Remo+ Remobell S Manuel utilisateur
Quick Start Guide
www.remoplus.co
WHAT’S IN THE BOX
REMOBELL® S WALL
MOUNT
15° ANGLE
MOUNT
SAFETY FUSE
DRILL BIT
1
* For brick or stucco surfaces, you’ll need a drill.
5° WEDGE
MOUNT
POWER TERMINAL SCREWS
DOORBELL SCREWS
SECURITY SCREWS
MOUNT
FOAM
POWER KIT
(WITH WIRE HARNESS)
EXTENSION
WIRES
SCREWDRIVER MOUNTING
SCREWS AND
ANCHORS
WIRE NUTS BUBBLE
LEVEL
MEET REMOBELL® S
2
FACEPLATE
LED Indicator
Bell button
Security screw holes
1
2
3
Camera lens
IR LED
Mic
Reset button
Mounting holes
4
5
6
7
8
BODY* BACK
* Remove the protective lm before use
Power terminal
Speaker
9
10
3
Check your doorbell voltage and chime.
RemoBell® S only works with a voltage of 16-24VAC.
Go to your breaker box and turn o the power to your doorbell.
WARNING: If you are not sure how to turn o the power to your doorbell from your breaker
box, please consult a licensed electrician.
• If you have a mechanical chime, start POWER KIT INSTALLATION.
• If you have an electronic chime, please refer to its manual for
instructions.
• If you do not have chime, skip POWER KIT INSTALLATION and follow
OPTION B on page 8.
BEFORE YOU BEGIN
4
POWER KIT INSTALLATION
1. Insert one end of the Wire
Harness into the Power Kit.
2. Remove the cover of your
mechanical chime.
3. Take a picture of the wiring for
reference during installation.
4. Loosen the screws and remove the
wires. Then straighten the exposed
end of the wires.
5
5. Connect the Wire Harness
to the "TRANS" and
"FRONT" chime terminals.
6. Insert an exposed end
of the Wire Harness
and one chime wire
into the Wire Nut, and
twist it tightly. Repeat
with remaining wires.
7. Place your Power Kit so that it doesn't interfere with moving parts or
mue the chime. You can use the adhesive backing to hold it in place.
Put the chime cover back on.
6
DOORBELL MOUNTING
1. Remove your existing doorbell and disconnect the wires.
2. Based on your doorbell location,
select the appropriate Mount
type to optimize the camera's
viewing angle.
3. Insert the Bubble Level into the Mount to
straighten the Mount. When the bubble
is in the middle, mark the drill points on
the wall. You can remove the Bubble
Level after the drill points are marked.
(Optional) For hard surfaces like brick
or stucco, paste the Mount Foam to
the back of your Mount.
7
4. Drill holes according to your
drill points and insert Anchors.
6. If a Power Kit is installed, follow Option A.
If you do not have chime, follow Option B.
5. Secure the Mount onto the wall
using Screwdriver and
Mounting Screws.
Option A: Connect the RemoBell® S
with your existing doorbell wires.
Table des matières
Autres manuels Remo+ Système d'interphone
