P.5
GENERAL ASSEMBLY TIPS AND TROUBLESHOOTING DURING ASSEMBLY:
*Before you start assembling, make sure you have all the parts and necessary
hardware by doing a quick inventory.
*Follow the assembly instructions step by step, and do not skip any unless
advised to do so by RTA PRODUCTS’ Customer Service.
*On each step, and to avoid misalignments, always leave screws loose, and
do not tighten them until all are in place.
*In wood panels, the laminate might be covering the holes.
If there are no visible holes: Pass the tip of your finger around the area where
the hole should be, and press against the surface to feel the indentation.
If the hole looks too small for the screw of bolt: carefully perforate the laminate
with the tip of a pen.
DOES THE HOLE
LOOK TOO SMALL?
CAREFULLY
PERFORATE. THE HOLE IS BIGGER
THAN WHAT IT APPEARED.
*In wood panels, some might have inserts that look like screws. Those inserts are
either nuts or cam locks. Make sure they are aligned to receive the screws or bolts.
Misaligned
nut CORRECT Misaligned
cam lock CORRECT
*Make sure to use the correct screws or bolts, and do not overtight them.
Using wrong screws or overtighting them might cause damage to the parts,
and such damage is not covered by the product’s warranty.
CORRECT SIZE OF SCREW
SCREW IS NOT OVERTIGHTEN A WRONG SIZE OF SCREW
OR OVERTIGHTING IT WILL
CAUSE DAMAGE!
RTA-2018
