delivery
• Outdoor unit with ETH interface to indoor unit
• Automatic, self-configured, plug-n-play
• Supporting 1.X, 2.X and 3.X GHz bands
1.3 Package Components and Unpacking
Check that the package contains:
1. WiN52xx ODU with integrated flat antenna
2. Pole/wall mounting hardware
In case of damage, contact the shipping company.
1.4 Safety Information
RF Exposure
The WiN5200, an outdoor CPE, is compliant with the requirements set forth in CFR 47 section
1.1307, addressing RF Exposure from radio frequency devices as defined in OET Bulletin 65.
The outdoor CPE mobile unit should be positioned more than 0.6 feet (20 cm) from humans.
The outdoor CPE fixed unit should be positioned at least 7 feet (2m) from humans.
Lightning Protection
When WiN5200 is installed in an outdoor location, all indoor components (Ethernet, power
supply) should be connected through a lightning protector.
The purpose of the lightning protection is to protect people and equipment located indoors
from lightning that might strike the WiN5200 or its outdoor cables. Therefore, the lightning
protector device should be installed indoors, as close as possible to the point where the cables
enter the building. The lightning protector can also be installed outdoors, as long as the cables
that lead from it indoors are well protected from lightning between the box and the building
entrance.
Power Cord Protection
The WiN5200 should always be connected to the WiN1010 data adapter for both power
supply and data transfer purposes.
WiN5200 Introduction | 9
Any other type of connection/application of the WiN5200 and/or WiN1010 is not allowed.
Route all power supply cords so that people cannot walk on them, or place objects on or
against them. This can pinch or damage the cords.
Servicing
Do not open the cover of this product and perform corrective actions unless instructed to do
so in the operating instructions.
Outdoor Grounding System
Verify that the antenna or cable system is grounded (earthed).
Theantenna is an integral part of the CPE (Models WiN51XX)
The CPE (antenna) installation must be as per Article 810 of the NEC. Of particular note is the
requirement that the grounding conductor not be less than 10 AWG (Cu). The scheme should
be either in accordance with UL 96 and 96A. Lightning Protection Components and
Installation Requirements for Lightning Protection Systems, or tested in accordance with UL
50 and UL 497.
CAUTION
To reduce the risk of fire, use only No. 26AWG or larger telecommunication line cord
between the indoor and outdoor units.
WiN5200 Introduction | 10
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates,uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
(1) This device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the
device
Changes or modifications to this equipment not expressly approved by the party
responsible for compliance (RuggedCom Inc.) could void the user’s authority to
operate the equipment.
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels RuggedCom Point d'accès sans fil
Manuels Point d'accès sans fil populaires d'autres marques
D-Link
D-Link DWL-2100AP - AirPlus Xtreme G Manuel utilisateur
Ubiquiti
Ubiquiti NanoStation NSM2 Manuel utilisateur
Cisco
Cisco Aironet 1550 Series Manuel utilisateur
Aruba
Aruba IAP-335 Manuel utilisateur
Advantek Networks
Advantek Networks AWN-AP-54MR Manuel utilisateur
IP-COM
IP-COM AP355 Manuel utilisateur
