External battery: Plug alligator clip wire into External Battery Jack (#6), and use red alligator clip to
connect the positive (red) terminal of the SLA battery, and black alligator clip to connect the negative (black)
terminal.
The firing module will work with either internal batteries or external powers. It will use the power with the
higher voltage.
2) Safety Tests
Do following steps before attaching e-matches / igniters.
Step 1: Turn on the Main Switch (#7) and set Rocker Switch (#3) to Learn. If the battery voltage of
Digital Readout Meter (#2) is blank While there is LED(s) which is on, do not use this module,
because the battery voltage is too low to have the module work normally. Turn off the Main Switch (#7)
and remove internal or external batteries, replace with fully charged batteries or fresh batteries.
Step 2: If the firing module is not synchronized to the transmitters, perform “Learn Codes” on (see
“Learn Codes / Clear Codes” below) before performing the next step.
Step 3: Set Rocker Switch (#3) to Test. All Cue Fire LEDs (#9) and Cue Test LEDs (#8) should be
turned on. Any unlit cue is defective.
Step 4: Set Rocker Switch (#3) to Arm. All Cue Fire LEDs (#9) and Cue Test LEDs (#8) should be off.
If any Cue Fire LED (#9) stays lit, then that cue is defective.
Important: Do not attach any e-match/igniter to defective cues under any circumstances, otherwise, that
e-match/igniter will fire prematurely. Premature ignition of fireworks can result in death or bodily harm.
Step 5: Set Rocker Switch (#3) to Arm. Extend the Antenna (#1). Press and release any Button 1 to 12
on transmitter A, the matching Cue Fire LED (#9) should flash on and off. Repeat this for different
buttons.
Step 6: Set Rocker Switch (#3) to Arm. Press and release any Button (except ALL) on transmitter B,
each Cue Fire LED (#9) should flash on and off in order using the selected interval. Push ALL and all Cue
Fire LEDs (#9) should flash on and off.
Step 7: Turn off Main Switch (#7). Retract Antenna (#1).
If the above safety tests are successful, you may attach lead wires of the igniters to the Negative
Terminal (#10) and Positive Terminal (#11).
D. Some Available Functions:
◆◆
Learn Codes / Clear Codes
You must synchronize (learn) the A & B transmitters to one or more firing modules before they can
communicate. Extend the Antenna (#1). Turn on the Main Switch (#7) and set Rocker Switch (#3) to
Learn. Press Learn Button (#5) and hold until Learn LED (#4) is lit. Press any button on Transmitter
Awithin 5 seconds and, the Learn LED (#4) will blink twice, the learning is successful. Repeat the process
with Transmitter B.
Note: The firing module can store the learn codes from one A transmitter and one B transmitter only. If you
synchronize another A or B transmitter it will replace the learning of the previous A or B transmitter. You can
also synchronize the same transmitter to several firing modules, this allows you to fire the same cue on
each synchronized receiver at the same time.
To clear learning codes, press the Learn Button (#5) and hold for more than 10 seconds, the Learn LED
(#4) will light and blink three times, the codes are now cleared.
◆◆
Test
You can test the continuity of any e-match/igniter that is connected to the cue terminals. Once all the
e-matches/igniters are connected, turn on the Main Switch (#7), set Rocker Switch (#3) to Test, if
Cue Test LED (#8) is lit and Cue Fire LED (#9) is unlit, that cue has continuity. Otherwise there is a bad
connection or a bad e-match/igniter.
