Roadstar HIF-9907 Manuel utilisateur

Service Manual - HIF-9907

HIF-9907

Service Manual - HIF-9907

INDEX

1.WARNING AND TECHNICAL SPECIFICATION

2.ALIGNMENT

3.BLOCK DIAGRAM

4.FUNCTION DIAGRAM

5.SPECIFICATION

6.VOLTAGE TABLE

7.TROUBLESHOOTING

8.DISASSEMBLY INSTRUCTION

9.EXPLOSION DIAGRAM AND BOM

10.WIRE ASSEMBLY DIAGRAM

11.PRINCIPLE DIAGRAM

12.REPAIR DIAGRAM

13.MATERIAL BILL OF APPLIANCE 37-40

21-23

24-25

6-16

19-20

17-18

TITLE: INDEX

4-5

27-31

33-34

35-36

WARNING:

FOR CONTINUED SAFETY THE FOLLOWING PRECAUTIONS SHOULD BE FOLLOWED

DURING SERVICING.

1.MAKE SURE POWER CORD IS DISCONNECTED BEFORE REPLACING ANY PART.

2.REPLACE WITH TYPE, CRITICAL PARTS WITH! MAKE ON THIS DIAGRAM.

3.THE FOLLOWING TEST MUST BE IMPLEMENTED AFTER EACH REPAIR BEFORE

RETURNING IT TO CUSTOMER.USE AN OHM-METER TO MEASURE THE F.C.

RESISTANCE FROM BOTH A.C.CONDUCTORS TO ANY EXPOSED METALLIC PART

SUCH AS A SCREW HEAD.METAL INLAYS ETC. THE RESISTANCE MEASURED SHOULD

BE 10 MEGAOHMS MINIMUM.

TECHNICAL SPECIFICATION

Power output :2 Watts RMS per channel NOTE:

into 8 ohms In keeping with our policy of continually

Frequency response :40Hz-15KHz improving our service and the technical

Bass Boost :100Hz+10dB quality of our products we reserve the right

to change component type.manufactures

sources of supply of technical specification

are any time.

TUNER SECTION

FM Section :88MHz-108MHz

AM Section :540KHz-1600KHZ

CASSETTE SECTION

Tape :Cassette type

Tape :4.75cm per second

Tracks :2Tracks stereo

Frequency Response :125Hz-8KHz

CD PLAYER SECTION

Frequency Response :40Hz-10KHz

S/N Ratio :60dB

Channel Separation :40dB

MODEL:HIF-9907

TITLE: WARNING AND TECHNICAL

SPECIFICATION

INSTRUMENTS REQUIRED: AM&FM Signal generator

IF Scope&2tracks Oscilloscope

AM/FM IF ALIGNMENT

Set output of signal generator no higher than necessary to obtain an output reading.

Slide the function switch to the tuner position and the band switch to the AM position.

Set volume control to reference output.

Use loop antenna to Radiate the Signal into the Receiver Antenna..

RADIO SETTING ADJUSTMENT REMARKS

GENERATOR

10.7/AM465KHZ Scope across FM T102 Adjust the

10.8KHz V Speaker jack Wave for maximum

10.9KHz Or IC TA2111 AM T101 &good Output

Pin(13 or 14)

AM RF ALIGNMENT

SIGNAL RADIO SETTING INDICATOR ADJUSTMENT REMARKS

GENERATOR

540KHz Tune to 540KHz SCOPE across T103 Adjust for maximum

400Hz (low end). Speaker jack or & good Output.

Modulation IC TA2111

1620KHz Tune to 1600KHz pin(13 or 14) VC101-TCO Adjust for maximum

400Hz (high end). &good output

Modulation

600KHz 600KHz VTVM&SCOPE BAR ANT. -AM Adjust for maximum

Across Speaker &good Output

1400KHz 1400KHz Jack VC101-TAC Adjust for maximum

&good Output

FM RF ALIGNMENT

Connect Signal Generator across antenna terminals.

Adjustment of coils should not be attempted unless the Original coil is deformed or has been replaced.

Slide the function switch to the tuner position and the band switch to the FM position.

Set Volume control to reference output.

SIGNAL

GENERATOR RADIO SETTING INDICATOR ADJUSTMENT REMARKS

87.5MHz Tune to <88MHz L103 Adjust for maximum

1000Hz (low end ) SCOPE across &good Output

modulation Speaker jack or

108.3MHz Tune to108MHz IC TA2111 VC101-FMO Adjust for maximum

1000Hz (high end ). Pin(13 or 14) &good Output.

modulation

90MHz 90MHz VTVM&SCOPE L102 Adjust for maximum.

Across SPEAKER &good output

106MHz 106MHz Jack C VC101-FMA Adjust for maximum.

&Good Output

ALIGNMENT PROCEDURES

SIGNAL INDICATOR

Tune to 90.3M/AM 600KHz

(

high end) AM Lowend

TITLE: ALIGNMENT

ALIGNMENT INSTRUCTIONS FOR CASSETTE TAPE DECK

Figure as diagram:

HEAD AZIMUTH: While playing test tape (6K3Hz) RECORDING BIAS: Press "Record" button, adjust L201

Adjust azimuth screw on the left side and the frequency move to 52KHz.

of the tape head for maximum output

for both L/R channel

INSTRUMENT REQUIRED: A. AC VOLTMETER

B. FREQUENCY COUNTER

ADJUSTMENT DIAGRAM:

TITLE: ALIGNMENT

TITLE: BLOCK DIAGRAM

UTC2025

TITLE: BLOCK DIAGRAM

Table des matières

Autres manuels Roadstar Système stéréo

Roadstar

Roadstar HRA-1540UE/BT Manuel utilisateur

Roadstar

Roadstar HRA-1782D+BT Manuel utilisateur

Roadstar

Roadstar HIF-9510RCW Manuel utilisateur

Roadstar

Roadstar HIF-9088TUMP Manuel utilisateur

Roadstar

Roadstar HIF-4800RC Manuel utilisateur

Roadstar

Roadstar HIF-8050 Manuel utilisateur

Roadstar

Roadstar HIF-9951L Manuel utilisateur

Roadstar

Roadstar HIF-9961L Manuel utilisateur

Roadstar

Roadstar HIF-7210R Manuel utilisateur

Roadstar

Roadstar HIF-8892D+BT Manuel utilisateur

Roadstar

Roadstar HIF-8551 Manuel utilisateur

Roadstar

Roadstar HRA-1550USMP Manuel utilisateur

Roadstar

Roadstar HIF-1899TUMPK Manuel utilisateur

Roadstar

Roadstar HIF-5803MP Manuel utilisateur

Roadstar

Roadstar HRA-1500MP Manuel utilisateur

Roadstar

Roadstar HIF-9911 Manuel utilisateur

Roadstar

Roadstar CDR-4500U Manuel utilisateur

Roadstar

Roadstar HIF-8590LRC Manuel utilisateur

Roadstar

Roadstar HIF-5510UCMPT Manuel utilisateur

Roadstar

Roadstar HIF-8892EBT Manuel utilisateur

Roadstar

Roadstar HIF-5803MP Manuel utilisateur

Roadstar

Roadstar HIF-1993DBT Manuel utilisateur

Roadstar

Roadstar HIF-9110L Manuel utilisateur

Roadstar

Roadstar HIF-5811MPT Manuel utilisateur

Manuels Système stéréo populaires d'autres marques

LG CM3330B Manuel utilisateur

Sony

Sony SS-CEP50 Manuel utilisateur

Cetacea Sound

Cetacea Sound CVS-II Manuel utilisateur

Aiwa

Aiwa XR-H66MD Manuel utilisateur

Denon

Denon UCD-250 Manuel utilisateur

Sanyo

Sanyo DC-MX41i Manuel utilisateur

Sharp

Sharp CD-ES600V Manuel utilisateur

Exibel

Exibel BDX600-UK Manuel utilisateur

Sanyo

Sanyo DC-F320 Manuel utilisateur

Philips

Philips FWM583X Manuel utilisateur

Sharp

Sharp CD-C462 Manuel utilisateur

Onkyo

Onkyo CBX 300 - CD / MP3 Clock Radio Manuel utilisateur

Aiwa

Aiwa XR-EM70 Manuel utilisateur

Cyrus

Cyrus Lyric Manuel utilisateur

Philips

Philips MCM159/98 Manuel utilisateur

Philips/Magnavox

Philips/Magnavox Magnavox FW 62C Manuel utilisateur

RCA

RCA RS3965SB Manuel utilisateur

Sharp

Sharp XL-UH240 Manuel utilisateur