Robin SIP Manuel du propriétaire
Version: Robin_SV_1.0 ENG
Datum: 07-04-2015
TECHNICAL INSTRUCTION:
REPLACEMENT SD-CARD
TECHNICAL
INSTRUCTION
Replacement SD-card
Robin SIP / SV
TECHNICAL INSTRUCTION
REPLACEMENT SD-CARD
ROBIN SIP / SV
version Robin_SV_1.0_ENG (07-04-2015)
Page 2
This document
This document describes the steps needed to replace the build-in SD-card of a Robin SIP or Robin SV
for a new one.
After replacement of the SD-card the settings are set back to factory defaults. The Robin needs to be
re-configured. By default the network settings are set to DHCP.
TECHNICAL INSTRUCTION
REPLACEMENT SD-CARD
ROBIN SIP / SV
version Robin_SV_1.0_ENG (07-04-2015)
Page 3
Preperation
Make sure the work environment is clean and ESD safe.
Necessary tools
To remove the back of the Robin SIP or Robin SV you’ll need the following tools:
• Cap screwdriver, size 5.5
Necessary parts
• Programmed SD-card, type Sandisk 8GB Class 10
TECHNICAL INSTRUCTION
REPLACEMENT SD-CARD
ROBIN SIP / SV
version Robin_SV_1.0_ENG (07-04-2015)
Page 4
Necessary tools and parts
Aantal Omschrijving Foto(s)
1 Robin SIP / SV
1 Programmed Sandisk SD-
card
1 Cap screwdriver, size 5.5
TECHNICAL INSTRUCTION
REPLACEMENT SD-CARD
ROBIN SIP / SV
version Robin_SV_1.0_ENG (07-04-2015)
Page 5
Removal of the back
Place the Robin on its front, on a clean surface.
• Unscrew the six nuts on the back.
• Remove the back of the Robin.
TECHNICAL INSTRUCTION
REPLACEMENT SD-CARD
ROBIN SIP / SV
version Robin_SV_1.0_ENG (07-04-2015)
Page 6
Removal of the old SD-card en placement of the new SD-card
• Keep the Robin on its side, so you can see the SD-card (above the connectors)
• Unlock the SD-card by pressing on the card (the card pops out of the holder)
• Remove the SD-card
• Place the new (Sandisk) SD-card in the SD-card holder. It will click in place.
! Note: The SD-card will only fit in the SD-card holder with the text upward !
TECHNICAL INSTRUCTION
REPLACEMENT SD-CARD
ROBIN SIP / SV
version Robin_SV_1.0_ENG (07-04-2015)
Page 7
Replacing the back
Place the Robin on its front, on a clean surface.
• Place the back on the Robin
• Screw the six bolts back in place
After reconnecting the Robin it will boot with factory default settings.
Autres manuels pour SIP
1
Ce manuel convient aux modèles suivants
1
Autres manuels Robin Système d'interphone
Robin
Robin SmartView SIP Manuel utilisateur
Robin
Robin SIP Manuel du propriétaire
Robin
Robin SmartView SIP Manuel utilisateur
Robin
Robin Compact SIP Manuel utilisateur
Robin
Robin SV Series Manuel utilisateur
Robin
Robin SlimLine Manuel utilisateur
Robin
Robin Compact Manuel utilisateur
Robin
Robin Robin SmartView Manuel utilisateur
