Ricoh MP7083A Manuel utilisateur

NOTICE

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communication. However, there is no

guarantee that interference will not occur in a particular

installlation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following

measures:

● Reorient or relocate the receiving antenna.

● Increase the separation between the equipment and

receiver.

● Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

● Consult the dealer or an experienced radio / TV technician

for help.

Warning as to USE

This CD-R/RW drive together with software is a product for

utilizing CD-R/RW recording media with rewriting, erasing and

readout capabilities, as an external computer memory device.

Except in the case where copying of CD-ROMs or the like is

especially recognized under the copyrights laws as being for

the purpose of individual use by the customer or the like, or in

the case where the customer has obtained permission to make

copies from the rightholder, reproduction of CD-ROMs and

subject to claims for damages and to penalties.

CAUTION

Rating voltage for peripherals.

1. Headphone Jack

Rating Voltage output Audio Signal Max. 2V

FCC WARNING

Changes or modification not expressly approved by the party

responsible for compliance could void the user's authority to

operate the equipment.

CAUTION

Use of controls or adjustments or performance of procedures

other than those specified herein may result in hazardous

radiation exposure.

Lower a volume

Use of controls or adjustments or performance of procedures

other than those specified herein may result in hazardous

radiation exposure.

The volume that exceeds 70dB occurs and the obstacle

sometimes breaks out.

Declaration of Conformity

"The Product complies with the requirements of the EMC

Directive 89/366/EEC and the Low Voltage Directive

73/23/EEC."

Please take notice that the manufacturer of this

equipment does not offer any warranty against data loss

due to inappropriate installation or handling, or direct or

indirect damages.

●

Please take notice that the manufacturer will bear no

responsibility for direct or indirect damages caused by

the use of this product or its malfunction.

●

Please take notice that the manufacturer will bear no

responsibility for damage to data caused by this product.

●

Please backup (copy) all important data as protection

against data loss.

●

PC DOS is a trademark of IBM Inc.● MS-DOS, Windows, Windows ® 95, Windows ® 98, Windows NT® and Windows® 2000 are

trademarks registered in the United States and other countries by the Microsoft Corporation.

●

The company names and product names written in this manual are trademarks or registered

trademarks.

●

This manual uses the following symbols to indicate important information relating to the drive.

Failing to comply with the information in this manual and/or incorrect handling of the drive

may result in serious personal injury or damage to the product.

Indicates restriction or precaution that should be observed.

Provides useful additional information.

This manual contains important notes and product handling information. Be sure to read the

manual before using the product. For easy reference in the future, please keep the manual

at a handy location.

Multimedia Printer series

Thank you for purchasing the Multimedia Printer series drive MP7083A (hereafter referred to as the

drive). The drive enables you to play CD-ROM discs, write once and play CD-R discs, or write, play,

and rewrite CD-RW discs.

The following marks indicate media that can be used with the drive.

Obey the following cautions when handling the drive or discs.

Cautions During Installation

Install the drive in accordance with the specifications. Be careful to avoid locations likely to cause

vibration or shock.

●

Avoid locations where there is high humidity, excessive dust, or poor ventilation.●

Avoid locations in direct sunlight, with severe changes in humidity, or places where there are

extremely high or low temperature variations.

●

Don't use the drive near radio or television receivers. It may interfere with their reception.●

Do not disassemble the drive. Dismantling the drive to attempt repairs or for other reasons is

dangerous because the laser may radiate outside the unit.

●

Cautions During Use

Don't suddenly move the drive from a cold place to a warm place, or suddenly raise the room

temperature. Condensation may occur, causing abnormal operation.

●

Make sure to remove the disc before moving the drive. The disc may be damaged, causing data loss.●

Be careful to prevent foreign objects such as liquids or metal from entering the drive. Should by

chance a foreign object enter the drive, please consult the dealer where the drive was purchased.

●

Don't use benzene or thinner to clean dirt from the drive. Don't allow chemicals such as insecticides

to contact the drive. Use a soft cloth to wipe the drive, or moisten a cloth with neutral detergent

diluted with water and use it to clean particularly dirty areas.

●

Don't cutoff the electric power while the drive is operating.●

When connecting two E-IDE devices to the Primary or Secondary connectors, make sure that the two

devices are not both configured as Master, or both as Slave. If they are both set the same, Windows

may fail to run or recognize the drives.

●

The total length of the E-IDE cable should be less than 18 inches (about 45 cm).●

Make sure the power to the host computer is turned OFF before connecting.●

Never insert a damaged disc into the drive.●

In wintertime, don't use a disc soon after bringing in from outdoors. Use it only after it has reached

room temperature.

●

Cautions Concerning Disc Cleaning

Remove the disc by pressing the eject button.●

Use compressed air to clear dust from the disc. (Spray the compressed air for about 5 seconds).●

Check to see if there is dirt on the surface of the disc. Be careful not to touch the disc with the fingers

when doing this. (See Fig. 1)

●

After cleaning the disc with compressed air, place it on the disc tray and mount it.(See Fig. 2)●

We suggest using dry air cleaner as compressed air for cleaning.●

Other Cautions

When moving the equipment, make sure that the disc has been removed from the drive.●

When connecting connectors, make sure that the power is OFF. If the power is ON, there is a

possibility of short circuit.

●

When not using the drive for a long period, dust may adhere to the disc tray. Before using the drive

again, use dry air cleaner to remove the dust from the tray.

●

fig1

Check1. Recording surface2.

Back

fig2

50 to 100mm1.

Back

Completely sealed door construction provides high reliability.● An improved anti-heat design means that no cooling fan is needed.● Easy-to-use tray model.● Enhanced-IDE (ATAPI) model● Compliant with industry standard Orange Book Part II (CD-R) and Part III (CD-RW).● Can read not only CD-R and CD-RW discs, but also video CDs, audio CDs, photo

CDs*1, and CD-Text

●

Can read data at 32x speed (4.8MB/sec data transfer rate), write data at 8x speed

(CD-R, 1,200KB/sec data transfer rate.) and write data at 8x speed *2(High Speed

CD-RW, 1,200KB/sec data transfer rate).

●

The recorded CD-RW media can be played in a DVD player or a multi-read CD-ROM

Player, maintaining future compatibility.

●

Supports random UDF for easy writing to CD-RW discs.

*1 Bundled software does not support this writing format.

*2 The speed at which to write on the current standard CD-RW discs is 4x

recording (at a data transfer rate of 600KB/sec).

●

Explains the system environment required for using the drive as a CD-R/CD-RW drive.

PC IBM PC/AT compatible

Operating System Windows 98/95(OSR2 or later)

Windows NT Workstation Ver.4.0 (Service Pack 5) or later*1

Windows 2000 (Professional)*1

CPU Pentium 200 MHz or higher

Memory Windows NT (Workstation) / 2000 64MB or more (Windows 95/98 32MB or

more)

Harddisk Hard disk with average access time of 19msec or less, and data transfer speed

of 2,500KB/sec or greater. 1GB or more free space.

Interface Enhanced-IDE interface (as Primary Slave, Secondary Master, or Slave)

Drive bay 5.25-inch half height bay required

Power +5V/+12V power socket required

Recommendation discs*3 CD-R(74min): Ricoh, Mitsubishi Chemical, Taiyo Yuden, Mitsui Chemicals,

TDK and Maxell discs

CD-R(80min): Ricoh, Taiyo Yuden, TDK discs

CD-RW: Ricoh and Mitsubishi Chemical discs*2

High Speed CD-RW: Ricoh discs *2

*1 abCD does not support these Operating System.

*2 The disc written using the CD-R/RW drive may not be readable by CD-ROM drives.

Multi-read compatible (Random UDF compatible) drives are necessary.

*3 Even if it is the recommendation disc, some of discs may have possibility to fail writting with

highest writting speed with the problem on the disc. In this case, please try to write with

lower writting speed, or please try to use another disc.

Multi-read compatible (Random UDF compatible) drives are:

Drives that can read low reflectivity discs.● Drives that support Packet Write.●

Front Panel

Rear panel

Front Panel

Disc tray

This is the tray for the disc. Place the disc on the ejected disc tray, then lightly push the tray (or push

the eject button) and the disc will be mounted.

Caution

Don't use force to pull out or push in the disc tray. This might cause damage to the loading

section of the drive.

Headphone jack

This jack is for connecting headphones or mini-speakers.

Volume control

This is used to adjust the output volume of the headphone jack. It can't be used to adjust the output

volume for the audio output connectors on the rear panel.

Caution

Turn the volume down before turning on the power. Sudden loud noises can damage your

hearing.

Busy indicator

This indicator lights green when a disc is mounted into the drive. When the disc is being accessed, it

flashes or lights green. If a disc is not mounted, the indicator does not light even when the power is

turned on. When a illegal disc is loaded or some hardware trouble occurs, the indicator blinks.

Eject button

This is the button used to eject or insert in the disc tray.

Table des matières

Autres manuels Ricoh Lecteur CD/CDR

Manuels Lecteur CD/CDR populaires d'autres marques

Philips

Philips CDD3610 Manuel utilisateur

QPS

QPS Que!Fire Manuel utilisateur

LG GCC-4241N Manuel utilisateur

Plextor

Plextor 12X-3 Mode d’emploi

Samsung

Samsung SN-324B Manuel utilisateur

Teac

Teac CD-211E Manuel utilisateur

SmartDisk

SmartDisk Firewire CD-R/W Manuel utilisateur

Axis

Axis CD-ROM SERVER Manuel utilisateur

LG CRD-8322B Manuel utilisateur

Memorex

Memorex 32023234 - 52x32x52x External USB2.0 CD... Instructions d'installation

Yamaha

Yamaha CD Recordable/Rewritable Drive CRW3200 Manuel utilisateur

Sony

Sony CRX230AE Manuel utilisateur

Sony

Sony CRX - 160E Manuel utilisateur

Panasonic

Panasonic KX-LD742 Manuel utilisateur

Pioneer

Pioneer BDR-S13U-X Manuel utilisateur

Panasonic

Panasonic LK-MC606BP Manuel utilisateur

Panasonic

Panasonic CF-VCW Series Manuel utilisateur

LG CRD-8320B Manuel utilisateur