Reznor UBX Manuel

Revision: UBX-UBZ-UDX-UDZ-HX (02-22) 1037154-0

HEAT EXCHANGER GASKET KIT INSTALLATION

FOR UNIT HEATERS

Supersedes: — (Original Version)

MODELS UBX, UBZ, UDX, AND UDZ

Table 1. Heat Exchanger Gasket Kit Components

Item

No.*Component Size

Unit Size

030, 045 060, 075 100, 125 150, 175, 200 225, 250 300, 350, 400

Kit PN

1036360 1036361 1036362 201670 201671 201672

Component PN (Quantity)

1Top/bottom header

panel gasket

5/8 × 21-3/8 1033925 (2) 1033925 (2) 1033925 (2) —

1 × 35-23/64 — 194533 (2) 194533 (2) 194533 (2)

2Front/rear heater

panel gasket

5/8 × 12-5/8 1033922 (2) —

—5/8 × 15-5/8 — 1033923 (2) —

5/8 × 23-5/8 — 1033924 (2)

1 × 20-3/16

—

195986 (2) —

1 × 26-3/16 — 195987 (2) —

1 × 34-3/16 — 195988 (2)

3Tube support

gasket

1 × 89-7/32 201424 (1) —

1 × 95-7/32 — 201425 (1) —

1 × 103-7/32 — 201426 (1)

*See Figure 1.

INSTALLATION

⚠ DANGER ⚠

• Improper installation could result in death, serious injury, and /or property damage.The qualiﬁed

agency performing this work assumes responsibility for this installation.

• Proper installation and sealing of the heat exchanger to the heater is necessary for reliable and

safe operation. Failure to properly install could result in property damage, personal injury, and/

or death.

• The replacement heat exchanger should be installed by a qualiﬁed service agency in compliance

with all codes and requirements of authorities having jurisdiction.

NOTE: Unit sizes 030–125 require the installation of four (4) gasket strips. Unit sizes 150–400 re-

quire the installation of ﬁve (5) gasket strips.

Install the heat exchanger gasket kit as follows (item numbers refer to Figure 1):

•To prevent damage during shipping or storage, gasket kits for replacement heat exchangers are shipped in a

parts bag.

•Gasket kits should be attached to the replacement heat exchanger at the time of installation.

•All gaskets are self-adhesive and are cut to size.

•Refer to the installation manual provided with the heater for important safety information.

•Ensure that all components listed in Table 1 are available before beginning installation.

Speciﬁcations and illustrations subject to change without notice or incurring obligations.

Latest version of this manual is available at www.reznorhvac.com.

UBX-UBZ-UDX-UDZ-HX (02-22) 1037154-0

INSTALLATION—CONTINUED

Figure 1. Heat Exchanger Gasket Locations (Refer to Table 1)

1. Install header panel gaskets:

NOTE: The header panel gaskets are sealing gaskets and must cover the full length of the surface.

a. Position top/bottom (1) and front/rear (2) gaskets on outer edges of header panel and align holes—ignore

large holes in bottom gasket.

b. To apply gasket(s), start at end and gradually peel backing from gasket as it is adhered. Repeat with each strip.

2. Install tube support gasket (unit sizes 150–400):

NOTE: The tube support gasket is required to prevent vibration but is not a sealing gasket.

a. Position tube supprt gasket (3) across top, rear, and bottom of tube support.

b. To apply gasket, start at end and gradually peel backing from gasket as it is adhered.

3. Complete replacement heat exchanger installation (refer to installation manual provided with heater):

a. Inspect and clean cabinet, burner, and vent system.

a. Replace any components that are not structurally sound.

4. When installation of replacement heat exchanger is complete, start up heater (refer to installation manual

provided with heater):

a. Follow instructions on lighting instruction plate to restart heater.

b. CHECK ALL SAFETY FEATURES FOR PROPER OPERATION.

UNIT SIZES 030–125 UNIT SIZES 150–400

Autres manuels pour UBX

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Reznor Chauffage

Reznor

Reznor UDX Instructions d'installation et d'utilisation

Reznor

Reznor ML 1511 Mode d’emploi

Reznor

Reznor ULSA 035(EC) Manuel utilisateur

Reznor

Reznor RPV 2000 Mode d’emploi

Reznor

Reznor GUARDIAN GB 1500 Manuel utilisateur

Reznor

Reznor UDSBD-4E Mode d’emploi

Reznor

Reznor AB-2 Series Supplément

Reznor

Reznor V3 Series Mode d’emploi

Reznor

Reznor BE Manuel utilisateur

Reznor

Reznor ACR1000SE6-1PH Manuel utilisateur

Reznor

Reznor EURO-X 1000 D Manuel utilisateur

Reznor

Reznor CAUA Series Manuel utilisateur

Reznor

Reznor UBZ Manuel utilisateur

Reznor

Reznor BE Series Manuel utilisateur

Reznor

Reznor PHOTON-P Manuel utilisateur

Reznor

Reznor RHC21 4000 Mode d’emploi

Reznor

Reznor LDAP Manuel utilisateur

Reznor

Reznor FT30-CV Guide d'installation et d'utilisation

Reznor

Reznor OH Instructions d'installation et d'utilisation

Reznor

Reznor UDBP Mode d’emploi

Reznor

Reznor RHC 8000(m) RJL Mode d’emploi

Reznor

Reznor UEAS Manuel utilisateur

Reznor

Reznor UESA-3 Manuel du propriétaire

Reznor

Reznor UDA Series Manuel du propriétaire

Manuels Chauffage populaires d'autres marques

oventrop

oventrop Regucor Series Manuel utilisateur

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuel utilisateur

ELMEKO

ELMEKO ML 150 Manuel utilisateur

BN Thermic

BN Thermic 830T Manuel utilisateur

KING

KING K Series Mode d’emploi

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guide de démarrage rapide

Well Straler

Well Straler RC-16B Manuel utilisateur

EUROM

EUROM 333299 Manuel utilisateur

Heylo

Heylo K 170 Manuel utilisateur

Eterna

Eterna TR70W Manuel utilisateur

Clarke

Clarke GRH15 Mode d’emploi

IRSAP

IRSAP The Radiator Company Ovali Manuel utilisateur

Empire Heating Systems

Empire Heating Systems WCC65 Manuel utilisateur

Wetekom

Wetekom 92 86 43 Manuel utilisateur

Desa

Desa SPC170-F Manuel utilisateur

Watlow

Watlow Watrod Electric Tubular Heaters Manuel utilisateur

Haverland

Haverland ECO-DRY GPS Series Manuel de la liste des pièces

Stelpro

Stelpro ASILVC2060 Series Manuel utilisateur