8. The pre-loaded message should start at section A1 and scroll continuously across the entire sign
from right to left. If the message doesn’t properly scroll through all sections check the data and
power cable connections between sections (steps 3 and 4 above).
Installing Corners
If your ticker has corners:
1. Place the two segments together and connect the data cable and power cables between the two
segments. (see steps 2-4 in Connecting Sections).
2. Rotate the joining metal to the desired angle and slide in the slot, tighten the screws to fix the two
segments together in the determined degree.
Network Connectivity
1. If you are using a wired connection, plug your Cat5 cable to the RJ45 port (see photo in step 7 on
the previous page). If you ordered a twin ticker, there will be one RJ45 port on the right side and
one on the left side.
2. For a wireless connection, once the sign is turned on with either a Smartphone or PC/Laptop that
can detect wireless networks, follow these steps:
a. Check available wireless networks, locate and connect to the network named 'Tickercom'
the password for this network is 'PASSWORD ' all in upper case. Once Connected to
'Tickercom' your device may state that you have 'Limited Connectivity' this is normal. If it
says "Unable to join the network", please try the WIFI setup on a different device.
b. Once connected to 'Tickercom' open your browser and in the address bar type in
192.168.0.1 and press enter.
support@risedisplay.com 9
