Rompa Teeth Brushing Bear Manuel utilisateur
1. Product Name
Teeth Brushing Bear
2. Product Code
21322
3. Colour
Likely to be as pictured above.
4. Brief Description
Activate your switch to make this happy bear talk, hum, sing and brush his teeth.
5. Contents
Bear with cable and jack socket attached.
6. Snoezelen® Stimulations
Sight
Sound
Touch
7. Best Use
Use with a switch connected to operate the bear.
8. Compatible ROMPA® Products
Please see www.rompa.com for our extensive range of switches and switch-adapted
products.
9. Starting Up
Insert 3 AA batteries.
Connect a switch to the jack socket.
10. Detailed Description
Activate your switch to make the Teeth Brushing Bear talk, hum, sing and move to
brush his teeth with his toothbrush. Encouraging, once activated he continues for
around 2 minutes –the recommended brushing time. At the end of this time his
teeth sparkle thanks to the LED lights in his lovely smile. Requires 3 AA batteries and
a switch (not included).
11. Safety
Always supervise the use of this product.
Not suitable for those who mouth.
Do not allow item to be thrown around or treated roughly as this may break the
internal mechanisms that make the bear move.
12. Technical Specification
Size: 25cmH
Power: 3 x AA batteries
13. Installation
1. Turn the Bear upside down. Using a cross-head screw driver open the battery
compartment.
2. Insert three AA batteries, observing the polarity indicated.
3. Close the battery compartment and tighten the screw to secure in place.
4. Connect the Bear to a switch (not included) via the jack socket at the
end of the cable attached. The socket is 3.5mm.
5. Make sure the ON/OFF switch is set to ON. Activate the Bear by activating the
switch you have just connected. The operation is latched –activate your switch to
make it play and activate the switch again to make the Bear stop. The play sequence
is approximately 2 minutes and will stop automatically when complete. If the Bear is
stopped, it will start again at the beginning of the sequence when your switch is
activated again.
6. The Teeth Brushing Bear can also be operated by pressing the paw with the spiral
pattern.
7. The Bear does not have a volume switch.
14. Care and Maintenance
Do not allow clients to pull on the cable.
Do not immerse the unit in water.
Change the batteries when operation becomes erratic.
Remove the batteries when the Bear is not in use for prolonged periods.
Do not use rechargeable batteries, and do not mix old and new batteries.
15. Troubleshooting
Problem: the Bear will not move or make a sound:
Make sure your switch is properly connected (pushed as far as possible into the
jack socket).
Check the batteries and replace these as required.
Make sure your switch is not faulty –check it with another switch-adapted
product.
Further copies of these instructions can be downloaded at www.rompa.com
We hope you find our instructions invaluable. If you have any suggestions for improving
them further your comments will be greatly received –please contact us at
TEETH BRUSHING BEAR 21322, January 2015
Copyright ROMPA®Ltd
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Rompa Jouet
Rompa
Rompa Pressure-Activated Frog Manuel utilisateur
Rompa
Rompa 20323 Manuel utilisateur
Rompa
Rompa PERCY PIG Manuel utilisateur
Rompa
Rompa Mog 20684 Manuel utilisateur
Rompa
Rompa 18407 Manuel utilisateur
Rompa
Rompa 14864 Manuel utilisateur
Rompa
Rompa Rainbow in my Room Manuel utilisateur
Rompa
Rompa Wizard of 'SnOeZ' Manuel utilisateur
Rompa
Rompa Musical Abstract Tactile Panel Manuel utilisateur
Rompa
Rompa TWILIGHT TURTLE 20491 Manuel utilisateur
